P0171 on a 2022 Chevrolet Traverse
Fuel System Too Lean (Bank 1)
P0171 on a 2022 Chevrolet Traverse indicates fuel system too lean (bank 1). It usually stays drivable short-term but should be diagnosed promptly. The most common cause is vacuum leak (intake manifold gasket, pcv hose, intake boot, brake booster hose) (typically $80–$600). Confirm the root cause before replacing parts.
What does P0171 mean on a 2022 Chevrolet Traverse?
P0171 is set when the engine control module detects that long-term fuel trim on Bank 1 has been pushed beyond approximately +25 % to compensate for what it interprets as a lean air-fuel mixture. In other words, the ECM is adding the maximum amount of fuel it is allowed to, and the oxygen sensors still report a lean condition. The cause is almost always either unmetered air entering the engine, a fuel delivery problem, or a sensor reporting bad data.
This guide covers P0171 across the 2020-2024 Chevrolet Traverse generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2020 through 2024.
Is it safe to drive a 2022 Chevrolet Traverse with P0171?
In most cases a 2022 Chevrolet Traverse stays drivable for short trips with P0171 active, but diagnose and repair it promptly. This is a moderate-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0171 on a 2022 Chevrolet Traverse?
- Check Engine Light is illuminated
- Rough or unstable idle, especially when cold
- Hesitation, stumble, or stall when accelerating from a stop
- Reduced fuel economy
- Mild loss of power
- Whistling or hissing sound from the intake area (vacuum leak)
What causes P0171 on a 2022 Chevrolet Traverse?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Vacuum leak (intake manifold gasket, PCV hose, intake boot, brake booster hose) The single most common P0171 cause across all makes. | Most common | $80–$600 |
| Dirty or failing mass airflow (MAF) sensor Cleaning with MAF-safe spray solves a large fraction of cases. | Most common | $30–$350 |
| Weak fuel pump or clogged fuel filter (low fuel pressure) | Common | $80–$900 |
| Failing fuel pressure regulator | Occasional | $100–$400 |
| Clogged or leaking fuel injectors on Bank 1 | Occasional | $150–$1,200 |
| Faulty oxygen sensor reporting false lean | Occasional | $150–$450 |
| Exhaust leak upstream of the front O2 sensor | Occasional | $100–$500 |
How to diagnose this on a 2022 Chevrolet Traverse
-
Read fuel trims and short-term/long-term values
Connect a scan tool capable of live data. Compare short-term (STFT) and long-term (LTFT) fuel trims at idle and at 2500 RPM. If LTFT is +15 % or higher at idle but drops near zero at 2500 RPM, suspect a vacuum leak. If LTFT is high at all RPMs, suspect fuel delivery or MAF.
Tools: Bidirectional scan tool with live PIDs
-
Smoke-test the intake for vacuum leaks
Cap the intake and introduce low-pressure smoke into the manifold. Watch for smoke escaping at intake gaskets, the PCV system, the brake booster hose, vacuum tees, and the throttle body base. Cracked plastic intake manifolds are common on many Ford, Chrysler, and Nissan engines.
Tools: Smoke machine, Inspection mirror, Flashlight
-
Inspect and clean the MAF sensor
Remove the MAF sensor and spray the sensing elements with MAF-safe electronics cleaner. Reinstall, clear the code, and drive. If P0171 returns within a few drive cycles with high LTFT at cruise, the MAF may need replacement.
Tools: MAF-safe cleaner, Trim panel tools
-
Measure fuel pressure key-on-engine-off and at idle
Attach a fuel pressure gauge to the fuel rail Schrader port (or use a banjo adapter on returnless systems). Compare to the OEM specification for the vehicle — most port-injected systems run 45–60 psi at idle. Pressure that drops more than 5 psi under load points to a weak pump or regulator.
Tools: Fuel pressure gauge, Vehicle-specific service data
-
Compare upstream O2 sensor activity to mode 6 data
A lazy or biased O2 sensor will set P0171 even when the engine is running correctly. Graph the sensor voltage at 2500 RPM — it should switch rapidly between roughly 0.1 V and 0.9 V. If it sticks low, the sensor (not the fuel system) is the problem.
Tools: Scan tool with graphing
NHTSA complaints & recalls for the 2022 Chevrolet Traverse
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2022 Chevrolet Traverse. Use these to gauge how common a problem is on your specific vehicle before you start chasing Chevrolet Traverse diagnostics.
- POWER TRAIN 37
- ENGINE 16
- UNKNOWN OR OTHER 24
- ELECTRICAL SYSTEM 16
- SERVICE BRAKES 7
1 active recall
- AIR BAGS:SIDE/WINDOW:CURTAIN Mar 2022
General Motors, LLC (GM) is recalling certain 2020-2022 Chevrolet Traverse and 2021-2022 Buick Enclave vehicles. The harness connector to the left or right side roof rail air bag may have incompatible electrical terminals, which could prevent the air bags from deploying in a cra…
NHTSA campaign 22V210000
How do I fix P0171 on a 2022 Chevrolet Traverse?
- Repair the intake / vacuum leak found by smoke test
- Clean or replace the mass airflow (MAF) sensor
- Replace the fuel pump and / or fuel filter
- Replace the fuel pressure regulator
- Service or replace fuel injectors on Bank 1
About the 2020-2024 Chevrolet Traverse
The 2020-2024 Chevrolet Traverse was commonly sold with the following powertrains: 3.6L V6, 2.0L Turbo I4. Common trims include L, LS, LT, RS, Premier, High Country.
Is P0171 dangerous to drive with?
In the short term, no. The engine will run rough and consume slightly more fuel, but the vehicle is not at immediate risk. Driving for weeks with an uncorrected lean condition is a different matter — sustained lean operation runs combustion temperatures higher than design, which can damage exhaust valves, oxygen sensors, and the catalytic converter. A car that has been driving with P0171 for months may also set P0420 as the catalyst fails.
Why P0171 often appears with P0174
P0171 covers Bank 1 (the cylinder bank containing cylinder #1) and P0174 covers Bank 2. On a V6 or V8 engine, both codes setting together rules out bank-specific causes like one injector or one head-side intake gasket. The common culprit when both banks go lean is something that affects the entire engine: a clogged MAF, a brake booster leak, low fuel pressure, or a cracked common intake plenum.
When to replace the MAF sensor vs. clean it
Cleaning resolves roughly half of MAF-related P0171 cases on high-mileage engines. Replace the MAF only if (a) cleaning does not restore correct grams-per-second airflow readings at idle, or (b) live data shows the MAF output stuck or biased low even after cleaning. A genuine OEM MAF will typically outlast a cheap aftermarket replacement by years.