P0455 on a 2012 Jeep Wrangler
EVAP Large or Gross Leak Detected
P0455 on a 2012 Jeep Wrangler indicates evap large or gross leak detected. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is missing, loose, or wrong-fit fuel cap (typically $0–$60). Confirm the root cause before replacing parts.
What does P0455 mean on a 2012 Jeep Wrangler?
P0455 is set when the EVAP system's gross-leak monitor detects an opening approximately 0.090 inches (2.3 mm) or larger — or in many cases, no seal at all. This is the size of a missing gas cap, a disconnected hose, or a failed vent solenoid stuck open. The system cannot hold pressure or vacuum for the calibration period, so the ECM concludes a major leak.
This guide covers P0455 across the 2010-2014 Jeep Wrangler generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2010 through 2014.
Is it safe to drive a 2012 Jeep Wrangler with P0455?
In most cases a 2012 Jeep Wrangler stays drivable for short trips with P0455 active, but diagnose and repair it promptly. This is a low-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0455 on a 2012 Jeep Wrangler?
- Check Engine Light is illuminated
- Distinct fuel smell, especially after refueling
- Fuel-cap warning message on the dashboard on some vehicles
- No drivability issue
- Vehicle will fail emissions / smog testing
What causes P0455 on a 2012 Jeep Wrangler?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Missing, loose, or wrong-fit fuel cap Always check first. A locking gas cap from another vehicle that almost fits is a common source. | Most common | $0–$60 |
| Disconnected or split EVAP hose | Common | $30–$200 |
| EVAP vent valve stuck open (will not seal during the monitor test) | Common | $80–$350 |
| Damaged or rusted-through fuel filler neck | Occasional | $200–$700 |
| Cracked or broken EVAP charcoal canister | Occasional | $200–$600 |
| Damaged O-ring at the fuel pump assembly cover | Rare | $30–$500 |
| Rodent damage to EVAP hoses (parked vehicles) | Occasional | $30–$200 |
How to diagnose this on a 2012 Jeep Wrangler
-
Check the gas cap is present and correctly seated
Confirm the cap is the correct OEM cap for the vehicle. Many generic-fit replacement caps look identical but have slightly wrong gasket geometry. Hand-tighten to at least 3 clicks. Some vehicles flag a missing cap as P0455 within one drive cycle.
Tools: None
-
Visually inspect the EVAP hoses near the canister
On most trucks and SUVs the EVAP canister sits behind the rear bumper or above the rear axle. Inspect every hose from the canister to the tank vent and to the purge solenoid. Pay particular attention to rodent damage on parked vehicles.
Tools: Floor jack and stands, Flashlight
-
Smoke-test the EVAP system at low pressure
Introduce smoke at 0.5 psi through the service port. With a large leak the smoke will pour visibly from the failure point within seconds. If smoke escapes from the vent solenoid even with the solenoid commanded closed, replace the solenoid.
Tools: EVAP smoke machine
-
Test the EVAP vent valve function
Disconnect the vent valve and apply 12 V — it should click and close. Hold a hand vacuum pump to one port and verify the valve holds vacuum when energized. A vent valve that does not close fully will set P0455 because the system can never seal.
Tools: 12 V test source, Hand vacuum pump
-
Inspect the fuel filler neck and tank-top seals
Rust-belt vehicles often develop pinholes or seam separation in the metal portion of the fuel filler neck. Once the rust is through, the EVAP system cannot hold any vacuum. Replacement is the only fix.
Tools: Floor jack and stands, Inspection mirror
NHTSA complaints & recalls for the 2012 Jeep Wrangler
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2012 Jeep Wrangler. Use these to gauge how common a problem is on your specific vehicle before you start chasing Jeep Wrangler diagnostics.
