P0137 on a 2022 Toyota Camry
Post-Cat O2 Sensor Low Voltage (Bank 1 Downstream)
P0137 on a 2022 Toyota Camry indicates post-cat o2 sensor low voltage (bank 1 downstream). It usually stays drivable short-term but should be diagnosed promptly. The most common cause is downstream o2 signal wire shorted to ground or open (typically $80–$350). Confirm the root cause before replacing parts.
What does P0137 mean on a 2022 Toyota Camry?
P0137 is set when the Bank 1 downstream oxygen sensor reports a voltage below the calibrated minimum — typically under about 0.1 V — for an extended period. Bank 1 is the cylinder bank containing cylinder number 1. Sensor 2 is the sensor AFTER the catalytic converter, not the one threaded into the exhaust manifold. A healthy downstream sensor on a warm engine holds a relatively steady 0.6–0.8 V because the catalyst smooths out the rich / lean swings coming from the engine, so a reading pinned low means an open or shorted-to-ground signal circuit, a failed sensor, or fresh air getting into the exhaust ahead of the sensor.
The symptoms, causes, and diagnostic steps below describe P0137 itself, so they read the same on nearby Toyota Camry model years. Powertrain and trim details vary year to year — confirm the specifics against your own vehicle before buying parts.
Is it safe to drive a 2022 Toyota Camry with P0137?
In most cases a 2022 Toyota Camry stays drivable for short trips with P0137 active, but diagnose and repair it promptly. This is a moderate-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0137 on a 2022 Toyota Camry?
- Check Engine Light is illuminated
- Catalyst readiness monitor will not complete
- Often no drivability symptoms at all
- Possible slight reduction in fuel economy
- Vehicle will fail emissions / smog testing
- Sometimes accompanied by P0171 if a genuine lean condition is present
What causes P0137 on a 2022 Toyota Camry?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Downstream O2 signal wire shorted to ground or open | Most common | $80–$350 |
| Failed Bank 1 downstream O2 sensor (stuck low) | Most common | $150–$450 |
| Exhaust leak ahead of the downstream sensor drawing in fresh air | Common | $100–$500 |
| Corroded downstream O2 sensor connector | Common | $30–$200 |
| Damaged sensor pigtail from a previous exhaust or suspension repair | Occasional | $80–$300 |
| Genuine lean condition from a vacuum leak reaching the catalyst Here the sensor is telling the truth — fix the lean condition, not the sensor. | Occasional | $80–$600 |
| Failed PCM input for the downstream sensor circuit | Rare | $400–$1,500 |
Cost ranges are editorial estimates for parts and labor at an independent U.S. shop — not quotes. What you actually pay moves with your region, the shop's hourly rate, which engine you have, and how much diagnostic time the job takes. Dealer service departments typically sit above these ranges.
How to diagnose this on a 2022 Toyota Camry
-
Confirm you are at the right sensor before touching anything
Bank 1 Sensor 2 is downstream of the catalytic converter on the bank containing cylinder number 1. On an inline engine there is only one bank, so it is simply the sensor after the cat. On a V engine you have to establish which bank holds cylinder 1 first. Replacing the upstream sensor by mistake is the single most common wasted repair on this code.
Tools: Vehicle-specific service information, Vehicle lift or jack stands
-
Read fuel trims to separate a real lean condition from a sensor fault
Check Bank 1 long-term fuel trim at idle and at 2500 RPM. Near zero means the engine is fuelling correctly and the sensor or its wiring is lying. Trim at +15 % or higher means the engine really is lean, the sensor is reporting honestly, and your job is to find the vacuum or exhaust leak — not to buy an O2 sensor.
Tools: Scan tool with live fuel trim PIDs
-
Disconnect the sensor and look for bias voltage
Unplug the downstream sensor. With the key on, the scan tool PID should show the ECM's bias voltage, usually around 0.4–0.5 V. If the reading stays pinned at zero with the sensor disconnected, the signal wire is shorted to ground somewhere between the connector and the PCM, and a new sensor will not change a thing.
Tools: Scan tool, Multimeter
-
Inspect the harness and connector under the vehicle
The downstream sensor and its harness live under the car in road spray and salt. Trace the wiring from the sensor body back to the chassis connector looking for melted insulation where it has touched the exhaust, chafing against the underbody, and rodent damage. Open the connector and check for water and green corrosion.
