P0138 on a 2022 GMC Sierra 1500

Post-Cat O2 Sensor High Voltage (Bank 1 Downstream)

P0138 on a 2022 GMC Sierra 1500 indicates post-cat o2 sensor high voltage (bank 1 downstream). It usually stays drivable short-term but should be diagnosed promptly. The most common cause is failed bank 1 downstream o2 sensor (stuck high) (typically $150–$450). Confirm the root cause before replacing parts.

Severity: low Safe to drive (short term) Pickup Truck 2020-2024 GMC Sierra 1500

Reviewed by MECH AI Editorial · Last verified

What does P0138 mean on a 2022 GMC Sierra 1500?

P0138 is set when the downstream (post-catalyst) oxygen sensor on Bank 1 reports a voltage above the calibrated maximum (typically above 1.0 V) for an extended period. The downstream sensor normally sits at a relatively steady 0.6–0.8 V because the catalyst smooths the rich/lean oscillation it sees coming in. A reading stuck above 1.0 V is either a genuine very-rich condition reaching the catalyst, a shorted signal wire, or a failed sensor biased high.

This guide covers P0138 across the 2020-2024 GMC Sierra 1500 generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2020 through 2024.

Is it safe to drive a 2022 GMC Sierra 1500 with P0138?

In most cases a 2022 GMC Sierra 1500 stays drivable for short trips with P0138 active, but diagnose and repair it promptly. This is a low-severity code — ignoring it can lead to further damage or a failed emissions test.

What are the symptoms of P0138 on a 2022 GMC Sierra 1500?

What causes P0138 on a 2022 GMC Sierra 1500?

Cause Likelihood Estimated repair (USD)
Failed Bank 1 downstream O2 sensor (stuck high) Most common $150–$450
Shorted-to-power O2 signal wire (sensor reads max) Common $80–$350
Genuine rich condition reaching the catalyst (leaking injector, FPR) Address the rich condition; the sensor is correctly reporting it. Common $150–$1,200
Damaged sensor connector — corrosion biasing the signal Common $30–$200
Internal sensor short due to contamination Occasional $150–$450
Coolant or oil in the exhaust (head gasket / valve seals) Rare $1,200–$3,500

How to diagnose this on a 2022 GMC Sierra 1500

  1. Determine whether the reading is real or sensor-reported

    Read fuel trims at idle and 2500 RPM. If Bank 1 LTFT is around −10 % or worse (the ECM pulling fuel out), the engine is genuinely running rich and the downstream sensor is correctly reporting it. If LTFT is near zero, the engine is fine and the sensor or its wiring is the problem.

    Tools: Scan tool with fuel trim PIDs

  2. Inspect for shorted signal wire

    Disconnect the Bank 1 downstream O2 sensor. With the connector unplugged and the key on, scan-tool voltage on the signal wire should fall to bias voltage (0.4–0.5 V). If voltage stays high (above 1 V), the signal wire is shorted to power somewhere between the sensor and the PCM.

    Tools: Scan tool, Multimeter

  3. Verify with a known-good sensor

    The downstream sensor is essentially a slow O2 sensor that should not switch rapidly. If a known-good sensor (or the Bank 2 downstream sensor if equipped) reads correctly while the Bank 1 downstream sticks high, the Bank 1 sensor is bad.

    Tools: Scan tool with sensor swap capability

  4. Inspect for fuel contamination of the catalyst

    If a separate rich-running fault (P0172, stuck injector) has been present for months, fuel may have entered the catalyst and altered its oxygen-storage behavior — which the downstream sensor sees as a chronic rich signal. This requires the rich cause fixed AND likely catalyst replacement.

    Tools: Diagnostic history review

  5. Check for exhaust system damage

    Look for any damage to the exhaust between the catalyst and the downstream sensor that could let oil mist or coolant into the exhaust stream. Coolant entering the exhaust (head gasket, cracked head) creates rich-mimicking sensor readings.

    Tools: Visual inspection, Coolant pressure tester

NHTSA complaints & recalls for the 2022 GMC Sierra 1500

Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2022 GMC Sierra 1500. Use these to gauge how common a problem is on your specific vehicle before you start chasing GMC Sierra 1500 diagnostics.

515 owner complaints
10 involved a crash
6 involved a fire
3 reported injuries
  • ENGINE 207
  • POWER TRAIN 92
  • STRUCTURE 90
  • ELECTRICAL SYSTEM 75
  • UNKNOWN OR OTHER 70

6 active recalls

  • EXTERIOR LIGHTING:BRAKE LIGHTS Jun 2022

    General Motors (GM) has decided that certain 2022 model year Chevrolet Silverado, and GMC Sierra vehicles equipped with an accessory sport bar. The accessory sport bar contains a high-mounted brake light that may not function. In addition, it may block the vehicle's existing hi…

    NHTSA campaign 22V463000
  • EXTERIOR LIGHTING:LIGHTING CONTROL MODULE:SOFTWARE Dec 2022

    General Motors, LLC (GM) is recalling certain 2020-2023 Cadillac CT4 and CT5; 2021-2023 Buick Envision; and 2022-2023 Cadillac Escalade and Escalade ESV, Chevrolet Silverado 1500, Suburban, Tahoe, GMC Sierra 1500, Yukon, and Yukon XL vehicles. The daytime running lights (DRLs) m…

    NHTSA campaign 22V903000
  • POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE:SOFTWARE Oct 2024

    General Motors, LLC (GM) is recalling certain 2020-2022 Chevrolet Silverado 1500, 2500, 3500, GMC Sierra 1500, 2500, 3500, 2021 Cadillac Escalade, Escalade ESV, Chevrolet Tahoe, Suburban, GMC Yukon, and Yukon XL vehicles equipped with diesel engines. The transmission control val…

    NHTSA campaign 24V797000
  • STRUCTURE:BODY:BUMPERS:ACTIVE SHUTTERS/GRILL Feb 2025

    General Motors, LLC (GM) is recalling certain 2022 GMC Sierra 1500 vehicles equipped with chrome front grille deflectors. The attachments that hold the front grille deflectors in place may fracture, resulting in grille detachment.…

    NHTSA campaign 25V060000

How do I fix P0138 on a 2022 GMC Sierra 1500?

About the 2020-2024 GMC Sierra 1500

The 2020-2024 GMC Sierra 1500 was commonly sold with the following powertrains: 5.3L V8, 6.2L V8, 2.7L Turbo I4, 3.0L Duramax I6 Diesel. Common trims include Pro, SLE, Elevation, SLT, AT4, Denali.

What the downstream O2 sensor actually does

Unlike the upstream sensor, which feeds closed-loop fuel control, the downstream sensor’s main job is to monitor catalyst efficiency. It also provides a slow secondary fuel-trim correction. A properly functioning catalyst smooths the rich/lean oscillation coming from the engine — so the downstream voltage normally hovers steadily around 0.6–0.8 V instead of switching.

P0138 means that smoothing is gone and the post-cat reading is biased high — either the cat is gone, the engine is running rich, or the sensor itself is misreading.

P0138 with no other rich codes

This pattern usually points at the sensor or its wiring rather than a fuel system problem. A genuine rich condition severe enough to peg the downstream sensor at >1 V would also set P0172. P0138 alone with normal fuel trims is the textbook “downstream sensor has failed” pattern.

When P0138 reflects a real fuel problem

If P0138 sets alongside P0172 (system too rich), P0171 (lean) with heavy intake leak, or recent fuel-injector work, the sensor is likely correct and the fueling is at fault. Replacing the sensor without fixing the upstream condition will result in P0138 returning within days.

Related diagnostic codes