P0172 on a 2022 Toyota Sienna
Fuel System Too Rich (Bank 1)
P0172 on a 2022 Toyota Sienna indicates fuel system too rich (bank 1). It usually stays drivable short-term but should be diagnosed promptly. The most common cause is leaking or stuck-open fuel injector(s) on bank 1 (typically $150–$1,200). Confirm the root cause before replacing parts.
What does P0172 mean on a 2022 Toyota Sienna?
P0172 is set when the engine control module detects that long-term fuel trim on Bank 1 has been driven beyond approximately −25 % — the ECM is pulling out the maximum amount of fuel it is allowed to remove, and the oxygen sensor still reports a rich mixture. The cause is something delivering excess fuel or restricting air, or a sensor reporting a false rich signal.
This guide covers P0172 across the 2020-2024 Toyota Sienna generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2020 through 2024.
Is it safe to drive a 2022 Toyota Sienna with P0172?
In most cases a 2022 Toyota Sienna stays drivable for short trips with P0172 active, but diagnose and repair it promptly. This is a moderate-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0172 on a 2022 Toyota Sienna?
- Check Engine Light is illuminated
- Strong fuel smell from the exhaust
- Black smoke from the tailpipe under acceleration
- Poor fuel economy (sometimes severely worse — 30 %+ drop)
- Rough idle and hard starting (flooded condition)
- Fouled spark plugs from rich-running conditions
- Eventual catalytic converter damage (P0420 follows)
What causes P0172 on a 2022 Toyota Sienna?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Leaking or stuck-open fuel injector(s) on Bank 1 Drip-test individual injectors to find the leaker. | Most common | $150–$1,200 |
| Failed fuel pressure regulator allowing too much fuel | Common | $100–$400 |
| Restricted or dirty air filter / clogged intake | Common | $20–$80 |
| Failed MAF sensor over-reporting airflow | Common | $30–$350 |
| Stuck-closed EVAP purge valve (purge solenoid leaking fuel vapor) | Occasional | $80–$300 |
| Leaking fuel pressure regulator vacuum hose pulling fuel into the intake | Occasional | $20–$150 |
| Failed upstream O2 sensor biased rich | Occasional | $150–$450 |
| Engine oil contaminated with fuel (overdue oil change after rich running) | Rare | $80–$200 |
How to diagnose this on a 2022 Toyota Sienna
-
Read fuel trims at idle and 2500 RPM
A scan tool will show short-term (STFT) and long-term (LTFT) fuel trim. If LTFT is around −20 % or worse at all RPMs, the system is truly rich. If trims look normal at the scan tool, the issue may have been intermittent — pull freeze-frame data to see conditions when P0172 set.
Tools: Scan tool with live PIDs
-
Inspect the air filter and intake tract
A heavily clogged air filter restricts airflow enough to push the mixture rich. Check the filter, the intake snorkel, and the throttle body for restrictions, soot buildup, or debris.
Tools: Common hand tools, Flashlight
-
Check for fuel in the FPR vacuum hose
With the engine off, remove the vacuum hose from the fuel pressure regulator. Fuel inside the hose means the regulator diaphragm is ruptured and fuel is being drawn directly into the intake. Replace the regulator.
Tools: None
-
Test injector spray pattern and balance
Use an injector test set, or measure fuel rail pressure drop while pulsing each injector individually with a scan tool. An injector that drops pressure significantly faster than its peers is leaking or flowing too much.
Tools: Scan tool with injector balance test, Fuel pressure gauge
-
Verify MAF sensor airflow reading
A healthy MAF reads approximately 1 g/s per liter of displacement at idle (for example, ~3 g/s at idle on a 3.0-liter engine). Readings 30 %+ above that suggest the MAF is over-reporting airflow, which drives the ECM to add fuel.
Tools: Scan tool with MAF PID
NHTSA complaints & recalls for the 2022 Toyota Sienna
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2022 Toyota Sienna. Use these to gauge how common a problem is on your specific vehicle before you start chasing Toyota Sienna diagnostics.
3 active recalls
- SEAT BELTS:REAR/OTHER:ANCHORAGE Nov 2021
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2022 Sienna vehicles equipped with seating for eight passengers. An incorrect seat belt webbing guide may have been installed on the outboard second-row seat belt assemblies.…
NHTSA campaign 21V889000 - ELECTRONIC STABILITY CONTROL (ESC):CONTROL MODULE:SOFTWARE Apr 2022
Toyota Engineering & Manufacturing (Toyota) is recalling certain 2022 Lexus LX 600, Lexus NX 350h, Lexus NX 450h+, Toytoa RAV4 Hybrid, 2021-2022 Lexus LS 500h, Toyota Mirai, RAV4 PRIME, Sienna, Venza, and 2020-2022 Toyota Highlander Hybrid vehicles. The Skid Control ECU software…
NHTSA campaign 22V239000 - EQUIPMENT ADAPTIVE/MOBILITY:WHEELCHAIR RESTRAINTS/SECUREMENT:LATCH/ANCHOR: Dec 2025
Vantage Mobility, LLC (VM) is recalling certain 2021-2026 Honda Odyssey, 2021-2025 Chrysler Pacifica, and Toyota Sienna vehicles equipped with QRT-Deluxe and QRT-Max wheelchair restraints. The retractors may not lock, preventing the wheelchair from being properly secured.…
NHTSA campaign 25V877000
How do I fix P0172 on a 2022 Toyota Sienna?
- Replace leaking or over-flowing fuel injector(s)
- Replace the fuel pressure regulator
- Replace the air filter and clean the intake
- Clean or replace the MAF sensor
- Replace the EVAP purge valve
- Change engine oil if fuel-diluted
About the 2020-2024 Toyota Sienna
The 2020-2024 Toyota Sienna was commonly sold with the following powertrains: 3.5L V6, 2.5L Hybrid I4. Common trims include LE, XLE, XSE, Limited, Platinum.
How P0172 destroys catalytic converters
Sustained rich operation washes fuel past the rings into the oil, fouls spark plugs, and — worst of all — dumps unburned hydrocarbons into the exhaust. The catalytic converter tries to oxidize that fuel and overheats. Within weeks of driving with P0172 uncorrected, the catalyst can melt internally and set P0420 alongside. At that point you have two repair bills instead of one.
Rich condition vs. flooded engine
P0172 is a steady-state rich condition. A flooded engine — won’t crank, or cranks but won’t fire after a cold start — is a different problem (usually a leaking injector or bad cold-start enrichment logic). Both can set P0172, but flooding is more often acute and visible immediately at the key turn.
When the MAF is reading too high
A MAF that over-reports airflow makes the ECM think more air is entering than really is, so it adds extra fuel to match. This is one of the few P0172 causes that does not involve excess fuel — the fuel system is working correctly, the sensor is lying. MAF cleaning and unmetered-air inspections come before MAF replacement.