Tools: Flashlight, Inspection mirror, Electrical contact cleaner
-
Find exhaust leaks between the catalyst and the sensor
A pinhole or a leaking flange gasket ahead of the downstream sensor lets fresh air into the exhaust stream, and the sensor correctly reports the oxygen it sees — as a permanently low voltage. Listen along the pipe with the engine cold, or use a smoke machine on the exhaust to make small leaks visible.
Tools: Mechanic's stethoscope, Smoke machine (optional), Flashlight
Known Technical Service Bulletins for the 2020-2024 Toyota Camry
Manufacturers publish Technical Service Bulletins (TSBs) when a known issue affects a specific vehicle. These bulletins come from the NHTSA database for your Toyota Camry.
- ENGINE Feb 27, 2026
OBSOLETE NOTICE February 27, 2026: This bulletin is no longer applicable and is now obsolete.
NHTSA #11029896 - ELECTRICAL SYSTEM Jan 30, 2026
OBSOLETE NOTICE January 30, 2026: This bulletin is now obsolete. Please see T-SB-0001-26.
NHTSA #11028726 - ELECTRICAL SYSTEM Jan 28, 2026
Some 2018 – 2024 model year Toyota vehicles equipped with a Premium Audio with Dynamic Navigation System require a Special Service Tool (SST) USB flash drive to update the map, points of interest, and system software.
NHTSA #11028722 - UNKNOWN OR OTHER Jan 7, 2026
Some 2005 – 2026 Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty odor is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this Service Bulletin is to provide general guidelines and procedures for odor remediation. This Service Bulletin provides a guide on how to prepare and treat the interior of the vehicle for odor remediation. Refer to the applicable model and model year Repair Manual and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines.
NHTSA #11028712 - ENGINE Aug 7, 2025
The specific condition covered by this program is for a small engine coolant leak that can occur from the flow shut-off valve that can allow coolant to drip on other parts of the vehicle. This can cause "Engine Maintenance Required" to be displayed on the instrument cluster or cause the A/C not to function normally. Although the flow shut-off valve is covered by Toyota’s New Vehicle Limited Warranty for 36 months or 36,000 miles (whichever comes first), we at Toyota care about the customers’ ownership experience. Toyota is providing coverage for repairs related to Flow Shut-off Valve Coolant Leak.
NHTSA #11022949 - ELECTRICAL SYSTEM Jun 25, 2025
Some 2021 – 2022 model year Avalon, 2018 – 2024 Camry, 2019 – 2025 model year Corolla, 2022 – 2025 model year Corolla Cross, and 2019 – 2025 model year RAV4 vehicles with A25A-FKS and M20A-FKS engines may have a MIL ON condition with one or more of the following Diagnostic Trouble Codes (DTCs) upon cold soak start up with engine coolant temperatures between 14°F – 41°F: •P030027 – Random/Multiple Cylinder Misfire Detected (Emission) Signal Rate of Change Above Threshold •P030000 – Random/Multiple Cylinder Misfire Detected •P030100 – Cylinder 1 Misfire Detected •P030200 – Cylinder 2 Misfire Detected •P030300 – Cylinder 3 Misfire Detected •P030400 – Cylinder 4 Misfire Detected
NHTSA #11020670
+14 more TSBs available in MECH AI's TSB explorer for this vehicle.
NHTSA complaints & recalls for the 2022 Toyota Camry
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2022 Toyota Camry. Use these to gauge how common a problem is on your specific vehicle before you start chasing Toyota Camry diagnostics.
- VEHICLE SPEED CONTROL 6
- AIR BAGS 10
- UNKNOWN OR OTHER 7
- SERVICE BRAKES 7
- ELECTRICAL SYSTEM 7
1 active recall
- AIR BAGS:SENSOR:OCCUPANT CLASSIFICATION Dec 2023
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2020-2021 Avalon, Avalon Hybrid, Corolla, Highlander, Highlander Hybrid, RAV4, RAV4 Hybrid, Lexus ES350, Lexus RX350, Lexus RX450H, 2021 Sienna Hybrid, Lexus ES250, 2020-2022 Camry, Camry Hybrid, and ES300H ve…
NHTSA campaign 23V865000
How do I fix P0137 on a 2022 Toyota Camry?
