P0446 on a 2017 Ford Mustang
EVAP Vent Control Circuit Fault
P0446 on a 2017 Ford Mustang indicates evap vent control circuit fault. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is failed evap vent valve / vent solenoid (mechanical sticking) (typically $80–$350). Confirm the root cause before replacing parts.
What does P0446 mean on a 2017 Ford Mustang?
P0446 is set when the engine control module detects that the EVAP vent valve circuit is not behaving as commanded. The vent valve is the normally-open solenoid that lets the charcoal canister breathe — and closes during the EVAP leak test to seal the system. P0446 typically means the vent valve is stuck (mechanically or electrically) so that the system can never seal properly for the leak test.
This guide covers P0446 across the 2015-2019 Ford Mustang generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2015 through 2019.
Is it safe to drive a 2017 Ford Mustang with P0446?
In most cases a 2017 Ford Mustang stays drivable for short trips with P0446 active, but diagnose and repair it promptly. This is a low-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0446 on a 2017 Ford Mustang?
- Check Engine Light is illuminated
- Difficulty filling the fuel tank (pump clicks off repeatedly)
- No other drivability problems
- Vehicle will fail emissions / smog testing
- Sometimes accompanied by P0455 (large leak) on the same scan
What causes P0446 on a 2017 Ford Mustang?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Failed EVAP vent valve / vent solenoid (mechanical sticking) | Most common | $80–$350 |
| Dirt, debris, or spider webs clogging the vent valve filter Common on trucks and SUVs with the canister mounted under the vehicle. | Common | $20–$100 |
| Damaged wiring or connector at the vent valve | Common | $50–$250 |
| Failed PCM driver circuit for the vent valve (rare) | Rare | $400–$1,500 |
| Cracked or saturated EVAP charcoal canister | Occasional | $200–$600 |
How to diagnose this on a 2017 Ford Mustang
-
Locate the vent valve on this vehicle
The vent valve is mounted on or next to the charcoal canister. On most modern trucks and SUVs that is behind the rear bumper or near the fuel tank. On many cars it sits in the engine compartment. Consult the service manual for the exact location.
Tools: Vehicle-specific service information
-
Test the vent valve electrically
Disconnect the valve connector. With the key on, check for battery voltage on the power side. Apply 12 V across the solenoid terminals directly — you should hear and feel it click. A solenoid that does not click is dead and needs replacement.
Tools: Multimeter, Test leads / jumper wires
-
Test the vent valve mechanically
Disconnect the hose at the vent valve. Connect a hand vacuum pump. With the solenoid de-energized, the valve should let air flow freely (no vacuum holds). With 12 V applied, the valve should hold vacuum. A valve that holds vacuum at rest, or that leaks vacuum when commanded closed, is the problem.
Tools: Hand vacuum pump, 12 V test source
-
Inspect for contamination
Trucks and SUVs frequently get spider webs, mud, or sand inside the vent valve filter on the canister side. Some vehicles have a dust filter that is replaceable; others integrate it into the valve assembly. Clean or replace as needed.
Tools: Compressed air, Replacement filter (if applicable)
-
Confirm the canister itself is intact
With the vent valve removed, look into the canister port for cracked plastic, saturated charcoal (will smell strongly of fuel), or debris. A failed canister will cause repeated P0446 set events even after the vent valve is replaced.
Tools: Flashlight
Known Technical Service Bulletins for the 2015-2019 Ford Mustang
Manufacturers publish Technical Service Bulletins (TSBs) when a known issue affects a specific vehicle. These bulletins come from the NHTSA database for your Ford Mustang.
- UNKNOWN OR OTHER Feb 23, 2026
Ford and Lincoln vehicles equipped with wired keyless entry keypad systems and accessory wireless keyless entry keypad systems may or may not come with a wallet card containing the master code. Unlike the integrated wired keypad, the accessory wireless keypad master code cannot be retrieved from the vehicle using a diagnostic scan tool or from the label printed on the body control module (BCM). The Factory Keyless Entry Code application within the diagnostic scan tool will not provide an applicable master code for the accessory wireless keypad. If the wallet card for an accessory keypad is not available, the "Wireless RF Keypad Diagnosis Guide" can be referenced and provides direction on how to retrieve the master code. This guide is located under the Workshop Manual tab > Accessories > Installation > Wireless RF Keypad Diagnosis Guide > PPT C > Step C2.<br /><br /> Note: The only available keypad for some vehicles from the assembly plant is the accessory wireless keyless entry keypad. The integrated wired keypad cannot be installed on vehicles not equipped from the factory with a wired keyless entry k
NHTSA #11029052 - ELECTRICAL SYSTEM Feb 23, 2026
