P0171 on a 2022 Toyota Camry
Fuel System Too Lean (Bank 1)
What does P0171 mean on a 2022 Toyota Camry?
P0171 is set when the engine control module detects that long-term fuel trim on Bank 1 has been pushed beyond approximately +25 % to compensate for what it interprets as a lean air-fuel mixture. In other words, the ECM is adding the maximum amount of fuel it is allowed to, and the oxygen sensors still report a lean condition. The cause is almost always either unmetered air entering the engine, a fuel delivery problem, or a sensor reporting bad data.
Symptoms on a 2022 Toyota Camry
- Check Engine Light is illuminated
- Rough or unstable idle, especially when cold
- Hesitation, stumble, or stall when accelerating from a stop
- Reduced fuel economy
- Mild loss of power
- Whistling or hissing sound from the intake area (vacuum leak)
Likely causes on a 2022 Toyota Camry
- Vacuum leak (intake manifold gasket, PCV hose, intake boot, brake booster hose) Most commonEstimated repair: $80– $600
The single most common P0171 cause across all makes.
- Dirty or failing mass airflow (MAF) sensor Most commonEstimated repair: $30– $350
Cleaning with MAF-safe spray solves a large fraction of cases.
- Weak fuel pump or clogged fuel filter (low fuel pressure) CommonEstimated repair: $80– $900
- Failing fuel pressure regulator OccasionalEstimated repair: $100– $400
- Clogged or leaking fuel injectors on Bank 1 OccasionalEstimated repair: $150– $1,200
- Faulty oxygen sensor reporting false lean OccasionalEstimated repair: $150– $450
- Exhaust leak upstream of the front O2 sensor OccasionalEstimated repair: $100– $500
How to diagnose this on a 2022 Toyota Camry
-
Read fuel trims and short-term/long-term values
Connect a scan tool capable of live data. Compare short-term (STFT) and long-term (LTFT) fuel trims at idle and at 2500 RPM. If LTFT is +15 % or higher at idle but drops near zero at 2500 RPM, suspect a vacuum leak. If LTFT is high at all RPMs, suspect fuel delivery or MAF.
Tools: Bidirectional scan tool with live PIDs
-
Smoke-test the intake for vacuum leaks
Cap the intake and introduce low-pressure smoke into the manifold. Watch for smoke escaping at intake gaskets, the PCV system, the brake booster hose, vacuum tees, and the throttle body base. Cracked plastic intake manifolds are common on many Ford, Chrysler, and Nissan engines.
Tools: Smoke machine, Inspection mirror, Flashlight
-
Inspect and clean the MAF sensor
Remove the MAF sensor and spray the sensing elements with MAF-safe electronics cleaner. Reinstall, clear the code, and drive. If P0171 returns within a few drive cycles with high LTFT at cruise, the MAF may need replacement.
Tools: MAF-safe cleaner, Trim panel tools
-
Measure fuel pressure key-on-engine-off and at idle
Attach a fuel pressure gauge to the fuel rail Schrader port (or use a banjo adapter on returnless systems). Compare to the OEM specification for the vehicle — most port-injected systems run 45–60 psi at idle. Pressure that drops more than 5 psi under load points to a weak pump or regulator.
Tools: Fuel pressure gauge, Vehicle-specific service data
-
Compare upstream O2 sensor activity to mode 6 data
A lazy or biased O2 sensor will set P0171 even when the engine is running correctly. Graph the sensor voltage at 2500 RPM — it should switch rapidly between roughly 0.1 V and 0.9 V. If it sticks low, the sensor (not the fuel system) is the problem.
Tools: Scan tool with graphing
Known Technical Service Bulletins for the 2020-2024 Toyota Camry
Manufacturers publish Technical Service Bulletins (TSBs) when a known issue affects a specific vehicle. These bulletins come from the NHTSA database for your Toyota Camry.
- ENGINE Feb 26, 2026
OBSOLETE NOTICE February 27, 2026: This bulletin is no longer applicable and is now obsolete.
