P0455 on a 2012 Toyota Corolla

EVAP Large or Gross Leak Detected

P0455 on a 2012 Toyota Corolla indicates evap large or gross leak detected. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is missing, loose, or wrong-fit fuel cap (typically $0–$60). Confirm the root cause before replacing parts.

Severity: low Safe to drive (short term) Compact Sedan 2010-2014 Toyota Corolla

Reviewed by MECH AI Editorial · Last verified

What does P0455 mean on a 2012 Toyota Corolla?

P0455 is set when the EVAP system's gross-leak monitor detects an opening approximately 0.090 inches (2.3 mm) or larger — or in many cases, no seal at all. This is the size of a missing gas cap, a disconnected hose, or a failed vent solenoid stuck open. The system cannot hold pressure or vacuum for the calibration period, so the ECM concludes a major leak.

This guide covers P0455 across the 2010-2014 Toyota Corolla generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2010 through 2014.

Is it safe to drive a 2012 Toyota Corolla with P0455?

In most cases a 2012 Toyota Corolla stays drivable for short trips with P0455 active, but diagnose and repair it promptly. This is a low-severity code — ignoring it can lead to further damage or a failed emissions test.

What are the symptoms of P0455 on a 2012 Toyota Corolla?

What causes P0455 on a 2012 Toyota Corolla?

Cause Likelihood Estimated repair (USD)
Missing, loose, or wrong-fit fuel cap Always check first. A locking gas cap from another vehicle that almost fits is a common source. Most common $0–$60
Disconnected or split EVAP hose Common $30–$200
EVAP vent valve stuck open (will not seal during the monitor test) Common $80–$350
Damaged or rusted-through fuel filler neck Occasional $200–$700
Cracked or broken EVAP charcoal canister Occasional $200–$600
Damaged O-ring at the fuel pump assembly cover Rare $30–$500
Rodent damage to EVAP hoses (parked vehicles) Occasional $30–$200

How to diagnose this on a 2012 Toyota Corolla

  1. Check the gas cap is present and correctly seated

    Confirm the cap is the correct OEM cap for the vehicle. Many generic-fit replacement caps look identical but have slightly wrong gasket geometry. Hand-tighten to at least 3 clicks. Some vehicles flag a missing cap as P0455 within one drive cycle.

    Tools: None

  2. Visually inspect the EVAP hoses near the canister

    On most trucks and SUVs the EVAP canister sits behind the rear bumper or above the rear axle. Inspect every hose from the canister to the tank vent and to the purge solenoid. Pay particular attention to rodent damage on parked vehicles.

    Tools: Floor jack and stands, Flashlight

  3. Smoke-test the EVAP system at low pressure

    Introduce smoke at 0.5 psi through the service port. With a large leak the smoke will pour visibly from the failure point within seconds. If smoke escapes from the vent solenoid even with the solenoid commanded closed, replace the solenoid.

    Tools: EVAP smoke machine

  4. Test the EVAP vent valve function

    Disconnect the vent valve and apply 12 V — it should click and close. Hold a hand vacuum pump to one port and verify the valve holds vacuum when energized. A vent valve that does not close fully will set P0455 because the system can never seal.

    Tools: 12 V test source, Hand vacuum pump

  5. Inspect the fuel filler neck and tank-top seals

    Rust-belt vehicles often develop pinholes or seam separation in the metal portion of the fuel filler neck. Once the rust is through, the EVAP system cannot hold any vacuum. Replacement is the only fix.

    Tools: Floor jack and stands, Inspection mirror

NHTSA complaints & recalls for the 2012 Toyota Corolla

Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2012 Toyota Corolla. Use these to gauge how common a problem is on your specific vehicle before you start chasing Toyota Corolla diagnostics.