Ford and Lincoln vehicles equipped with wired keyless entry keypad systems and accessory wireless keyless entry keypad systems may or may not come with a wallet card containing the master code. Unlike the integrated wired keypad, the accessory wireless keypad master code cannot be retrieved from the vehicle using a diagnostic scan tool or from the label printed on the body control module (BCM). The Factory Keyless Entry Code application within the diagnostic scan tool will not provide an applicable master code for the accessory wireless keypad. If the wallet card for an accessory keypad is not available, the "Wireless RF Keypad Diagnosis Guide" can be referenced and provides direction on how to retrieve the master code. This guide is located under the Workshop Manual tab > Accessories > Installation > Wireless RF Keypad Diagnosis Guide > PPT C > Step C2.<br /><br /> Note: The only available keypad for some vehicles from the assembly plant is the accessory wireless keyless entry keypad. The integrated wired keypad cannot be installed on vehicles not equipped from the factory with a wired keyless entry k
NHTSA #11029052 - STRUCTURE Feb 23, 2026
Ford and Lincoln vehicles equipped with wired keyless entry keypad systems and accessory wireless keyless entry keypad systems may or may not come with a wallet card containing the master code. Unlike the integrated wired keypad, the accessory wireless keypad master code cannot be retrieved from the vehicle using a diagnostic scan tool or from the label printed on the body control module (BCM). The Factory Keyless Entry Code application within the diagnostic scan tool will not provide an applicable master code for the accessory wireless keypad. If the wallet card for an accessory keypad is not available, the "Wireless RF Keypad Diagnosis Guide" can be referenced and provides direction on how to retrieve the master code. This guide is located under the Workshop Manual tab > Accessories > Installation > Wireless RF Keypad Diagnosis Guide > PPT C > Step C2.<br /><br /> Note: The only available keypad for some vehicles from the assembly plant is the accessory wireless keyless entry keypad. The integrated wired keypad cannot be installed on vehicles not equipped from the factory with a wired keyless entry k
NHTSA #11029052 - VISIBILITY/WIPER Jan 5, 2026
Certain 2015-2019 Model Year Multiple Vehicle Lines Rear View Camera Inspection For One-Time Replacemen
NHTSA #11027801 - VISIBILITY/WIPER Dec 22, 2025
Certain 2015-2019 Model Year Multiple Vehicle Lines Rear View Camera Inspection For One-Time Replacement
NHTSA #11026915 - UNKNOWN OR OTHER Dec 22, 2025
Certain 2015-2019 Model Year Multiple Vehicle Lines Rear View Camera Inspection For One-Time Replacement
NHTSA #11026915
+14 more TSBs available in MECH AI's TSB explorer for this vehicle.
NHTSA complaints & recalls for the 2017 Ford Mustang
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2017 Ford Mustang. Use these to gauge how common a problem is on your specific vehicle before you start chasing Ford Mustang diagnostics.
- ENGINE 26
- BACK OVER PREVENTION 62
- UNKNOWN OR OTHER 36
- STRUCTURE 36
- ELECTRICAL SYSTEM 31
6 active recalls
- ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSES/LINES/PIPING/FITTINGS Oct 2016
Ford Motor Company (Ford) is recalling certain model year 2015-2017 Mustang vehicles manufactured February 24, 2015, to August 30, 2016. A hose may separate from the engine oil cooler tube assembly causing an oil leak.…
NHTSA campaign 16V779000 - AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE Aug 2017
Ford Motor Company (Ford) is recalling certain 2017 F-150 and Mustang vehicles. The air bag inflator within the passenger frontal air bag module may rupture in the event of a crash.…
NHTSA campaign 17V529000 - LATCHES/LOCKS/LINKAGES:DOORS:LATCH Mar 2017
Ford Motor Company (Ford) is recalling certain 2017 Ford Mustang vehicles. The return spring for the driver side interior door handle may come loose, allowing the driver's door to unlatch in a side impact crash. As such, these vehicles fail to comply with the requirements of Fe…
NHTSA campaign 17V168000 - BACK OVER PREVENTION: SENSING SYSTEM: CAMERA Feb 2022
Ford Motor Company (Ford) is recalling certain 2015-2017 Mustang vehicles. The rearview camera wiring may be loose or damaged, which can result in a blank or distorted image.…
NHTSA campaign 22V082000
How do I fix P0446 on a 2017 Ford Mustang?
- Replace the EVAP vent valve / vent solenoid
- Clean the vent valve filter and inspection port
- Repair damaged wiring or connector at the vent valve
- Replace the charcoal canister assembly
About the 2015-2019 Ford Mustang
The 2015-2019 Ford Mustang was commonly sold with the following powertrains: 2.3L EcoBoost I4, 5.0L V8, 5.2L V8. Common trims include EcoBoost, GT, Mach 1, Shelby GT500, Dark Horse.
Why the gas pump clicks off with P0446
The vent valve is what allows the fuel tank to “breathe” during refueling. If the valve is stuck closed, displaced air cannot escape as fuel goes in — pressure builds, fuel splashes back into the filler neck, and the pump nozzle’s auto-shutoff triggers prematurely. If you have to “trickle fill” your tank to get gas in, P0446 (or a related vent code) is the most likely cause.
When P0446 sets with P0455
If P0446 (vent control) sets alongside P0455 (large leak), the root cause is usually one part — the vent valve is stuck open, so the system can never seal for the leak test, which triggers both codes. Replace the vent valve and clear codes; if P0455 returns alone the next monitor run, do a separate small-leak diagnosis.
Trucks and SUVs vs. cars
Under-vehicle mounted vent valves (most trucks, SUVs, and minivans) fail more often than engine-bay mounted ones. They live in a worse environment — road spray, salt, mud, debris. On vehicles with chronic P0446, an upgraded “all-terrain” vent valve or a relocation kit is sometimes worth considering after the second failure.