P0171 on a 2022 Ford Bronco
Fuel System Too Lean (Bank 1)
P0171 on a 2022 Ford Bronco indicates fuel system too lean (bank 1). It usually stays drivable short-term but should be diagnosed promptly. The most common cause is vacuum leak (intake manifold gasket, pcv hose, intake boot, brake booster hose) (typically $80–$600). Confirm the root cause before replacing parts.
What does P0171 mean on a 2022 Ford Bronco?
P0171 is set when the engine control module detects that long-term fuel trim on Bank 1 has been pushed beyond approximately +25 % to compensate for what it interprets as a lean air-fuel mixture. In other words, the ECM is adding the maximum amount of fuel it is allowed to, and the oxygen sensors still report a lean condition. The cause is almost always either unmetered air entering the engine, a fuel delivery problem, or a sensor reporting bad data.
This guide covers P0171 across the 2020-2024 Ford Bronco generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2020 through 2024.
Is it safe to drive a 2022 Ford Bronco with P0171?
In most cases a 2022 Ford Bronco stays drivable for short trips with P0171 active, but diagnose and repair it promptly. This is a moderate-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0171 on a 2022 Ford Bronco?
- Check Engine Light is illuminated
- Rough or unstable idle, especially when cold
- Hesitation, stumble, or stall when accelerating from a stop
- Reduced fuel economy
- Mild loss of power
- Whistling or hissing sound from the intake area (vacuum leak)
What causes P0171 on a 2022 Ford Bronco?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Vacuum leak (intake manifold gasket, PCV hose, intake boot, brake booster hose) The single most common P0171 cause across all makes. | Most common | $80–$600 |
| Dirty or failing mass airflow (MAF) sensor Cleaning with MAF-safe spray solves a large fraction of cases. | Most common | $30–$350 |
| Weak fuel pump or clogged fuel filter (low fuel pressure) | Common | $80–$900 |
| Failing fuel pressure regulator | Occasional | $100–$400 |
| Clogged or leaking fuel injectors on Bank 1 | Occasional | $150–$1,200 |
| Faulty oxygen sensor reporting false lean | Occasional | $150–$450 |
| Exhaust leak upstream of the front O2 sensor | Occasional | $100–$500 |
How to diagnose this on a 2022 Ford Bronco
-
Read fuel trims and short-term/long-term values
Connect a scan tool capable of live data. Compare short-term (STFT) and long-term (LTFT) fuel trims at idle and at 2500 RPM. If LTFT is +15 % or higher at idle but drops near zero at 2500 RPM, suspect a vacuum leak. If LTFT is high at all RPMs, suspect fuel delivery or MAF.
Tools: Bidirectional scan tool with live PIDs
-
Smoke-test the intake for vacuum leaks
Cap the intake and introduce low-pressure smoke into the manifold. Watch for smoke escaping at intake gaskets, the PCV system, the brake booster hose, vacuum tees, and the throttle body base. Cracked plastic intake manifolds are common on many Ford, Chrysler, and Nissan engines.
Tools: Smoke machine, Inspection mirror, Flashlight
-
Inspect and clean the MAF sensor
Remove the MAF sensor and spray the sensing elements with MAF-safe electronics cleaner. Reinstall, clear the code, and drive. If P0171 returns within a few drive cycles with high LTFT at cruise, the MAF may need replacement.
Tools: MAF-safe cleaner, Trim panel tools
-
Measure fuel pressure key-on-engine-off and at idle
Attach a fuel pressure gauge to the fuel rail Schrader port (or use a banjo adapter on returnless systems). Compare to the OEM specification for the vehicle — most port-injected systems run 45–60 psi at idle. Pressure that drops more than 5 psi under load points to a weak pump or regulator.
Tools: Fuel pressure gauge, Vehicle-specific service data
-
Compare upstream O2 sensor activity to mode 6 data
A lazy or biased O2 sensor will set P0171 even when the engine is running correctly. Graph the sensor voltage at 2500 RPM — it should switch rapidly between roughly 0.1 V and 0.9 V. If it sticks low, the sensor (not the fuel system) is the problem.
Tools: Scan tool with graphing
NHTSA complaints & recalls for the 2022 Ford Bronco
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2022 Ford Bronco. Use these to gauge how common a problem is on your specific vehicle before you start chasing Ford Bronco diagnostics.
- ENGINE 42
- POWER TRAIN 34
- VISIBILITY/WIPER 64
- SERVICE BRAKES 41
- UNKNOWN OR OTHER 37
21 active recalls
- LATCHES/LOCKS/LINKAGES:DOORS:LOCK Jun 2022
Ford Motor Company (Ford) is recalling certain four-door 2021-2022 Bronco vehicles. The passenger-side rear door may be opened from inside of the vehicle when the child safety lock is in the "ON" position.…
NHTSA campaign 22V411000 - VISIBILITY:WINDSHIELD Jun 2022
Ford Motor Company (Ford) is recalling certain 2022 Bronco and Ranger vehicles. The windshield may not have been properly bonded to the vehicle, which could allow it to detach during a crash. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle…
NHTSA campaign 22V451000 - BACK OVER PREVENTION: SENSING SYSTEM: CAMERA Nov 2022
Ford Motor Company (Ford) is recalling certain 2021-2022 Bronco vehicles equipped with rearview camera systems and 8-inch screen displays. The rearview camera image may still be displayed after a backing event has ended. As such, these vehicles fail to comply with the requireme…
NHTSA campaign 22V825000 - AIR BAGS:SENSOR:SIDE IMPACT Dec 2022
Ford Motor Company (Ford) is recalling certain 2021-2022 Bronco vehicles. The right or left side impact sensors may not be properly secured to the vehicle.…
NHTSA campaign 22V928000
How do I fix P0171 on a 2022 Ford Bronco?
- Repair the intake / vacuum leak found by smoke test
- Clean or replace the mass airflow (MAF) sensor
- Replace the fuel pump and / or fuel filter
- Replace the fuel pressure regulator
- Service or replace fuel injectors on Bank 1
About the 2020-2024 Ford Bronco
The 2020-2024 Ford Bronco was commonly sold with the following powertrains: 2.3L EcoBoost I4, 2.7L EcoBoost V6. Common trims include Base, Big Bend, Black Diamond, Outer Banks, Badlands, Wildtrak, Raptor.
Is P0171 dangerous to drive with?
In the short term, no. The engine will run rough and consume slightly more fuel, but the vehicle is not at immediate risk. Driving for weeks with an uncorrected lean condition is a different matter — sustained lean operation runs combustion temperatures higher than design, which can damage exhaust valves, oxygen sensors, and the catalytic converter. A car that has been driving with P0171 for months may also set P0420 as the catalyst fails.
Why P0171 often appears with P0174
P0171 covers Bank 1 (the cylinder bank containing cylinder #1) and P0174 covers Bank 2. On a V6 or V8 engine, both codes setting together rules out bank-specific causes like one injector or one head-side intake gasket. The common culprit when both banks go lean is something that affects the entire engine: a clogged MAF, a brake booster leak, low fuel pressure, or a cracked common intake plenum.
When to replace the MAF sensor vs. clean it
Cleaning resolves roughly half of MAF-related P0171 cases on high-mileage engines. Replace the MAF only if (a) cleaning does not restore correct grams-per-second airflow readings at idle, or (b) live data shows the MAF output stuck or biased low even after cleaning. A genuine OEM MAF will typically outlast a cheap aftermarket replacement by years.