P2187 on a 2012 Honda CR-V
System Too Lean at Idle (Bank 1)
P2187 on a 2012 Honda CR-V indicates system too lean at idle (bank 1). It usually stays drivable short-term but should be diagnosed promptly. The most common cause is vacuum leak (intake gasket, brake-booster hose, pcv, throttle-body gasket) (typically $80–$600). Confirm the root cause before replacing parts.
What does P2187 mean on a 2012 Honda CR-V?
P2187 is set when long-term fuel trim on Bank 1 goes excessively positive (typically beyond +20 %) specifically at idle, but stays closer to normal at part-throttle and cruise. The distinctive pattern — lean only at idle — almost always points at a vacuum leak rather than a fueling problem. At idle, intake manifold vacuum is at its highest, which amplifies the effect of any leak; off-idle, the leak path becomes a smaller fraction of total airflow and trims look fine.
This guide covers P2187 across the 2010-2014 Honda CR-V generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2010 through 2014.
Is it safe to drive a 2012 Honda CR-V with P2187?
In most cases a 2012 Honda CR-V stays drivable for short trips with P2187 active, but diagnose and repair it promptly. This is a moderate-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P2187 on a 2012 Honda CR-V?
- Check Engine Light is illuminated
- Rough or unstable idle, especially when warm
- Possible hesitation or stumble immediately off-idle
- Stalling at idle (worst cases)
- Slight reduction in fuel economy
- May be paired with P0171 (general lean Bank 1) if the leak is large
- No drivability issue at cruise
What causes P2187 on a 2012 Honda CR-V?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Vacuum leak (intake gasket, brake-booster hose, PCV, throttle-body gasket) P2187 is essentially "lean at idle = vacuum leak" until proven otherwise. | Most common | $80–$600 |
| Stuck-open EVAP purge valve introducing fuel vapor unmanaged | Common | $80–$300 |
| Cracked plastic intake manifold (Ford 4.6/5.4, Chrysler 4.0, GM 3.6) | Common | $250–$900 |
| Failing PCV valve or hose | Common | $30–$200 |
| Failed or biased Bank 1 upstream O2 sensor | Occasional | $150–$450 |
| Throttle body gasket leak | Occasional | $30–$200 |
| Carbon-coked throttle body letting blade hold slightly open | Occasional | $20–$200 |
How to diagnose this on a 2012 Honda CR-V
-
Compare idle vs cruise fuel trims
Read Bank 1 LTFT at idle and at 2500 RPM cruise. P2187 with LTFT around +20 % at idle but near zero at cruise is the classic vacuum-leak signature. P2187 with high trim at all RPMs is a broader lean condition (likely P0171 alongside).
Tools: Scan tool with live PIDs
-
Smoke-test the intake comprehensively
Pressurize the intake with smoke through the throttle body. Watch every gasket, hose, vacuum tee, the brake booster line, the PCV system, the EVAP purge line, and any unused vacuum ports. The leak path is somewhere in there.
Tools: EVAP / intake smoke machine, Flashlight and mirror
-
Inspect the PCV system
The PCV system is a common P2187 cause — particularly the hose from the valve cover to the intake. Aged rubber cracks and PCV valves stick open. Pull the valve and shake — it should rattle. A non-rattling PCV is finished.
Tools: Common hand tools
-
Disconnect the EVAP purge to test
With the engine warm and idling, disconnect the purge valve. If the rough idle smooths out and LTFT drops, the purge valve was stuck open. P2187 + idle improvement on purge disconnect = purge valve.
Tools: Hose disconnect tools
-
Inspect the brake booster hose
A failing brake booster diaphragm or hose is the single most overlooked P2187 cause. Pull the brake-booster line off and cap the manifold port. If idle smooths out, the booster or its hose is the leak.
Tools: Hose plug or vacuum cap
NHTSA complaints & recalls for the 2012 Honda CR-V
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2012 Honda CR-V. Use these to gauge how common a problem is on your specific vehicle before you start chasing Honda CR-V diagnostics.
