P0455 on a 2017 Hyundai Santa Fe

EVAP Large or Gross Leak Detected

P0455 on a 2017 Hyundai Santa Fe indicates evap large or gross leak detected. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is missing, loose, or wrong-fit fuel cap (typically $0–$60). Confirm the root cause before replacing parts.

Severity: low Safe to drive (short term) Mid-size SUV 2015-2019 Hyundai Santa Fe

Reviewed by MECH AI Editorial · Last verified

What does P0455 mean on a 2017 Hyundai Santa Fe?

P0455 is set when the EVAP system's gross-leak monitor detects an opening approximately 0.090 inches (2.3 mm) or larger — or in many cases, no seal at all. This is the size of a missing gas cap, a disconnected hose, or a failed vent solenoid stuck open. The system cannot hold pressure or vacuum for the calibration period, so the ECM concludes a major leak.

This guide covers P0455 across the 2015-2019 Hyundai Santa Fe generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2015 through 2019.

Is it safe to drive a 2017 Hyundai Santa Fe with P0455?

In most cases a 2017 Hyundai Santa Fe stays drivable for short trips with P0455 active, but diagnose and repair it promptly. This is a low-severity code — ignoring it can lead to further damage or a failed emissions test.

What are the symptoms of P0455 on a 2017 Hyundai Santa Fe?

What causes P0455 on a 2017 Hyundai Santa Fe?

Cause Likelihood Estimated repair (USD)
Missing, loose, or wrong-fit fuel cap Always check first. A locking gas cap from another vehicle that almost fits is a common source. Most common $0–$60
Disconnected or split EVAP hose Common $30–$200
EVAP vent valve stuck open (will not seal during the monitor test) Common $80–$350
Damaged or rusted-through fuel filler neck Occasional $200–$700
Cracked or broken EVAP charcoal canister Occasional $200–$600
Damaged O-ring at the fuel pump assembly cover Rare $30–$500
Rodent damage to EVAP hoses (parked vehicles) Occasional $30–$200

How to diagnose this on a 2017 Hyundai Santa Fe

  1. Check the gas cap is present and correctly seated

    Confirm the cap is the correct OEM cap for the vehicle. Many generic-fit replacement caps look identical but have slightly wrong gasket geometry. Hand-tighten to at least 3 clicks. Some vehicles flag a missing cap as P0455 within one drive cycle.

    Tools: None

  2. Visually inspect the EVAP hoses near the canister

    On most trucks and SUVs the EVAP canister sits behind the rear bumper or above the rear axle. Inspect every hose from the canister to the tank vent and to the purge solenoid. Pay particular attention to rodent damage on parked vehicles.

    Tools: Floor jack and stands, Flashlight

  3. Smoke-test the EVAP system at low pressure

    Introduce smoke at 0.5 psi through the service port. With a large leak the smoke will pour visibly from the failure point within seconds. If smoke escapes from the vent solenoid even with the solenoid commanded closed, replace the solenoid.

    Tools: EVAP smoke machine

  4. Test the EVAP vent valve function

    Disconnect the vent valve and apply 12 V — it should click and close. Hold a hand vacuum pump to one port and verify the valve holds vacuum when energized. A vent valve that does not close fully will set P0455 because the system can never seal.

    Tools: 12 V test source, Hand vacuum pump

  5. Inspect the fuel filler neck and tank-top seals

    Rust-belt vehicles often develop pinholes or seam separation in the metal portion of the fuel filler neck. Once the rust is through, the EVAP system cannot hold any vacuum. Replacement is the only fix.

    Tools: Floor jack and stands, Inspection mirror

NHTSA complaints & recalls for the 2017 Hyundai Santa Fe

Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2017 Hyundai Santa Fe. Use these to gauge how common a problem is on your specific vehicle before you start chasing Hyundai Santa Fe diagnostics.

923 owner complaints
14 involved a crash
23 involved a fire
18 reported injuries
  • ENGINE 618
  • POWER TRAIN 149
  • UNKNOWN OR OTHER 83
  • ELECTRICAL SYSTEM 64
  • SERVICE BRAKES 59

6 active recalls

  • TIRES:PRESSURE MONITORING AND REGULATING SYSTEMS Mar 2017

    Hyundai Motor America (Hyundai) is recalling certain 2017 Santa Fe Sport vehicles. The affected vehicles have a tire pressure monitoring system (TPMS) that may not have been set in the correct mode during vehicle assembly, and therefore will not provide an appropriate warning in…

    NHTSA campaign 17V142000
  • LATCHES/LOCKS/LINKAGES:HOOD:LATCH Jun 2017

    Hyundai Motor America (Hyundai) is recalling certain 2013-2017 Santa Fe and Santa Fe Sport vehicles. In the affected vehicles, the secondary hood latch actuating cable may corrode and bind, causing the secondary hood latch to remain in the unlatched position when the hood is clo…

    NHTSA campaign 17V358000
  • ENGINE AND ENGINE COOLING:ENGINE Sep 2017

    Hyundai Motor America (Hyundai) is recalling certain 2017 Santa Fe vehicles equipped with 3.3L engines. The crankshaft assemblies may have been produced with surface irregularities in the crankshaft pin, causing engine bearing wear.…

    NHTSA campaign 17V578000
  • ELECTRICAL SYSTEM:WIRING Nov 2016

    Hyundai Motor America (Hyundai) is recalling certain model year 2016-2017 Tucson vehicles manufactured May 19, 2015, to November 14, 2016, and 2017 Santa Fe vehicles manufactured November 28, 2015, to November 14, 2016. The affected vehicles may be equipped with an accessory tra…

    NHTSA campaign 16V842000

How do I fix P0455 on a 2017 Hyundai Santa Fe?

About the 2015-2019 Hyundai Santa Fe

The 2015-2019 Hyundai Santa Fe was commonly sold with the following powertrains: 2.5L I4, 2.5L Turbo I4, 1.6L Hybrid I4. Common trims include SE, SEL, XRT, Limited, Calligraphy.

How fast P0455 sets after a missing cap

Most OBD-II vehicles flag P0455 within one cold-start drive cycle after the cap is left off. Some Ford and GM vehicles will set a more specific “check fuel cap” message first and only escalate to P0455 if the issue persists across multiple drive cycles.

P0455 right after winter on a parked vehicle

Mice and rats chew EVAP hoses to nest inside the canister or near the fuel tank. If P0455 appears on a vehicle that has been parked for the winter, inspect every accessible EVAP hose for clean-edged bite marks before buying parts. This pattern is so common on rural-parked trucks that several shop forums have dedicated threads.

The cap that “fits” but doesn’t seal

A locking gas cap from a similar-vintage vehicle in the same brand family often threads on but seals against the filler neck at the wrong depth or angle. The result is repeated P0455 codes after every refuel. If the cap has been replaced and the code persists, double-check it is the exact OEM part number for this vehicle.

Related diagnostic codes