P0740 on a 2022 Toyota Camry
Torque Converter Clutch Circuit Fault
P0740 on a 2022 Toyota Camry indicates torque converter clutch circuit fault. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is failed tcc solenoid (typically $300–$900). Confirm the root cause before replacing parts.
What does P0740 mean on a 2022 Toyota Camry?
P0740 is the general torque converter clutch (TCC) circuit code. Depending on the manufacturer it is set for an electrical fault in the TCC solenoid circuit — an open or a short — or for the clutch simply never engaging when the transmission controller commands it. The torque converter clutch is what mechanically locks the engine to the transmission at cruise, removing the slip that a fluid coupling always has. When it does not work, the engine turns faster than it should for a given road speed, fuel economy drops, and the transmission runs hotter than it was designed to.
The symptoms, causes, and diagnostic steps below describe P0740 itself, so they read the same on nearby Toyota Camry model years. Powertrain and trim details vary year to year — confirm the specifics against your own vehicle before buying parts.
Is it safe to drive a 2022 Toyota Camry with P0740?
In most cases a 2022 Toyota Camry stays drivable for short trips with P0740 active, but diagnose and repair it promptly. This is a high-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0740 on a 2022 Toyota Camry?
- Check Engine Light is illuminated
- Engine RPM at highway cruise is higher than normal for the same speed
- Noticeable fuel economy drop, worst on the highway
- No sensation of the transmission "shifting" into lockup at cruise
- Transmission fluid running hot, especially when towing
- Often paired with P0700 from the transmission controller
What causes P0740 on a 2022 Toyota Camry?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Failed TCC solenoid | Most common | $300–$900 |
| Damaged wiring or fluid-contaminated external transmission connector | Common | $100–$500 |
| Low transmission fluid level or contaminated fluid | Common | $100–$400 |
| Stuck TCC control valve in the valve body | Common | $400–$1,500 |
| Worn or burned torque converter clutch friction material Requires torque converter replacement — a major job. | Occasional | $1,800–$4,500 |
| Failed TCM or PCM driver for the TCC circuit | Rare | $500–$1,500 |
| Internal transmission damage allowing fluid bypass | Rare | $2,500–$6,500 |
Cost ranges are editorial estimates for parts and labor at an independent U.S. shop — not quotes. What you actually pay moves with your region, the shop's hourly rate, which engine you have, and how much diagnostic time the job takes. Dealer service departments typically sit above these ranges.
How to diagnose this on a 2022 Toyota Camry
-
Check transmission fluid level and condition
This comes first every time. Many modern transmissions have no dipstick and require a specific procedure — fluid at a defined temperature, engine running, vehicle level — to check the level at all. Follow the procedure for this vehicle. Fluid that smells burnt or carries clutch material tells you the problem is internal and no solenoid will fix it.
Tools: Vehicle-specific service procedure, Replacement fluid (if needed)
-
Pull all transmission codes, not just the engine codes
P0740 on its own is one repair scope. P0740 alongside gear-ratio codes or a pressure code means broader problems that a solenoid replacement will not resolve. Read the TCM directly rather than relying on a generic scan of engine codes only.
Tools: Scan tool with TCM access
-
Watch TCC command against actual lockup on the road
At a steady highway cruise, graph commanded TCC state alongside engine RPM and vehicle speed. On a healthy system the RPM drops noticeably at the moment lockup engages. Command with no RPM drop confirms the clutch is not engaging mechanically — which is the condition, not yet the cause.
Tools: Scan tool with TCC and live RPM PIDs
-
Test the TCC solenoid circuit electrically
Locate the TCC solenoid pin at the external transmission connector using the wiring diagram, and measure resistance. Compare against the specification for this transmission. Infinite resistance means an open coil or an open circuit; a near-zero reading means a shorted solenoid.
Tools: Multimeter, Wiring diagram
-
Inspect the external transmission connector for fluid
A failed case seal lets transmission fluid wick up inside the wiring harness and into the connector. The result mimics a failed solenoid on a multimeter while the solenoid is perfectly fine. If you find fluid in the connector, the repair is the seal and often a section of harness.
