P0446 on a 2022 Toyota Camry
EVAP Vent Control Circuit Fault
P0446 on a 2022 Toyota Camry indicates evap vent control circuit fault. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is failed evap vent valve / vent solenoid (mechanical sticking) (typically $80–$350). Confirm the root cause before replacing parts.
What does P0446 mean on a 2022 Toyota Camry?
P0446 is set when the engine control module detects that the EVAP vent valve circuit is not behaving as commanded. The vent valve is the normally-open solenoid that lets the charcoal canister breathe — and closes during the EVAP leak test to seal the system. P0446 typically means the vent valve is stuck (mechanically or electrically) so that the system can never seal properly for the leak test.
This guide covers P0446 across the 2020-2024 Toyota Camry generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2020 through 2024.
Is it safe to drive a 2022 Toyota Camry with P0446?
In most cases a 2022 Toyota Camry stays drivable for short trips with P0446 active, but diagnose and repair it promptly. This is a low-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0446 on a 2022 Toyota Camry?
- Check Engine Light is illuminated
- Difficulty filling the fuel tank (pump clicks off repeatedly)
- No other drivability problems
- Vehicle will fail emissions / smog testing
- Sometimes accompanied by P0455 (large leak) on the same scan
What causes P0446 on a 2022 Toyota Camry?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Failed EVAP vent valve / vent solenoid (mechanical sticking) | Most common | $80–$350 |
| Dirt, debris, or spider webs clogging the vent valve filter Common on trucks and SUVs with the canister mounted under the vehicle. | Common | $20–$100 |
| Damaged wiring or connector at the vent valve | Common | $50–$250 |
| Failed PCM driver circuit for the vent valve (rare) | Rare | $400–$1,500 |
| Cracked or saturated EVAP charcoal canister | Occasional | $200–$600 |
How to diagnose this on a 2022 Toyota Camry
-
Locate the vent valve on this vehicle
The vent valve is mounted on or next to the charcoal canister. On most modern trucks and SUVs that is behind the rear bumper or near the fuel tank. On many cars it sits in the engine compartment. Consult the service manual for the exact location.
Tools: Vehicle-specific service information
-
Test the vent valve electrically
Disconnect the valve connector. With the key on, check for battery voltage on the power side. Apply 12 V across the solenoid terminals directly — you should hear and feel it click. A solenoid that does not click is dead and needs replacement.
Tools: Multimeter, Test leads / jumper wires
-
Test the vent valve mechanically
Disconnect the hose at the vent valve. Connect a hand vacuum pump. With the solenoid de-energized, the valve should let air flow freely (no vacuum holds). With 12 V applied, the valve should hold vacuum. A valve that holds vacuum at rest, or that leaks vacuum when commanded closed, is the problem.
Tools: Hand vacuum pump, 12 V test source
-
Inspect for contamination
Trucks and SUVs frequently get spider webs, mud, or sand inside the vent valve filter on the canister side. Some vehicles have a dust filter that is replaceable; others integrate it into the valve assembly. Clean or replace as needed.
Tools: Compressed air, Replacement filter (if applicable)
-
Confirm the canister itself is intact
With the vent valve removed, look into the canister port for cracked plastic, saturated charcoal (will smell strongly of fuel), or debris. A failed canister will cause repeated P0446 set events even after the vent valve is replaced.
Tools: Flashlight
Known Technical Service Bulletins for the 2020-2024 Toyota Camry
Manufacturers publish Technical Service Bulletins (TSBs) when a known issue affects a specific vehicle. These bulletins come from the NHTSA database for your Toyota Camry.
- ENGINE Feb 27, 2026
OBSOLETE NOTICE February 27, 2026: This bulletin is no longer applicable and is now obsolete.
NHTSA #11029896 - ELECTRICAL SYSTEM Jan 30, 2026
OBSOLETE NOTICE January 30, 2026: This bulletin is now obsolete. Please see T-SB-0001-26.
NHTSA #11028726 - ELECTRICAL SYSTEM Jan 28, 2026
Some 2018 – 2024 model year Toyota vehicles equipped with a Premium Audio with Dynamic Navigation System require a Special Service Tool (SST) USB flash drive to update the map, points of interest, and system software.
NHTSA #11028722 - UNKNOWN OR OTHER Jan 7, 2026
Some 2005 – 2026 Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty odor is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this Service Bulletin is to provide general guidelines and procedures for odor remediation. This Service Bulletin provides a guide on how to prepare and treat the interior of the vehicle for odor remediation. Refer to the applicable model and model year Repair Manual and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines.
NHTSA #11028712 - ENGINE Aug 7, 2025
The specific condition covered by this program is for a small engine coolant leak that can occur from the flow shut-off valve that can allow coolant to drip on other parts of the vehicle. This can cause "Engine Maintenance Required" to be displayed on the instrument cluster or cause the A/C not to function normally. Although the flow shut-off valve is covered by Toyota’s New Vehicle Limited Warranty for 36 months or 36,000 miles (whichever comes first), we at Toyota care about the customers’ ownership experience. Toyota is providing coverage for repairs related to Flow Shut-off Valve Coolant Leak.