- POWER TRAIN 282
- ENGINE 171
- STEERING 204
- ELECTRICAL SYSTEM 147
- AIR BAGS 128
10 active recalls
- AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE Jan 2019
Chrysler (FCA US LLC) is recalling certain 2010 Dodge Ram 3500, Ram 4500/5500, 2010-2011 Dodge Dakota, 2010-2014 Dodge Challenger, 2010-2015 Dodge Challenger, Chrysler 300, and 2010-2016 Jeep Wrangler vehicles. Upon deployment of the driver's frontal air bag, excessive internal…
NHTSA campaign 19V018000 - SEAT BELTS:FRONT:ANCHORAGE Sep 2019
Chrysler (FCA US LLC) is recalling certain 2011-2018 Jeep Wrangler right hand drive vehicles. The driver's seat belt buckle mounting strap may fracture and separate from the seat frame.…
NHTSA campaign 19V680000 - AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE Jan 2018
Chrysler (FCA US LLC) is recalling certain 2009-2013 Jeep Wrangler, Chrysler 300, Dodge Challenger and Dodge Charger vehicles, and 2009-2011 Dodge Dakota vehicles sold, or ever registered, in the states of Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, Sou…
NHTSA campaign 18V021000 - AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE May 2016
Chrysler (FCA US LLC) expanded the affected population to include 73,712 2005-2009 RAM 2500 trucks produced at the St. Louis North Assembly Plant. With this change, Chrysler is recalling certain model year 2004-2008 RAM 1500, 2005-2009 RAM 2500, 2006-2009 RAM 3500, 2007-2010 RAM…
NHTSA campaign 16V352000
How do I fix P0455 on a 2012 Jeep Wrangler?
- Replace the fuel cap
- Replace the EVAP vent valve / vent solenoid
- Replace damaged EVAP hoses
- Replace the EVAP charcoal canister
- Replace the fuel filler neck
About the 2010-2014 Jeep Wrangler
The 2010-2014 Jeep Wrangler was commonly sold with the following powertrains: 3.6L Pentastar V6, 2.0L Turbo I4, 3.0L EcoDiesel V6. Common trims include Sport, Sport S, Sahara, Rubicon.
How fast P0455 sets after a missing cap
Most OBD-II vehicles flag P0455 within one cold-start drive cycle after the cap is left off. Some Ford and GM vehicles will set a more specific “check fuel cap” message first and only escalate to P0455 if the issue persists across multiple drive cycles.
P0455 right after winter on a parked vehicle
Mice and rats chew EVAP hoses to nest inside the canister or near the fuel tank. If P0455 appears on a vehicle that has been parked for the winter, inspect every accessible EVAP hose for clean-edged bite marks before buying parts. This pattern is so common on rural-parked trucks that several shop forums have dedicated threads.
The cap that “fits” but doesn’t seal
A locking gas cap from a similar-vintage vehicle in the same brand family often threads on but seals against the filler neck at the wrong depth or angle. The result is repeated P0455 codes after every refuel. If the cap has been replaced and the code persists, double-check it is the exact OEM part number for this vehicle.
P0455 on a 2012 Jeep Wrangler: frequently asked questions
What does diagnostic trouble code P0455 mean on a 2012 Jeep Wrangler?
P0455 is set when the EVAP system's gross-leak monitor detects an opening approximately 0.090 inches (2.3 mm) or larger — or in many cases, no seal at all. This is the size of a missing gas cap, a disconnected hose, or a failed vent solenoid stuck open. The system cannot hold pressure or vacuum for the calibration period, so the ECM concludes a major leak.
What are the symptoms of P0455 on a 2012 Jeep Wrangler?
Check Engine Light is illuminated. Distinct fuel smell, especially after refueling. Fuel-cap warning message on the dashboard on some vehicles. No drivability issue. Vehicle will fail emissions / smog testing
What causes P0455 on a 2012 Jeep Wrangler?
Missing, loose, or wrong-fit fuel cap (most-common). Disconnected or split EVAP hose (common). EVAP vent valve stuck open (will not seal during the monitor test) (common). Damaged or rusted-through fuel filler neck (occasional). Cracked or broken EVAP charcoal canister (occasional). Damaged O-ring at the fuel pump assembly cover (rare). Rodent damage to EVAP hoses (parked vehicles) (occasional)
Is it safe to drive a 2012 Jeep Wrangler with P0455?
In most cases a 2012 Jeep Wrangler stays drivable for short trips with P0455 active, but it should be diagnosed and repaired promptly — this is a low-severity code. Ignoring it can lead to further damage or a failed emissions test.