P0743 on a 2022 Toyota Camry
Torque Converter Clutch Circuit Electrical Fault
P0743 on a 2022 Toyota Camry indicates torque converter clutch circuit electrical fault. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is failed tcc solenoid (open or shorted coil) (typically $300–$900). Confirm the root cause before replacing parts.
What does P0743 mean on a 2022 Toyota Camry?
P0743 narrows the torque converter clutch fault to the electrical circuit specifically. The transmission controller drives the TCC solenoid and monitors that circuit's voltage or current; an open coil, a short to ground, a short to power, or resistance well outside specification will set P0743. It is a wiring-and-solenoid code rather than a "the clutch is worn out" code — though the only way to be sure of that is to test the circuit rather than assume it.
The symptoms, causes, and diagnostic steps below describe P0743 itself, so they read the same on nearby Toyota Camry model years. Powertrain and trim details vary year to year — confirm the specifics against your own vehicle before buying parts.
Is it safe to drive a 2022 Toyota Camry with P0743?
In most cases a 2022 Toyota Camry stays drivable for short trips with P0743 active, but diagnose and repair it promptly. This is a high-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0743 on a 2022 Toyota Camry?
- Check Engine Light is illuminated
- Engine RPM at highway cruise higher than normal for the same speed
- Noticeable fuel economy drop on the highway
- No sensation of lockup engaging at cruising speed
- Transmission fluid running hot, particularly when towing
- Often paired with P0700 from the transmission controller
What causes P0743 on a 2022 Toyota Camry?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Failed TCC solenoid (open or shorted coil) | Most common | $300–$900 |
| Transmission fluid wicked up the harness into the external connector Reads identically to a failed solenoid on a multimeter — inspect the connector before ordering parts. | Most common | $100–$500 |
| Chafed, broken, or corroded TCC solenoid wiring | Common | $80–$350 |
| Low or contaminated transmission fluid | Occasional | $100–$400 |
| Failed TCM or PCM driver for the TCC solenoid circuit | Rare | $500–$1,500 |
Cost ranges are editorial estimates for parts and labor at an independent U.S. shop — not quotes. What you actually pay moves with your region, the shop's hourly rate, which engine you have, and how much diagnostic time the job takes. Dealer service departments typically sit above these ranges.
How to diagnose this on a 2022 Toyota Camry
-
Check transmission fluid level and condition first
Even on an electrical code, fluid comes first — it is cheap to check and it changes how you interpret everything else. Follow the vehicle's specific procedure, which on many modern transmissions means checking at a defined fluid temperature with the engine running. Burnt-smelling fluid or clutch material in it means the problem is bigger than a solenoid circuit.
Tools: Vehicle-specific service procedure, Replacement fluid (if needed)
-
Inspect the external transmission connector for fluid intrusion
This is the check that most often changes the outcome. A failing case seal lets fluid travel up inside the harness and pool in the connector, producing resistance readings that look exactly like a dead solenoid. Unplug the connector and look for fluid inside the body or wicking along the wires. If it is there, the seal and the contaminated harness section are the repair.
Tools: Connector unlock tool, Flashlight, Clean rags
-
Measure TCC solenoid resistance at the connector
Identify the TCC solenoid pins in the wiring diagram and measure resistance across them. Compare against the figure specified for this transmission rather than a generic range. Infinite resistance indicates an open coil or an open circuit; near zero indicates a shorted coil.
Tools: Multimeter, Wiring diagram
-
Confirm the controller is actually commanding the circuit
Back-probe the TCC control wire and drive the vehicle to a steady cruise where lockup should occur. The controller should switch the circuit. If it never commands, the problem is upstream — an input the controller needs, an enable condition not being met, or the driver inside the module — not the solenoid.
Tools: Multimeter or scope, Back-probe pins, Scan tool with TCC PIDs
-
Check the circuit wiring end to end
With the solenoid disconnected at the transmission and the controller connector accessible, check the control wire for continuity, for shorts to ground, and for shorts to power. A wire that reads voltage while disconnected at both ends is touching something it should not, and that chafe point is the repair.
Tools: Multimeter, Wiring diagram
Known Technical Service Bulletins for the 2020-2024 Toyota Camry
Manufacturers publish Technical Service Bulletins (TSBs) when a known issue affects a specific vehicle. These bulletins come from the NHTSA database for your Toyota Camry.
- ENGINE Feb 27, 2026
OBSOLETE NOTICE February 27, 2026: This bulletin is no longer applicable and is now obsolete.
NHTSA #11029896 - ELECTRICAL SYSTEM Jan 30, 2026
OBSOLETE NOTICE January 30, 2026: This bulletin is now obsolete. Please see T-SB-0001-26.
NHTSA #11028726 - ELECTRICAL SYSTEM Jan 28, 2026
Some 2018 – 2024 model year Toyota vehicles equipped with a Premium Audio with Dynamic Navigation System require a Special Service Tool (SST) USB flash drive to update the map, points of interest, and system software.
NHTSA #11028722 - UNKNOWN OR OTHER Jan 7, 2026
Some 2005 – 2026 Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty odor is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this Service Bulletin is to provide general guidelines and procedures for odor remediation. This Service Bulletin provides a guide on how to prepare and treat the interior of the vehicle for odor remediation. Refer to the applicable model and model year Repair Manual and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines.
NHTSA #11028712 - ENGINE Aug 7, 2025
The specific condition covered by this program is for a small engine coolant leak that can occur from the flow shut-off valve that can allow coolant to drip on other parts of the vehicle. This can cause "Engine Maintenance Required" to be displayed on the instrument cluster or cause the A/C not to function normally. Although the flow shut-off valve is covered by Toyota’s New Vehicle Limited Warranty for 36 months or 36,000 miles (whichever comes first), we at Toyota care about the customers’ ownership experience. Toyota is providing coverage for repairs related to Flow Shut-off Valve Coolant Leak.
