P0455 on a 2022 Jeep Wrangler
EVAP Large or Gross Leak Detected
P0455 on a 2022 Jeep Wrangler indicates evap large or gross leak detected. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is missing, loose, or wrong-fit fuel cap (typically $0–$60). Confirm the root cause before replacing parts.
What does P0455 mean on a 2022 Jeep Wrangler?
P0455 is set when the EVAP system's gross-leak monitor detects an opening approximately 0.090 inches (2.3 mm) or larger — or in many cases, no seal at all. This is the size of a missing gas cap, a disconnected hose, or a failed vent solenoid stuck open. The system cannot hold pressure or vacuum for the calibration period, so the ECM concludes a major leak.
This guide covers P0455 across the 2020-2024 Jeep Wrangler generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2020 through 2024.
Is it safe to drive a 2022 Jeep Wrangler with P0455?
In most cases a 2022 Jeep Wrangler stays drivable for short trips with P0455 active, but diagnose and repair it promptly. This is a low-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0455 on a 2022 Jeep Wrangler?
- Check Engine Light is illuminated
- Distinct fuel smell, especially after refueling
- Fuel-cap warning message on the dashboard on some vehicles
- No drivability issue
- Vehicle will fail emissions / smog testing
What causes P0455 on a 2022 Jeep Wrangler?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Missing, loose, or wrong-fit fuel cap Always check first. A locking gas cap from another vehicle that almost fits is a common source. | Most common | $0–$60 |
| Disconnected or split EVAP hose | Common | $30–$200 |
| EVAP vent valve stuck open (will not seal during the monitor test) | Common | $80–$350 |
| Damaged or rusted-through fuel filler neck | Occasional | $200–$700 |
| Cracked or broken EVAP charcoal canister | Occasional | $200–$600 |
| Damaged O-ring at the fuel pump assembly cover | Rare | $30–$500 |
| Rodent damage to EVAP hoses (parked vehicles) | Occasional | $30–$200 |
How to diagnose this on a 2022 Jeep Wrangler
-
Check the gas cap is present and correctly seated
Confirm the cap is the correct OEM cap for the vehicle. Many generic-fit replacement caps look identical but have slightly wrong gasket geometry. Hand-tighten to at least 3 clicks. Some vehicles flag a missing cap as P0455 within one drive cycle.
Tools: None
-
Visually inspect the EVAP hoses near the canister
On most trucks and SUVs the EVAP canister sits behind the rear bumper or above the rear axle. Inspect every hose from the canister to the tank vent and to the purge solenoid. Pay particular attention to rodent damage on parked vehicles.
Tools: Floor jack and stands, Flashlight
-
Smoke-test the EVAP system at low pressure
Introduce smoke at 0.5 psi through the service port. With a large leak the smoke will pour visibly from the failure point within seconds. If smoke escapes from the vent solenoid even with the solenoid commanded closed, replace the solenoid.
Tools: EVAP smoke machine
-
Test the EVAP vent valve function
Disconnect the vent valve and apply 12 V — it should click and close. Hold a hand vacuum pump to one port and verify the valve holds vacuum when energized. A vent valve that does not close fully will set P0455 because the system can never seal.
Tools: 12 V test source, Hand vacuum pump
-
Inspect the fuel filler neck and tank-top seals
Rust-belt vehicles often develop pinholes or seam separation in the metal portion of the fuel filler neck. Once the rust is through, the EVAP system cannot hold any vacuum. Replacement is the only fix.
Tools: Floor jack and stands, Inspection mirror
NHTSA complaints & recalls for the 2022 Jeep Wrangler
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2022 Jeep Wrangler. Use these to gauge how common a problem is on your specific vehicle before you start chasing Jeep Wrangler diagnostics.