- Replace the Bank 1 downstream O2 sensor with an OEM part
- Repair the shorted-to-ground or open O2 signal wire
- Repair exhaust leaks between the catalyst and the downstream sensor
- Clean or replace the corroded downstream sensor connector
- Repair vacuum leaks if fuel trims confirm a genuine lean condition
Engines in the 2022 Toyota Camry
The 2022 Toyota Camry was offered with the 2.5L 4-cylinder and 3.5L 6-cylinder engines, including a hybrid version. Which one you have changes where P0137 is most likely to originate, so confirm your engine before ordering parts.
Engine data: EPA fueleconomy.gov.
Bank 1 Sensor 2 means the sensor after the catalytic converter
This is worth being pedantic about, because getting it wrong sends you to the wrong part of the exhaust:
- Sensor 1 — upstream, before the catalyst, usually threaded into the exhaust manifold or the downpipe. This is the sensor that drives fuel control.
- Sensor 2 — downstream, after the catalyst, underneath the vehicle. This is the sensor that monitors whether the catalyst is still working.
P0137 is a Sensor 2 code. If you are reaching down past the manifold, you are at the wrong sensor.
Is the sensor lying, or is the engine actually lean?
Fuel trim answers this in about thirty seconds, and it decides the entire repair:
- Trim near zero, P0137 alone → the engine is fuelling correctly. The sensor or its circuit is at fault. Test the wiring, then replace the sensor.
- Trim high positive, often with P0171 → the engine really is running lean and the downstream sensor is honestly reporting it. Replacing the sensor fixes nothing. Go find the vacuum leak, the exhaust leak, or the fuel delivery problem.
Why the car drives fine with P0137
The downstream sensor’s primary job is monitoring catalyst efficiency, not controlling fuel delivery — that is the upstream sensor’s role. It contributes only a slow secondary correction to fuel trim. So a failed downstream sensor almost always shows up as a light on the dash and a failed emissions test, not as a car that runs badly. That makes P0137 non-urgent from a drivability standpoint, but it does not make it optional: the catalyst monitor cannot complete while it is set, and most emissions programmes treat an incomplete monitor as a failure.
Buy the sensor once
Aftermarket oxygen sensors at a fraction of OEM pricing have a real track record of setting the same code again within months. The downstream sensor is a comparison device rather than a precision measurement device, so it is slightly more forgiving than the upstream one — but not forgiving enough to be worth the second job. Bosch, Denso, or NTK in the exact part number listed for your year, make, model, engine, and emissions package.
P0137 on a 2022 Toyota Camry: frequently asked questions
What does diagnostic trouble code P0137 mean on a 2022 Toyota Camry?
P0137 is set when the Bank 1 downstream oxygen sensor reports a voltage below the calibrated minimum — typically under about 0.1 V — for an extended period. Bank 1 is the cylinder bank containing cylinder number 1. Sensor 2 is the sensor AFTER the catalytic converter, not the one threaded into the exhaust manifold. A healthy downstream sensor on a warm engine holds a relatively steady 0.6–0.8 V because the catalyst smooths out the rich / lean swings coming from the engine, so a reading pinned low means an open or shorted-to-ground signal circuit, a failed sensor, or fresh air getting into the exhaust ahead of the sensor.
What are the symptoms of P0137 on a 2022 Toyota Camry?
Check Engine Light is illuminated. Catalyst readiness monitor will not complete. Often no drivability symptoms at all. Possible slight reduction in fuel economy. Vehicle will fail emissions / smog testing. Sometimes accompanied by P0171 if a genuine lean condition is present
What causes P0137 on a 2022 Toyota Camry?
Downstream O2 signal wire shorted to ground or open (most-common). Failed Bank 1 downstream O2 sensor (stuck low) (most-common). Exhaust leak ahead of the downstream sensor drawing in fresh air (common). Corroded downstream O2 sensor connector (common). Damaged sensor pigtail from a previous exhaust or suspension repair (occasional). Genuine lean condition from a vacuum leak reaching the catalyst (occasional). Failed PCM input for the downstream sensor circuit (rare)
Is it safe to drive a 2022 Toyota Camry with P0137?
In most cases a 2022 Toyota Camry stays drivable for short trips with P0137 active, but it should be diagnosed and repaired promptly — this is a moderate-severity code. Ignoring it can lead to further damage or a failed emissions test.