P0750 on a 2012 Kia Sorento

Shift Solenoid A Malfunction

P0750 on a 2012 Kia Sorento indicates shift solenoid a malfunction. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is failed shift solenoid a (electrical or mechanical) (typically $250–$900). Confirm the root cause before replacing parts.

Severity: high Safe to drive (short term) Mid-size SUV 2010-2014 Kia Sorento

Reviewed by MECH AI Editorial · Last verified

What does P0750 mean on a 2012 Kia Sorento?

P0750 is set when the TCM detects that shift solenoid A is not responding to commands — either the circuit is electrically open or shorted, or the solenoid is mechanically stuck. Shift solenoid A controls one of the hydraulic shift paths inside the valve body; depending on the transmission, "A" may control specific shifts (1-2 or 2-3) or be paired with another solenoid for upshift logic. Without a working solenoid A, the transmission cannot make those shifts and typically enters limp mode.

This guide covers P0750 across the 2010-2014 Kia Sorento generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2010 through 2014.

Is it safe to drive a 2012 Kia Sorento with P0750?

In most cases a 2012 Kia Sorento stays drivable for short trips with P0750 active, but diagnose and repair it promptly. This is a high-severity code — ignoring it can lead to further damage or a failed emissions test.

What are the symptoms of P0750 on a 2012 Kia Sorento?

What causes P0750 on a 2012 Kia Sorento?

Cause Likelihood Estimated repair (USD)
Failed shift solenoid A (electrical or mechanical) Most common $250–$900
Damaged solenoid wiring or external transmission connector Common $100–$500
Contaminated transmission fluid causing valve sticking Common $150–$500
Worn or stuck valve body causing the solenoid to lose pressure regulation Occasional $600–$2,000
Failed TCM driver for the solenoid circuit Rare $500–$1,500
Internal transmission damage (rare for P0750 alone) Rare $2,500–$6,500

How to diagnose this on a 2012 Kia Sorento

  1. Check fluid level and condition

    Always start a transmission diagnosis with fluid. Most modern transmissions require a specific procedure to check level — typically warm, level surface, engine running, selector in park. Burnt-smelling or dark fluid means clutch material in circulation; fix the underlying issue, not just the solenoid.

    Tools: Vehicle-specific service procedure, Replacement fluid if needed

  2. Pull all transmission codes from the TCM

    P0750 alone is one repair scope. P0750 with P0731-P0734 (ratio incorrect) or P0741 (TCC stuck off) means broader transmission issues that may not resolve with a solenoid replacement alone.

    Tools: Scan tool with TCM access

  3. Test shift solenoid A electrically

    Disconnect the external transmission connector. Find the solenoid A pin in the wiring diagram and measure resistance — typically 10–30 Ω. Infinite or near-zero means a failed solenoid. Confirm the TCM is commanding voltage during a shift attempt by back-probing while driving.

    Tools: Multimeter, Wiring diagram, Back-probe pins

  4. Inspect the connector for fluid contamination

    A failing case seal allows transmission fluid to wick up the external wiring harness, contaminating the connector. Look for fluid inside the connector or up the harness. If found, repair the seal AND likely replace the contaminated harness section — fluid in the connector creates intermittent faults that can mimic solenoid failure.

    Tools: Connector unlock tool, Flashlight

  5. Drop the pan and inspect for clutch material

    Brown or gritty paste on the pan magnet indicates clutch slippage somewhere in the transmission. If the solenoid is bad, that's one repair; if the pan also shows clutch material, the transmission has bigger problems and a solenoid replacement is just a stopgap.

    Tools: Drain pan, New filter and gasket, Common hand tools

NHTSA complaints & recalls for the 2012 Kia Sorento

Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2012 Kia Sorento. Use these to gauge how common a problem is on your specific vehicle before you start chasing Kia Sorento diagnostics.

873 owner complaints
21 involved a crash
75 involved a fire
36 reported injuries
  • ENGINE 460
  • ELECTRICAL SYSTEM 127
  • SERVICE BRAKES 101
  • UNKNOWN OR OTHER 81
  • AIR BAGS 79

5 active recalls

  • FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS Dec 2018

    Kia Motors America (Kia) is recalling certain 2011-2017 Optima, 2012-2017 Sorento and 2011-2018 Sportage vehicles that previously received an engine replacement under recall number 17V-224, warranty, or the Knock Sensor Detection System (KSDS) Product Improvement Campaign. The h…

    NHTSA campaign 18V907000
  • ENGINE Dec 2020

    Kia Motors America (Kia) is recalling certain 2012-2013 Sorento, 2012-2015 Forte and Forte Koup, 2011-2013 Optima Hybrid, 2014-2015 Soul, and 2012 Sportage vehicles. An engine compartment fire can occur while driving.…

    NHTSA campaign 20V750000
  • ENGINE AND ENGINE COOLING:ENGINE Mar 2017

    Kia Motor Company (Kia) is recalling certain 2011-2014 Optima, 2012-2014 Sorento and 2011-2013 Sportage vehicles. Machining errors during the engine manufacturing process may cause premature bearing wear within the engine.…

    NHTSA campaign 17V224000
  • POWER TRAIN:AUTOMATIC TRANSMISSION Oct 2015

    Kia Motors America (Kia) is recalling certain model year 2011-2013 Kia Sorento vehicles manufactured October 19, 2009, to January 31, 2013. In the affected vehicles, if excessive force is applied to the gear shift lever, the brake-shift interlock mechanism may chip or crack allo…

    NHTSA campaign 15V626000

How do I fix P0750 on a 2012 Kia Sorento?

About the 2010-2014 Kia Sorento

The 2010-2014 Kia Sorento was commonly sold with the following powertrains: 2.5L I4, 2.5L Turbo I4, 1.6L Turbo Hybrid I4, 1.6L Plug-in Hybrid I4. Common trims include LX, S, EX, SX, SX-Prestige, X-Line.

What “solenoid A” actually does depends on the transmission

Different transmissions use different shift logic, so “shift solenoid A” controls different specific shifts:

The repair manual for the specific transmission will identify which shift A controls. The symptom set varies accordingly — some P0750 conditions strand the vehicle, others just produce harsh or skipped shifts.

Solenoid pack vs individual solenoid replacement

Modern transmissions group all shift solenoids into a single “solenoid pack” that bolts to the valve body. Replacing all solenoids at once (as a pack) is often the same labor as one solenoid alone — and prevents the other solenoids from failing shortly after as the pack ages out together. For high-mileage transmissions, pack replacement is the more economical choice.

When the solenoid is fine but P0750 still sets

Two non-obvious causes that can fool a parts-swap repair:

Related diagnostic codes