- ENGINE 89
- POWER TRAIN 48
- ELECTRICAL SYSTEM 67
- UNKNOWN OR OTHER 51
- STEERING 35
3 active recalls
- EQUIPMENT:OTHER:LABELS Oct 2012
Honda is recalling certain model year 2012 CR-V, equipped with the LX trim level and manufactured from August 30, 2012, to August 31, 2012. These vehicles fail to comply with the requirements of 49 CFR Part 567, "Certification." The incorrect values for Gross Vehicle Weight Rat…
NHTSA campaign 12V501000 - POWER TRAIN:AUTOMATIC TRANSMISSION Apr 2013
Honda is recalling certain model year 2012-2013 CR-V, Odyssey, and model year 2013 Acura RDX vehicles. During sub-freezing temperatures, the brake-shift interlock blocking mechanism may become slow and allow the gear selector to be moved from the Park position without pressing t…
NHTSA campaign 13V143000 - LATCHES/LOCKS/LINKAGES:DOORS:LATCH Jul 2012
Honda is recalling certain model year 2012 Honda CR-V and model year 2013 Acura ILX vehicles. If the manual or power door lock is activated while an interior front door handle is being operated by an occupant, the cable connecting the interior door handle to the door latch mecha…
NHTSA campaign 12V338000
How do I fix P2187 on a 2012 Honda CR-V?
- Repair vacuum leak(s) found by smoke test
- Replace the EVAP purge valve
- Replace cracked plastic intake manifold (model-specific)
- Replace the PCV valve and hose
- Repair brake booster vacuum leak
- Replace the upstream O2 sensor if biased
About the 2010-2014 Honda CR-V
The 2010-2014 Honda CR-V was commonly sold with the following powertrains: 1.5L Turbo I4, 2.4L I4, 2.0L Hybrid I4. Common trims include LX, EX, EX-L, Touring.
Why “lean at idle but not at cruise” points at a vacuum leak
The size of any intake vacuum leak is fixed — say, 5 grams per minute of air. At idle, the engine consumes maybe 15 g/s of air total. The leak represents a big fraction of that total, so fuel trim has to add fuel aggressively to compensate. At cruise the engine consumes 100+ g/s of air; the same leak is now proportionally tiny and trim looks normal.
This is why P2187 specifically (lean at idle) is so reliably a vacuum leak diagnosis — far more so than the broader P0171 which could also be fuel-side problems.
P2187 vs P0171
- P0171 — general system too lean Bank 1. Sets when LTFT runs high across operating conditions. Could be vacuum leak, fuel pressure, MAF, or sensor.
- P2187 — specifically lean at idle. Sets when LTFT runs high at idle but not elsewhere. Strongly points at vacuum leak.
If both codes set together, the vacuum leak is large enough to affect cruise trim too. If only P2187 sets, the leak is small.
Common P2187-prone vehicles
- Ford 4.6 / 5.4 modular V8 — cracked plastic intake manifold
- Chrysler 3.6 Pentastar — intake gasket, PCV system
- GM 3.6 LFX / LLT V6 — PCV diaphragm in valve cover failure
- Honda K-series — IACV gasket, vacuum tee at brake booster
- Toyota 2GR-FE — throttle body gasket
- Most vehicles 10+ years old — hardened brake-booster hose
P2187 on a 2012 Honda CR-V: frequently asked questions
What does diagnostic trouble code P2187 mean on a 2012 Honda CR-V?
P2187 is set when long-term fuel trim on Bank 1 goes excessively positive (typically beyond +20 %) specifically at idle, but stays closer to normal at part-throttle and cruise. The distinctive pattern — lean only at idle — almost always points at a vacuum leak rather than a fueling problem. At idle, intake manifold vacuum is at its highest, which amplifies the effect of any leak; off-idle, the leak path becomes a smaller fraction of total airflow and trims look fine.
What are the symptoms of P2187 on a 2012 Honda CR-V?
Check Engine Light is illuminated. Rough or unstable idle, especially when warm. Possible hesitation or stumble immediately off-idle. Stalling at idle (worst cases). Slight reduction in fuel economy. May be paired with P0171 (general lean Bank 1) if the leak is large. No drivability issue at cruise
What causes P2187 on a 2012 Honda CR-V?
Vacuum leak (intake gasket, brake-booster hose, PCV, throttle-body gasket) (most-common). Stuck-open EVAP purge valve introducing fuel vapor unmanaged (common). Cracked plastic intake manifold (Ford 4.6/5.4, Chrysler 4.0, GM 3.6) (common). Failing PCV valve or hose (common). Failed or biased Bank 1 upstream O2 sensor (occasional). Throttle body gasket leak (occasional). Carbon-coked throttle body letting blade hold slightly open (occasional)
Is it safe to drive a 2012 Honda CR-V with P2187?
In most cases a 2012 Honda CR-V stays drivable for short trips with P2187 active, but it should be diagnosed and repaired promptly — this is a moderate-severity code. Ignoring it can lead to further damage or a failed emissions test.