NHTSA #11029896 - ELECTRICAL SYSTEM Jan 29, 2026
OBSOLETE NOTICE January 30, 2026: This bulletin is now obsolete. Please see T-SB-0001-26.
NHTSA #11028726 - ELECTRICAL SYSTEM Jan 27, 2026
Some 2018 – 2024 model year Toyota vehicles equipped with a Premium Audio with Dynamic Navigation System require a Special Service Tool (SST) USB flash drive to update the map, points of interest, and system software.
NHTSA #11028722 - UNKNOWN OR OTHER Jan 6, 2026
Some 2005 – 2026 Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty odor is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this Service Bulletin is to provide general guidelines and procedures for odor remediation. This Service Bulletin provides a guide on how to prepare and treat the interior of the vehicle for odor remediation. Refer to the applicable model and model year Repair Manual and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines.
NHTSA #11028712 - ENGINE Aug 6, 2025
The specific condition covered by this program is for a small engine coolant leak that can occur from the flow shut-off valve that can allow coolant to drip on other parts of the vehicle. This can cause "Engine Maintenance Required" to be displayed on the instrument cluster or cause the A/C not to function normally. Although the flow shut-off valve is covered by Toyota’s New Vehicle Limited Warranty for 36 months or 36,000 miles (whichever comes first), we at Toyota care about the customers’ ownership experience. Toyota is providing coverage for repairs related to Flow Shut-off Valve Coolant Leak.
NHTSA #11022949 - ELECTRICAL SYSTEM Jun 24, 2025
Some 2021 – 2022 model year Avalon, 2018 – 2024 Camry, 2019 – 2025 model year Corolla, 2022 – 2025 model year Corolla Cross, and 2019 – 2025 model year RAV4 vehicles with A25A-FKS and M20A-FKS engines may have a MIL ON condition with one or more of the following Diagnostic Trouble Codes (DTCs) upon cold soak start up with engine coolant temperatures between 14°F – 41°F: •P030027 – Random/Multiple Cylinder Misfire Detected (Emission) Signal Rate of Change Above Threshold •P030000 – Random/Multiple Cylinder Misfire Detected •P030100 – Cylinder 1 Misfire Detected •P030200 – Cylinder 2 Misfire Detected •P030300 – Cylinder 3 Misfire Detected •P030400 – Cylinder 4 Misfire Detected
NHTSA #11020670
+14 more TSBs available in MECH AI's TSB explorer for this vehicle.
Common fixes
- Repair the intake / vacuum leak found by smoke test
- Clean or replace the mass airflow (MAF) sensor
- Replace the fuel pump and / or fuel filter
- Replace the fuel pressure regulator
- Service or replace fuel injectors on Bank 1
About the 2020-2024 Toyota Camry
The 2020-2024 Toyota Camry was commonly sold with the following powertrains: 2.5L I4, 3.5L V6, 2.5L Hybrid I4. Common trims include LE, SE, XLE, XSE.
Is P0171 dangerous to drive with?
In the short term, no. The engine will run rough and consume slightly more fuel, but the vehicle is not at immediate risk. Driving for weeks with an uncorrected lean condition is a different matter — sustained lean operation runs combustion temperatures higher than design, which can damage exhaust valves, oxygen sensors, and the catalytic converter. A car that has been driving with P0171 for months may also set P0420 as the catalyst fails.
Why P0171 often appears with P0174
P0171 covers Bank 1 (the cylinder bank containing cylinder #1) and P0174 covers Bank 2. On a V6 or V8 engine, both codes setting together rules out bank-specific causes like one injector or one head-side intake gasket. The common culprit when both banks go lean is something that affects the entire engine: a clogged MAF, a brake booster leak, low fuel pressure, or a cracked common intake plenum.
When to replace the MAF sensor vs. clean it
Cleaning resolves roughly half of MAF-related P0171 cases on high-mileage engines. Replace the MAF only if (a) cleaning does not restore correct grams-per-second airflow readings at idle, or (b) live data shows the MAF output stuck or biased low even after cleaning. A genuine OEM MAF will typically outlast a cheap aftermarket replacement by years.