- ENGINE 82
- POWER TRAIN 55
- ELECTRICAL SYSTEM 141
- STEERING 68
- UNKNOWN OR OTHER 57
14 active recalls
- EXTERIOR LIGHTING May 2022
Chryler (FCA US, LLC) is recalling certain 2022 Jeep Wrangler vehicles. The side marker lights may not function due to an incompatible tail light assembly wiring harness. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard numbe…
NHTSA campaign 22V326000 - ELECTRICAL SYSTEM:PROPULSION SYSTEM:TRACTION BATTERY Oct 2022
Chrysler (FCA US, LLC) is recalling certain 2022-2023 Jeep Wrangler Plug-In Hybrid Electric (PHEV) vehicles. The high voltage (HV) battery pack assembly was built with incorrect fasteners to secure the 200-amp fuse, which can generate excessive heat.…
NHTSA campaign 22V768000 - FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP Oct 2022
Chrysler (FCA US, LLC) is recalling certain 2020-2022 Jeep Wrangler, Ram 1500, and 2021-2022 Jeep Gladiator vehicles equipped with 3.0L diesel engines. The high pressure fuel pump (HPFP) may fail, causing an engine stall.…
NHTSA campaign 22V767000 - ENGINE Nov 2022
Chrysler (FCA US, LLC) is recalling certain 2021-2023 Jeep Wrangler 4xe vehicles equipped with 2.0L Plug-In Hybrid Electric Vehicle engines. A loss of communication may cause an engine shutdown.…
NHTSA campaign 22V865000
How do I fix P0455 on a 2022 Jeep Wrangler?
- Replace the fuel cap
- Replace the EVAP vent valve / vent solenoid
- Replace damaged EVAP hoses
- Replace the EVAP charcoal canister
- Replace the fuel filler neck
About the 2020-2024 Jeep Wrangler
The 2020-2024 Jeep Wrangler was commonly sold with the following powertrains: 3.6L Pentastar V6, 2.0L Turbo I4, 3.0L EcoDiesel V6. Common trims include Sport, Sport S, Sahara, Rubicon.
How fast P0455 sets after a missing cap
Most OBD-II vehicles flag P0455 within one cold-start drive cycle after the cap is left off. Some Ford and GM vehicles will set a more specific “check fuel cap” message first and only escalate to P0455 if the issue persists across multiple drive cycles.
P0455 right after winter on a parked vehicle
Mice and rats chew EVAP hoses to nest inside the canister or near the fuel tank. If P0455 appears on a vehicle that has been parked for the winter, inspect every accessible EVAP hose for clean-edged bite marks before buying parts. This pattern is so common on rural-parked trucks that several shop forums have dedicated threads.
The cap that “fits” but doesn’t seal
A locking gas cap from a similar-vintage vehicle in the same brand family often threads on but seals against the filler neck at the wrong depth or angle. The result is repeated P0455 codes after every refuel. If the cap has been replaced and the code persists, double-check it is the exact OEM part number for this vehicle.
P0455 on a 2022 Jeep Wrangler: frequently asked questions
What does diagnostic trouble code P0455 mean on a 2022 Jeep Wrangler?
P0455 is set when the EVAP system's gross-leak monitor detects an opening approximately 0.090 inches (2.3 mm) or larger — or in many cases, no seal at all. This is the size of a missing gas cap, a disconnected hose, or a failed vent solenoid stuck open. The system cannot hold pressure or vacuum for the calibration period, so the ECM concludes a major leak.
What are the symptoms of P0455 on a 2022 Jeep Wrangler?
Check Engine Light is illuminated. Distinct fuel smell, especially after refueling. Fuel-cap warning message on the dashboard on some vehicles. No drivability issue. Vehicle will fail emissions / smog testing
What causes P0455 on a 2022 Jeep Wrangler?
Missing, loose, or wrong-fit fuel cap (most-common). Disconnected or split EVAP hose (common). EVAP vent valve stuck open (will not seal during the monitor test) (common). Damaged or rusted-through fuel filler neck (occasional). Cracked or broken EVAP charcoal canister (occasional). Damaged O-ring at the fuel pump assembly cover (rare). Rodent damage to EVAP hoses (parked vehicles) (occasional)
Is it safe to drive a 2022 Jeep Wrangler with P0455?
In most cases a 2022 Jeep Wrangler stays drivable for short trips with P0455 active, but it should be diagnosed and repaired promptly — this is a low-severity code. Ignoring it can lead to further damage or a failed emissions test.