NHTSA #11022949 - ELECTRICAL SYSTEM Jun 25, 2025
Some 2021 – 2022 model year Avalon, 2018 – 2024 Camry, 2019 – 2025 model year Corolla, 2022 – 2025 model year Corolla Cross, and 2019 – 2025 model year RAV4 vehicles with A25A-FKS and M20A-FKS engines may have a MIL ON condition with one or more of the following Diagnostic Trouble Codes (DTCs) upon cold soak start up with engine coolant temperatures between 14°F – 41°F: •P030027 – Random/Multiple Cylinder Misfire Detected (Emission) Signal Rate of Change Above Threshold •P030000 – Random/Multiple Cylinder Misfire Detected •P030100 – Cylinder 1 Misfire Detected •P030200 – Cylinder 2 Misfire Detected •P030300 – Cylinder 3 Misfire Detected •P030400 – Cylinder 4 Misfire Detected
NHTSA #11020670
+14 more TSBs available in MECH AI's TSB explorer for this vehicle.
NHTSA complaints & recalls for the 2022 Toyota Camry
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2022 Toyota Camry. Use these to gauge how common a problem is on your specific vehicle before you start chasing Toyota Camry diagnostics.
- VEHICLE SPEED CONTROL 6
- AIR BAGS 10
- UNKNOWN OR OTHER 7
- SERVICE BRAKES 7
- ELECTRICAL SYSTEM 7
1 active recall
- AIR BAGS:SENSOR:OCCUPANT CLASSIFICATION Dec 2023
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2020-2021 Avalon, Avalon Hybrid, Corolla, Highlander, Highlander Hybrid, RAV4, RAV4 Hybrid, Lexus ES350, Lexus RX350, Lexus RX450H, 2021 Sienna Hybrid, Lexus ES250, 2020-2022 Camry, Camry Hybrid, and ES300H ve…
NHTSA campaign 23V865000
How do I fix P0446 on a 2022 Toyota Camry?
- Replace the EVAP vent valve / vent solenoid
- Clean the vent valve filter and inspection port
- Repair damaged wiring or connector at the vent valve
- Replace the charcoal canister assembly
About the 2020-2024 Toyota Camry
The 2020-2024 Toyota Camry was commonly sold with the following powertrains: 2.5L I4, 3.5L V6, 2.5L Hybrid I4. Common trims include LE, SE, XLE, XSE.
Why the gas pump clicks off with P0446
The vent valve is what allows the fuel tank to “breathe” during refueling. If the valve is stuck closed, displaced air cannot escape as fuel goes in — pressure builds, fuel splashes back into the filler neck, and the pump nozzle’s auto-shutoff triggers prematurely. If you have to “trickle fill” your tank to get gas in, P0446 (or a related vent code) is the most likely cause.
When P0446 sets with P0455
If P0446 (vent control) sets alongside P0455 (large leak), the root cause is usually one part — the vent valve is stuck open, so the system can never seal for the leak test, which triggers both codes. Replace the vent valve and clear codes; if P0455 returns alone the next monitor run, do a separate small-leak diagnosis.
Trucks and SUVs vs. cars
Under-vehicle mounted vent valves (most trucks, SUVs, and minivans) fail more often than engine-bay mounted ones. They live in a worse environment — road spray, salt, mud, debris. On vehicles with chronic P0446, an upgraded “all-terrain” vent valve or a relocation kit is sometimes worth considering after the second failure.
P0446 on a 2022 Toyota Camry: frequently asked questions
What does diagnostic trouble code P0446 mean on a 2022 Toyota Camry?
P0446 is set when the engine control module detects that the EVAP vent valve circuit is not behaving as commanded. The vent valve is the normally-open solenoid that lets the charcoal canister breathe — and closes during the EVAP leak test to seal the system. P0446 typically means the vent valve is stuck (mechanically or electrically) so that the system can never seal properly for the leak test.
What are the symptoms of P0446 on a 2022 Toyota Camry?
Check Engine Light is illuminated. Difficulty filling the fuel tank (pump clicks off repeatedly). No other drivability problems. Vehicle will fail emissions / smog testing. Sometimes accompanied by P0455 (large leak) on the same scan
What causes P0446 on a 2022 Toyota Camry?
Failed EVAP vent valve / vent solenoid (mechanical sticking) (most-common). Dirt, debris, or spider webs clogging the vent valve filter (common). Damaged wiring or connector at the vent valve (common). Failed PCM driver circuit for the vent valve (rare) (rare). Cracked or saturated EVAP charcoal canister (occasional)
Is it safe to drive a 2022 Toyota Camry with P0446?
In most cases a 2022 Toyota Camry stays drivable for short trips with P0446 active, but it should be diagnosed and repaired promptly — this is a low-severity code. Ignoring it can lead to further damage or a failed emissions test.