P0301 on a 2022 Honda HR-V

Cylinder 1 Misfire

P0301 on a 2022 Honda HR-V indicates cylinder 1 misfire. Stop driving and diagnose it before continuing — it can signal an unsafe condition. The most common cause is failed ignition coil on cylinder 1 (typically $80–$450). Confirm the root cause before replacing parts.

Severity: high Do not drive Subcompact SUV 2020-2024 Honda HR-V

Reviewed by MECH AI Editorial · Last verified

What does P0301 mean on a 2022 Honda HR-V?

P0301 is set when the engine control module's misfire monitor detects that combustion is failing specifically in cylinder 1. The ECM identifies the affected cylinder by correlating crankshaft deceleration with camshaft position. The fact that only cylinder 1 is misfiring narrows the cause to parts that are specific to that cylinder — its plug, coil, injector, compression, or in some cases its harness wiring.

This guide covers P0301 across the 2020-2024 Honda HR-V generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2020 through 2024.

Is it safe to drive a 2022 Honda HR-V with P0301?

No. P0301 is a high-severity code on the 2022 Honda HR-V — avoid driving until it is diagnosed and repaired, as it can indicate an unsafe condition or risk further damage.

What are the symptoms of P0301 on a 2022 Honda HR-V?

What causes P0301 on a 2022 Honda HR-V?

Cause Likelihood Estimated repair (USD)
Failed ignition coil on cylinder 1 On coil-on-plug engines this is the single most likely cause. Most common $80–$450
Worn, fouled, or wrong-gap spark plug in cylinder 1 Most common $15–$80
Clogged, leaking, or electrically failed injector on cylinder 1 Common $150–$800
Burnt exhaust valve or low compression on cylinder 1 Occasional $800–$3,500
Damaged or chafed wiring to the cylinder 1 coil or injector Occasional $80–$300
Cracked cylinder 1 intake runner or local vacuum leak Rare $100–$600

How to diagnose this on a 2022 Honda HR-V

  1. Confirm cylinder 1 location on this engine

    Cylinder 1 numbering differs by manufacturer. On most inline engines cylinder 1 is at the front. On most transverse V6s cylinder 1 is on the bank closer to the firewall. Consult the service manual before pulling parts.

    Tools: Vehicle-specific service information

  2. Swap the cylinder 1 ignition coil with a known-good cylinder

    Move the cylinder 1 coil to cylinder 2 (or any non-misfiring cylinder), and move that coil to cylinder 1. Clear codes and drive. If the misfire follows the coil to its new cylinder, replace the coil. If the misfire stays in cylinder 1, the coil is fine.

    Tools: Socket set

  3. Swap the cylinder 1 spark plug

    Use the same swap method with the spark plug. Inspect the removed plug first — a wet, fuel-soaked plug means no spark or no compression; a black sooty plug means a rich condition; a cracked ceramic means replace immediately.

    Tools: Spark plug socket, Extension and ratchet

  4. Test the cylinder 1 injector electrically and acoustically

    Listen to the injector with a stethoscope at idle — it should click rhythmically. A "noid light" or scan tool fuel-injector test confirms that the ECM is firing the injector. If it pulses but the cylinder still misfires, the injector may be clogged or leaking.

    Tools: Mechanic's stethoscope, Noid light kit or scan tool injector test

  5. Perform a wet/dry compression test on cylinder 1

    Measure compression on cylinder 1 cold and warm. If significantly lower than the other cylinders, add a teaspoon of oil through the plug hole and retest. Pressure that rises with oil points to worn rings; pressure that stays low points to valves or the head gasket.

    Tools: Compression tester, Engine oil

NHTSA complaints & recalls for the 2022 Honda HR-V

Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2022 Honda HR-V. Use these to gauge how common a problem is on your specific vehicle before you start chasing Honda HR-V diagnostics.

74 owner complaints
10 involved a crash
1 involved a fire
8 reported injuries
  • ENGINE 16
  • POWER TRAIN 14
  • VEHICLE SPEED CONTROL 12
  • ELECTRICAL SYSTEM 24
  • UNKNOWN OR OTHER 14

3 active recalls

  • BACK OVER PREVENTION:DISPLAY FUNCTION Feb 2023

    Honda (American Honda Motor Co.) is recalling certain 2018-2020 Fit and 2019-2022 HR-V vehicles. The rearview camera image may not display when the engine is started with a key, due to a design error in the audio display power circuit. As such, these vehicles fail to comply wit…

    NHTSA campaign 23V046000
  • AIR BAGS:SENSOR:OCCUPANT CLASSIFICATION:FRONT PASSENGER Feb 2024

    Honda (American Honda Motor Co.) is recalling certain 2020-2022 Pilot, Accord, Civic sedan, HR-V, Odyssey, 2020 Civic coupe, Fit, 2021-2022 Civic hatchback, 2021 Civic Type R, Insight, 2020-2021 CR-V, CR-V Hybrid, Passport, Ridgeline, Accord Hybrid, 2020 Acura MDX, 2022 Acura MDX…

    NHTSA campaign 24V064000
  • BACK OVER PREVENTION:DISPLAY FUNCTION May 2024

    Honda (America Honda Motor Co.) is recalling certain 2018-2020 Fit and 2019-2022 HR-V vehicles that were previously recalled under NHTSA recall number 23V-046. The rearview camera image may not display when the engine is started with a key, due to a design error in the audio dis…

    NHTSA campaign 24V384000

How do I fix P0301 on a 2022 Honda HR-V?

About the 2020-2024 Honda HR-V

The 2020-2024 Honda HR-V was commonly sold with the following powertrains: 1.8L I4, 2.0L I4. Common trims include LX, Sport, EX, EX-L.

Why isolated-cylinder misfires are easier than P0300 alone

When the ECM can attribute the misfire to one specific cylinder, the diagnostic path is short: there are only a handful of parts unique to that cylinder. The swap test (move the coil to a different cylinder, see if the misfire follows) typically resolves a P0301 within 15 minutes of hands-on work.

When P0301 follows a coil but the coil tests good

Aftermarket coils — especially the discount bulk packs sold online — can test fine on the bench but fail under cylinder-pressure load. If a brand-new coil sets P0301 within days, replace it with an OEM or premium-aftermarket part. This is especially common on Ford modular engines and GM L83/L86 truck V8s.

P0301 on a direct-injection engine

On direct-injection engines (most modern Hondas, Mazdas, Hyundais, and many Fords from 2012 onward), carbon buildup on intake valves can cause single-cylinder misfires that ignition and fuel work will not fix. A borescope inspection through the intake port reveals the carbon. Walnut-shell blasting restores normal operation.

Related diagnostic codes