445 owner complaints
41 involved a crash
1 involved a fire
28 reported injuries
  • VEHICLE SPEED CONTROL 16
  • AIR BAGS 370
  • STEERING 18
  • STRUCTURE 14
  • ELECTRICAL SYSTEM 13

5 active recalls

  • AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE Jan 2019

    Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2014-2016 Toyota 4Runner, 2014-2015 Scion xB, Lexus IS350C, IS250C, 2014 Toyota Sienna, Lexus IS-F, and 2014-2017 Lexus GX460 vehicles sold, or ever registered in the states of Alabama, California, Florida, Ge…

    NHTSA campaign 19V005000
  • AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE Oct 2019

    Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2010-2016 4Runner, 2003-2006 Tundra, 2003-2013 Corolla, 2009-2010 Corolla Matrix, 2004-2005 RAV4, 2002-2007 Sequoia, 2011-2013 Sienna, 2008-2012 Scion xB, 2008-2009 Lexus IS-F, 2007-2012 Yaris and Lexus ES350,…

    NHTSA campaign 19V741000
  • AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE Jan 2017

    Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2012 Toyota 4Runner, Corolla, Corolla Matrix, Sienna, Yaris, Scion xB, Lexus ES350, GX460, IS-F, IS250, IS350, IS250C, IS350C, and Lexus LFA vehicles originally sold, or ever registered, in Alabama, California…

    NHTSA campaign 17V006000
  • AIR BAGS:FRONTAL:SENSOR/CONTROL MODULE-INACTIVE Jan 2013

    Southeast Toyota Distributors, LLC (SET) is recalling certain models interspersed through model years 2009 through 2013 as follows: model year 2009-2012 Tacoma, 4Runner, Camry, Camry Hybrid, Prius, and RAV4; model year 2009-2010 Avalon, FJ Cruiser, and Highlander Hybrid; model ye…

    NHTSA campaign 13V014000

How do I fix P0455 on a 2012 Toyota Corolla?

About the 2010-2014 Toyota Corolla

The 2010-2014 Toyota Corolla was commonly sold with the following powertrains: 1.8L I4, 2.0L I4, 1.8L Hybrid I4. Common trims include L, LE, SE, XLE, XSE.

How fast P0455 sets after a missing cap

Most OBD-II vehicles flag P0455 within one cold-start drive cycle after the cap is left off. Some Ford and GM vehicles will set a more specific “check fuel cap” message first and only escalate to P0455 if the issue persists across multiple drive cycles.

P0455 right after winter on a parked vehicle

Mice and rats chew EVAP hoses to nest inside the canister or near the fuel tank. If P0455 appears on a vehicle that has been parked for the winter, inspect every accessible EVAP hose for clean-edged bite marks before buying parts. This pattern is so common on rural-parked trucks that several shop forums have dedicated threads.

The cap that “fits” but doesn’t seal

A locking gas cap from a similar-vintage vehicle in the same brand family often threads on but seals against the filler neck at the wrong depth or angle. The result is repeated P0455 codes after every refuel. If the cap has been replaced and the code persists, double-check it is the exact OEM part number for this vehicle.

P0455 on a 2012 Toyota Corolla: frequently asked questions

What does diagnostic trouble code P0455 mean on a 2012 Toyota Corolla?

P0455 is set when the EVAP system's gross-leak monitor detects an opening approximately 0.090 inches (2.3 mm) or larger — or in many cases, no seal at all. This is the size of a missing gas cap, a disconnected hose, or a failed vent solenoid stuck open. The system cannot hold pressure or vacuum for the calibration period, so the ECM concludes a major leak.

What are the symptoms of P0455 on a 2012 Toyota Corolla?

Check Engine Light is illuminated. Distinct fuel smell, especially after refueling. Fuel-cap warning message on the dashboard on some vehicles. No drivability issue. Vehicle will fail emissions / smog testing

What causes P0455 on a 2012 Toyota Corolla?

Missing, loose, or wrong-fit fuel cap (most-common). Disconnected or split EVAP hose (common). EVAP vent valve stuck open (will not seal during the monitor test) (common). Damaged or rusted-through fuel filler neck (occasional). Cracked or broken EVAP charcoal canister (occasional). Damaged O-ring at the fuel pump assembly cover (rare). Rodent damage to EVAP hoses (parked vehicles) (occasional)

Is it safe to drive a 2012 Toyota Corolla with P0455?

In most cases a 2012 Toyota Corolla stays drivable for short trips with P0455 active, but it should be diagnosed and repaired promptly — this is a low-severity code. Ignoring it can lead to further damage or a failed emissions test.

Related diagnostic codes

P0455 on other Toyota Corolla model years