Tools: Connector unlock tool, Flashlight
Known Technical Service Bulletins for the 2020-2024 Toyota Camry
Manufacturers publish Technical Service Bulletins (TSBs) when a known issue affects a specific vehicle. These bulletins come from the NHTSA database for your Toyota Camry.
- ENGINE Feb 27, 2026
OBSOLETE NOTICE February 27, 2026: This bulletin is no longer applicable and is now obsolete.
NHTSA #11029896 - ELECTRICAL SYSTEM Jan 30, 2026
OBSOLETE NOTICE January 30, 2026: This bulletin is now obsolete. Please see T-SB-0001-26.
NHTSA #11028726 - ELECTRICAL SYSTEM Jan 28, 2026
Some 2018 – 2024 model year Toyota vehicles equipped with a Premium Audio with Dynamic Navigation System require a Special Service Tool (SST) USB flash drive to update the map, points of interest, and system software.
NHTSA #11028722 - UNKNOWN OR OTHER Jan 7, 2026
Some 2005 – 2026 Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty odor is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this Service Bulletin is to provide general guidelines and procedures for odor remediation. This Service Bulletin provides a guide on how to prepare and treat the interior of the vehicle for odor remediation. Refer to the applicable model and model year Repair Manual and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines.
NHTSA #11028712 - ENGINE Aug 7, 2025
The specific condition covered by this program is for a small engine coolant leak that can occur from the flow shut-off valve that can allow coolant to drip on other parts of the vehicle. This can cause "Engine Maintenance Required" to be displayed on the instrument cluster or cause the A/C not to function normally. Although the flow shut-off valve is covered by Toyota’s New Vehicle Limited Warranty for 36 months or 36,000 miles (whichever comes first), we at Toyota care about the customers’ ownership experience. Toyota is providing coverage for repairs related to Flow Shut-off Valve Coolant Leak.
NHTSA #11022949 - ELECTRICAL SYSTEM Jun 25, 2025
Some 2021 – 2022 model year Avalon, 2018 – 2024 Camry, 2019 – 2025 model year Corolla, 2022 – 2025 model year Corolla Cross, and 2019 – 2025 model year RAV4 vehicles with A25A-FKS and M20A-FKS engines may have a MIL ON condition with one or more of the following Diagnostic Trouble Codes (DTCs) upon cold soak start up with engine coolant temperatures between 14°F – 41°F: •P030027 – Random/Multiple Cylinder Misfire Detected (Emission) Signal Rate of Change Above Threshold •P030000 – Random/Multiple Cylinder Misfire Detected •P030100 – Cylinder 1 Misfire Detected •P030200 – Cylinder 2 Misfire Detected •P030300 – Cylinder 3 Misfire Detected •P030400 – Cylinder 4 Misfire Detected
NHTSA #11020670
+14 more TSBs available in MECH AI's TSB explorer for this vehicle.
NHTSA complaints & recalls for the 2022 Toyota Camry
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2022 Toyota Camry. Use these to gauge how common a problem is on your specific vehicle before you start chasing Toyota Camry diagnostics.
- VEHICLE SPEED CONTROL 6
- AIR BAGS 10
- UNKNOWN OR OTHER 7
- SERVICE BRAKES 7
- ELECTRICAL SYSTEM 7
1 active recall
- AIR BAGS:SENSOR:OCCUPANT CLASSIFICATION Dec 2023
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2020-2021 Avalon, Avalon Hybrid, Corolla, Highlander, Highlander Hybrid, RAV4, RAV4 Hybrid, Lexus ES350, Lexus RX350, Lexus RX450H, 2021 Sienna Hybrid, Lexus ES250, 2020-2022 Camry, Camry Hybrid, and ES300H ve…
NHTSA campaign 23V865000
How do I fix P0740 on a 2022 Toyota Camry?
- Service transmission fluid and filter to the correct specification
- Replace the TCC solenoid (often supplied as part of a solenoid pack)
- Repair the external transmission connector or harness
- Replace or service the valve body for a stuck TCC control valve
- Replace the torque converter for worn clutch friction material
Engines in the 2022 Toyota Camry
The 2022 Toyota Camry was offered with the 2.5L 4-cylinder and 3.5L 6-cylinder engines, including a hybrid version. Which one you have changes where P0740 is most likely to originate, so confirm your engine before ordering parts.
