P0455 on a 2022 Ford Escape

EVAP Large or Gross Leak Detected

P0455 on a 2022 Ford Escape indicates evap large or gross leak detected. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is missing, loose, or wrong-fit fuel cap (typically $0–$60). Confirm the root cause before replacing parts.

Severity: low Safe to drive (short term) Compact SUV 2020-2024 Ford Escape

Reviewed by MECH AI Editorial · Last verified

What does P0455 mean on a 2022 Ford Escape?

P0455 is set when the EVAP system's gross-leak monitor detects an opening approximately 0.090 inches (2.3 mm) or larger — or in many cases, no seal at all. This is the size of a missing gas cap, a disconnected hose, or a failed vent solenoid stuck open. The system cannot hold pressure or vacuum for the calibration period, so the ECM concludes a major leak.

This guide covers P0455 across the 2020-2024 Ford Escape generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2020 through 2024.

Is it safe to drive a 2022 Ford Escape with P0455?

In most cases a 2022 Ford Escape stays drivable for short trips with P0455 active, but diagnose and repair it promptly. This is a low-severity code — ignoring it can lead to further damage or a failed emissions test.

What are the symptoms of P0455 on a 2022 Ford Escape?

What causes P0455 on a 2022 Ford Escape?

Cause Likelihood Estimated repair (USD)
Missing, loose, or wrong-fit fuel cap Always check first. A locking gas cap from another vehicle that almost fits is a common source. Most common $0–$60
Disconnected or split EVAP hose Common $30–$200
EVAP vent valve stuck open (will not seal during the monitor test) Common $80–$350
Damaged or rusted-through fuel filler neck Occasional $200–$700
Cracked or broken EVAP charcoal canister Occasional $200–$600
Damaged O-ring at the fuel pump assembly cover Rare $30–$500
Rodent damage to EVAP hoses (parked vehicles) Occasional $30–$200

How to diagnose this on a 2022 Ford Escape

  1. Check the gas cap is present and correctly seated

    Confirm the cap is the correct OEM cap for the vehicle. Many generic-fit replacement caps look identical but have slightly wrong gasket geometry. Hand-tighten to at least 3 clicks. Some vehicles flag a missing cap as P0455 within one drive cycle.

    Tools: None

  2. Visually inspect the EVAP hoses near the canister

    On most trucks and SUVs the EVAP canister sits behind the rear bumper or above the rear axle. Inspect every hose from the canister to the tank vent and to the purge solenoid. Pay particular attention to rodent damage on parked vehicles.

    Tools: Floor jack and stands, Flashlight

  3. Smoke-test the EVAP system at low pressure

    Introduce smoke at 0.5 psi through the service port. With a large leak the smoke will pour visibly from the failure point within seconds. If smoke escapes from the vent solenoid even with the solenoid commanded closed, replace the solenoid.

    Tools: EVAP smoke machine

  4. Test the EVAP vent valve function

    Disconnect the vent valve and apply 12 V — it should click and close. Hold a hand vacuum pump to one port and verify the valve holds vacuum when energized. A vent valve that does not close fully will set P0455 because the system can never seal.

    Tools: 12 V test source, Hand vacuum pump

  5. Inspect the fuel filler neck and tank-top seals

    Rust-belt vehicles often develop pinholes or seam separation in the metal portion of the fuel filler neck. Once the rust is through, the EVAP system cannot hold any vacuum. Replacement is the only fix.

    Tools: Floor jack and stands, Inspection mirror

NHTSA complaints & recalls for the 2022 Ford Escape

Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2022 Ford Escape. Use these to gauge how common a problem is on your specific vehicle before you start chasing Ford Escape diagnostics.

