P0301 on a 2017 GMC Sierra 1500

Cylinder 1 Misfire

P0301 on a 2017 GMC Sierra 1500 indicates cylinder 1 misfire. Stop driving and diagnose it before continuing — it can signal an unsafe condition. The most common cause is failed ignition coil on cylinder 1 (typically $80–$450). Confirm the root cause before replacing parts.

Severity: high Do not drive Pickup Truck 2015-2019 GMC Sierra 1500

Reviewed by MECH AI Editorial · Last verified

What does P0301 mean on a 2017 GMC Sierra 1500?

P0301 is set when the engine control module's misfire monitor detects that combustion is failing specifically in cylinder 1. The ECM identifies the affected cylinder by correlating crankshaft deceleration with camshaft position. The fact that only cylinder 1 is misfiring narrows the cause to parts that are specific to that cylinder — its plug, coil, injector, compression, or in some cases its harness wiring.

This guide covers P0301 across the 2015-2019 GMC Sierra 1500 generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2015 through 2019.

Is it safe to drive a 2017 GMC Sierra 1500 with P0301?

No. P0301 is a high-severity code on the 2017 GMC Sierra 1500 — avoid driving until it is diagnosed and repaired, as it can indicate an unsafe condition or risk further damage.

What are the symptoms of P0301 on a 2017 GMC Sierra 1500?

What causes P0301 on a 2017 GMC Sierra 1500?

Cause Likelihood Estimated repair (USD)
Failed ignition coil on cylinder 1 On coil-on-plug engines this is the single most likely cause. Most common $80–$450
Worn, fouled, or wrong-gap spark plug in cylinder 1 Most common $15–$80
Clogged, leaking, or electrically failed injector on cylinder 1 Common $150–$800
Burnt exhaust valve or low compression on cylinder 1 Occasional $800–$3,500
Damaged or chafed wiring to the cylinder 1 coil or injector Occasional $80–$300
Cracked cylinder 1 intake runner or local vacuum leak Rare $100–$600

How to diagnose this on a 2017 GMC Sierra 1500

  1. Confirm cylinder 1 location on this engine

    Cylinder 1 numbering differs by manufacturer. On most inline engines cylinder 1 is at the front. On most transverse V6s cylinder 1 is on the bank closer to the firewall. Consult the service manual before pulling parts.

    Tools: Vehicle-specific service information

  2. Swap the cylinder 1 ignition coil with a known-good cylinder

    Move the cylinder 1 coil to cylinder 2 (or any non-misfiring cylinder), and move that coil to cylinder 1. Clear codes and drive. If the misfire follows the coil to its new cylinder, replace the coil. If the misfire stays in cylinder 1, the coil is fine.

    Tools: Socket set

  3. Swap the cylinder 1 spark plug

    Use the same swap method with the spark plug. Inspect the removed plug first — a wet, fuel-soaked plug means no spark or no compression; a black sooty plug means a rich condition; a cracked ceramic means replace immediately.

    Tools: Spark plug socket, Extension and ratchet

  4. Test the cylinder 1 injector electrically and acoustically

    Listen to the injector with a stethoscope at idle — it should click rhythmically. A "noid light" or scan tool fuel-injector test confirms that the ECM is firing the injector. If it pulses but the cylinder still misfires, the injector may be clogged or leaking.

    Tools: Mechanic's stethoscope, Noid light kit or scan tool injector test

  5. Perform a wet/dry compression test on cylinder 1

    Measure compression on cylinder 1 cold and warm. If significantly lower than the other cylinders, add a teaspoon of oil through the plug hole and retest. Pressure that rises with oil points to worn rings; pressure that stays low points to valves or the head gasket.

    Tools: Compression tester, Engine oil

NHTSA complaints & recalls for the 2017 GMC Sierra 1500

Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2017 GMC Sierra 1500. Use these to gauge how common a problem is on your specific vehicle before you start chasing GMC Sierra 1500 diagnostics.

425 owner complaints
20 involved a crash
5 involved a fire
8 reported injuries
  • POWER TRAIN 142
  • ENGINE 62
  • SERVICE BRAKES 127
  • ELECTRICAL SYSTEM 60
  • UNKNOWN OR OTHER 41

5 active recalls

  • SERVICE BRAKES, HYDRAULIC:POWER ASSIST:VACUUM Sep 2019

    General Motors LLC (GM) is recalling certain 2015-2017 Cadillac Escalade, 2014-2018 Chevrolet Silverado, GMC Sierra, 2015-2018 Chevrolet Suburban, Tahoe, GMC Yukon vehicles. The amount of vacuum created by the vacuum pump may decrease over time.…

    NHTSA campaign 19V645000
  • SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:WHEEL SPEED SENSOR/TONE RING Oct 2019

    General Motors LLC (GM) is recalling certain 2015-2020 Chevrolet Suburban, Tahoe, and GMC Yukon, and 2014-2018 Chevrolet Silverado 1500 and GMC Sierra 1500 vehicles equipped with a 5.3-liter engine, a 3.08-ratio rear axle and four-wheel drive. If a wheel-speed sensor fails, whil…

    NHTSA campaign 19V761000
  • AIR BAGS:FRONTAL Sep 2016

    General Motors LLC (GM) is recalling certain model year 2015-2017 Chevrolet Silverado 2500 HD, 3500 HD, Tahoe, Suburban, GMC Sierra 2500 HD and 3500 HD, GMC Yukon, GMC Yukon XL, Cadillac Escalade and Cadillac Escalade ESV vehicles and 2014-2017 Chevrolet Corvette, Silverado 1500…

    NHTSA campaign 16V651000
  • CHILD SEAT:TETHER: CONNECTOR/CLIP Aug 2017

    General Motors LLC (GM) is recalling certain 2017 Chevrolet Silverado 1500, and GMC Sierra 1500 trucks. The owner's manual for the affected vehicles may be missing instructions on how to use the tether anchorage and child restraint anchorage systems. As such, these vehicles fai…

    NHTSA campaign 17V487000

How do I fix P0301 on a 2017 GMC Sierra 1500?

About the 2015-2019 GMC Sierra 1500

The 2015-2019 GMC Sierra 1500 was commonly sold with the following powertrains: 5.3L V8, 6.2L V8, 2.7L Turbo I4, 3.0L Duramax I6 Diesel. Common trims include Pro, SLE, Elevation, SLT, AT4, Denali.

Why isolated-cylinder misfires are easier than P0300 alone

When the ECM can attribute the misfire to one specific cylinder, the diagnostic path is short: there are only a handful of parts unique to that cylinder. The swap test (move the coil to a different cylinder, see if the misfire follows) typically resolves a P0301 within 15 minutes of hands-on work.

When P0301 follows a coil but the coil tests good

Aftermarket coils — especially the discount bulk packs sold online — can test fine on the bench but fail under cylinder-pressure load. If a brand-new coil sets P0301 within days, replace it with an OEM or premium-aftermarket part. This is especially common on Ford modular engines and GM L83/L86 truck V8s.

P0301 on a direct-injection engine

On direct-injection engines (most modern Hondas, Mazdas, Hyundais, and many Fords from 2012 onward), carbon buildup on intake valves can cause single-cylinder misfires that ignition and fuel work will not fix. A borescope inspection through the intake port reveals the carbon. Walnut-shell blasting restores normal operation.

Related diagnostic codes