Engine data: EPA fueleconomy.gov.
P0740, P0741, P0743 — three codes, one system
The torque converter clutch codes describe different aspects of the same failure, and manufacturers are not perfectly consistent about which one they set:
| Code | What it describes |
|---|---|
| P0740 | General TCC circuit fault — electrical or “never engages” |
| P0741 | TCC performance, or stuck off — commanded but slipping |
| P0742 | TCC stuck on — will not release, stalls at stops |
| P0743 | TCC circuit electrical fault specifically |
| P0744 | TCC circuit intermittent |
Because P0740 is the broad one, the same physical fault might show up as P0740 on one vehicle and P0743 on another. Do not read too much into which number appeared; read the live data instead.
What no lockup feels like from the driver’s seat
The clearest tell is highway RPM. A vehicle that used to cruise at 2,000 RPM at 70 mph and now sits noticeably higher at the same speed is running without lockup. The engine is spinning the converter’s fluid rather than being bolted to the transmission through the clutch.
The second tell is that the familiar sensation of a final “shift” at around 45–55 mph is gone. That was never a gear change — it is the lockup clutch engaging. Its absence is P0740’s signature symptom.
The third is fuel economy. Converter slip at highway speed costs real miles per gallon, which is why this code often shows up as “my mileage suddenly got worse” before anyone notices the light.
Fluid first, always
Low or degraded fluid causes hydraulic problems that look exactly like electrical ones, and it is the cheapest thing on the list to correct. Check it before touching a solenoid.
One old piece of advice deserves updating: for decades the rule was never to change the fluid in a transmission that is already misbehaving, on the theory that fresh fluid washes out accumulated material and finishes the job. With modern fluids, a drain-and-fill using the correct OEM specification is generally safe and sometimes resolves the code outright. A high-pressure machine flush on a transmission that is already slipping is still a risk worth avoiding.
When to hand this to a transmission shop
Fluid level, connector inspection, and a resistance check at the external connector are all reasonable driveway jobs. Once the diagnosis points inside — a stuck valve in the valve body, or clutch material on the pan magnet — you are into a job that needs a lift, a fluid handling setup, and transmission-specific experience. That is a good moment to stop and get a quote rather than to keep going.
P0740 on a 2022 Toyota Camry: frequently asked questions
What does diagnostic trouble code P0740 mean on a 2022 Toyota Camry?
P0740 is the general torque converter clutch (TCC) circuit code. Depending on the manufacturer it is set for an electrical fault in the TCC solenoid circuit — an open or a short — or for the clutch simply never engaging when the transmission controller commands it. The torque converter clutch is what mechanically locks the engine to the transmission at cruise, removing the slip that a fluid coupling always has. When it does not work, the engine turns faster than it should for a given road speed, fuel economy drops, and the transmission runs hotter than it was designed to.
What are the symptoms of P0740 on a 2022 Toyota Camry?
Check Engine Light is illuminated. Engine RPM at highway cruise is higher than normal for the same speed. Noticeable fuel economy drop, worst on the highway. No sensation of the transmission "shifting" into lockup at cruise. Transmission fluid running hot, especially when towing. Often paired with P0700 from the transmission controller
What causes P0740 on a 2022 Toyota Camry?
Failed TCC solenoid (most-common). Damaged wiring or fluid-contaminated external transmission connector (common). Low transmission fluid level or contaminated fluid (common). Stuck TCC control valve in the valve body (common). Worn or burned torque converter clutch friction material (occasional). Failed TCM or PCM driver for the TCC circuit (rare). Internal transmission damage allowing fluid bypass (rare)
Is it safe to drive a 2022 Toyota Camry with P0740?
In most cases a 2022 Toyota Camry stays drivable for short trips with P0740 active, but it should be diagnosed and repaired promptly — this is a high-severity code. Ignoring it can lead to further damage or a failed emissions test.