206 owner complaints
6 involved a crash
4 involved a fire
7 reported injuries
  • FUEL SYSTEM 57
  • GASOLINE 57
  • POWER TRAIN 24
  • ENGINE 24
  • SERVICE BRAKES 33

19 active recalls

  • SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:CALIPER Nov 2021

    Ford Motor Company (Ford) is recalling certain 2021-2022 Bronco Sport and Escape vehicles. The rear brake linings may have been manufactured incorrectly, which can affect braking performance. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle…

    NHTSA campaign 21V922000
  • ELECTRICAL SYSTEM:PROPULSION SYSTEM:TRACTION BATTERY Mar 2022

    Ford Motor Company (Ford) is recalling certain 2022 Corsair and 2021-2022 Escape vehicles equipped with a 2.5L Hybrid powertrain. The high voltage battery may fail, resulting in a sudden loss of drive power.…

    NHTSA campaign 22V149000
  • ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION Mar 2022

    Ford Motor Company (Ford) is recalling certain 2020-2022 Escape and 2021-2022 Bronco Sport vehicles equipped with 1.5L engines. The engine oil separator housing may crack and develop an oil leak.…

    NHTSA campaign 22V191000
  • ENGINE AND ENGINE COOLING Jul 2022

    Ford Motor Company (Ford) is recalling certain 2020-2022 Escape, 2021-2022 Lincoln Corsair, and 2022 Maverick vehicles equipped with 2.5L HEV or PHEV engines. In the event of an engine failure, engine oil and fuel vapor may be released into the engine compartment and accumulate…

    NHTSA campaign 22V484000

How do I fix P0455 on a 2022 Ford Escape?

About the 2020-2024 Ford Escape

The 2020-2024 Ford Escape was commonly sold with the following powertrains: 1.5L EcoBoost I3, 2.0L EcoBoost I4, 2.5L Hybrid I4. Common trims include S, SE, SEL, Titanium.

How fast P0455 sets after a missing cap

Most OBD-II vehicles flag P0455 within one cold-start drive cycle after the cap is left off. Some Ford and GM vehicles will set a more specific “check fuel cap” message first and only escalate to P0455 if the issue persists across multiple drive cycles.

P0455 right after winter on a parked vehicle

Mice and rats chew EVAP hoses to nest inside the canister or near the fuel tank. If P0455 appears on a vehicle that has been parked for the winter, inspect every accessible EVAP hose for clean-edged bite marks before buying parts. This pattern is so common on rural-parked trucks that several shop forums have dedicated threads.

The cap that “fits” but doesn’t seal

A locking gas cap from a similar-vintage vehicle in the same brand family often threads on but seals against the filler neck at the wrong depth or angle. The result is repeated P0455 codes after every refuel. If the cap has been replaced and the code persists, double-check it is the exact OEM part number for this vehicle.

P0455 on a 2022 Ford Escape: frequently asked questions

What does diagnostic trouble code P0455 mean on a 2022 Ford Escape?

P0455 is set when the EVAP system's gross-leak monitor detects an opening approximately 0.090 inches (2.3 mm) or larger — or in many cases, no seal at all. This is the size of a missing gas cap, a disconnected hose, or a failed vent solenoid stuck open. The system cannot hold pressure or vacuum for the calibration period, so the ECM concludes a major leak.

What are the symptoms of P0455 on a 2022 Ford Escape?

Check Engine Light is illuminated. Distinct fuel smell, especially after refueling. Fuel-cap warning message on the dashboard on some vehicles. No drivability issue. Vehicle will fail emissions / smog testing

What causes P0455 on a 2022 Ford Escape?

Missing, loose, or wrong-fit fuel cap (most-common). Disconnected or split EVAP hose (common). EVAP vent valve stuck open (will not seal during the monitor test) (common). Damaged or rusted-through fuel filler neck (occasional). Cracked or broken EVAP charcoal canister (occasional). Damaged O-ring at the fuel pump assembly cover (rare). Rodent damage to EVAP hoses (parked vehicles) (occasional)

Is it safe to drive a 2022 Ford Escape with P0455?

In most cases a 2022 Ford Escape stays drivable for short trips with P0455 active, but it should be diagnosed and repaired promptly — this is a low-severity code. Ignoring it can lead to further damage or a failed emissions test.

Related diagnostic codes

P0455 on other Ford Escape model years