NHTSA #11022949 - ELECTRICAL SYSTEM Jun 25, 2025
Some 2021 – 2022 model year Avalon, 2018 – 2024 Camry, 2019 – 2025 model year Corolla, 2022 – 2025 model year Corolla Cross, and 2019 – 2025 model year RAV4 vehicles with A25A-FKS and M20A-FKS engines may have a MIL ON condition with one or more of the following Diagnostic Trouble Codes (DTCs) upon cold soak start up with engine coolant temperatures between 14°F – 41°F: •P030027 – Random/Multiple Cylinder Misfire Detected (Emission) Signal Rate of Change Above Threshold •P030000 – Random/Multiple Cylinder Misfire Detected •P030100 – Cylinder 1 Misfire Detected •P030200 – Cylinder 2 Misfire Detected •P030300 – Cylinder 3 Misfire Detected •P030400 – Cylinder 4 Misfire Detected
NHTSA #11020670
+14 more TSBs available in MECH AI's TSB explorer for this vehicle.
NHTSA complaints & recalls for the 2022 Toyota Camry
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2022 Toyota Camry. Use these to gauge how common a problem is on your specific vehicle before you start chasing Toyota Camry diagnostics.
- VEHICLE SPEED CONTROL 6
- AIR BAGS 10
- UNKNOWN OR OTHER 7
- SERVICE BRAKES 7
- ELECTRICAL SYSTEM 7
1 active recall
- AIR BAGS:SENSOR:OCCUPANT CLASSIFICATION Dec 2023
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2020-2021 Avalon, Avalon Hybrid, Corolla, Highlander, Highlander Hybrid, RAV4, RAV4 Hybrid, Lexus ES350, Lexus RX350, Lexus RX450H, 2021 Sienna Hybrid, Lexus ES250, 2020-2022 Camry, Camry Hybrid, and ES300H ve…
NHTSA campaign 23V865000
How do I fix P0743 on a 2022 Toyota Camry?
- Replace the TCC solenoid (often supplied as part of a solenoid pack)
- Repair the fluid-contaminated external connector and harness section
- Repair the failed transmission case seal that allowed fluid intrusion
- Repair chafed or shorted TCC control wiring
- Service transmission fluid and filter to the correct specification
Engines in the 2022 Toyota Camry
The 2022 Toyota Camry was offered with the 2.5L 4-cylinder and 3.5L 6-cylinder engines, including a hybrid version. Which one you have changes where P0743 is most likely to originate, so confirm your engine before ordering parts.
Engine data: EPA fueleconomy.gov.
What “electrical” narrows down for you
P0743 is more useful than P0740 because it tells you where to start. The controller is not reporting that lockup failed to happen — it is reporting that the circuit itself measured wrong. That means the first tools out of the box are a multimeter and a wiring diagram, not a scan tool on a test drive.
It also means the expensive outcomes are less likely. A worn torque converter clutch causes a performance code, not an electrical one. It is still possible to have both problems at once, but P0743 alone points at a solenoid, a wire, or a connector.
The connector is the check people skip
Transmission fluid climbing up inside a wiring harness is more common than most people expect, and it produces a diagnosis trap: the multimeter shows an out-of-spec solenoid circuit, the solenoid gets replaced, and the code returns within days because the actual fault was fluid bridging the connector pins.
Unplug the external connector and look inside before you order anything. If it is wet, the repair is the case seal and the contaminated harness — and the solenoid you were about to buy is probably fine.
Solenoid packs versus single solenoids
Most modern transmissions group their solenoids into a single pack that bolts to the valve body. Replacing the whole pack is frequently the same labour as replacing one solenoid inside it, because the labour is almost entirely getting to the pack. On a high-mileage transmission where the solenoids have aged together, the pack is usually the better value even though the part costs more.
How urgent is this?
The vehicle drives. What you lose is lockup, which means higher cruise RPM, worse fuel economy, and — the part that actually matters — more heat in the transmission fluid. Heat is what kills automatic transmissions. A few weeks of normal commuting is not going to destroy anything. Towing a trailer across a mountain pass with no lockup is a genuinely bad idea. If you tow, treat this as a fix-before-the-trip item.
P0743 on a 2022 Toyota Camry: frequently asked questions
What does diagnostic trouble code P0743 mean on a 2022 Toyota Camry?
P0743 narrows the torque converter clutch fault to the electrical circuit specifically. The transmission controller drives the TCC solenoid and monitors that circuit's voltage or current; an open coil, a short to ground, a short to power, or resistance well outside specification will set P0743. It is a wiring-and-solenoid code rather than a "the clutch is worn out" code — though the only way to be sure of that is to test the circuit rather than assume it.
What are the symptoms of P0743 on a 2022 Toyota Camry?
Check Engine Light is illuminated. Engine RPM at highway cruise higher than normal for the same speed. Noticeable fuel economy drop on the highway. No sensation of lockup engaging at cruising speed. Transmission fluid running hot, particularly when towing. Often paired with P0700 from the transmission controller
What causes P0743 on a 2022 Toyota Camry?
Failed TCC solenoid (open or shorted coil) (most-common). Transmission fluid wicked up the harness into the external connector (most-common). Chafed, broken, or corroded TCC solenoid wiring (common). Low or contaminated transmission fluid (occasional). Failed TCM or PCM driver for the TCC solenoid circuit (rare)
Is it safe to drive a 2022 Toyota Camry with P0743?
In most cases a 2022 Toyota Camry stays drivable for short trips with P0743 active, but it should be diagnosed and repaired promptly — this is a high-severity code. Ignoring it can lead to further damage or a failed emissions test.