P0138 on a 2017 Chevrolet Silverado 1500
Post-Cat O2 Sensor High Voltage (Bank 1 Downstream)
P0138 on a 2017 Chevrolet Silverado 1500 indicates post-cat o2 sensor high voltage (bank 1 downstream). It usually stays drivable short-term but should be diagnosed promptly. The most common cause is failed bank 1 downstream o2 sensor (stuck high) (typically $150–$450). Confirm the root cause before replacing parts.
What does P0138 mean on a 2017 Chevrolet Silverado 1500?
P0138 is set when the downstream (post-catalyst) oxygen sensor on Bank 1 reports a voltage above the calibrated maximum (typically above 1.0 V) for an extended period. The downstream sensor normally sits at a relatively steady 0.6–0.8 V because the catalyst smooths the rich/lean oscillation it sees coming in. A reading stuck above 1.0 V is either a genuine very-rich condition reaching the catalyst, a shorted signal wire, or a failed sensor biased high.
This guide covers P0138 across the 2015-2019 Chevrolet Silverado 1500 generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2015 through 2019.
Is it safe to drive a 2017 Chevrolet Silverado 1500 with P0138?
In most cases a 2017 Chevrolet Silverado 1500 stays drivable for short trips with P0138 active, but diagnose and repair it promptly. This is a low-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0138 on a 2017 Chevrolet Silverado 1500?
- Check Engine Light is illuminated
- Possible mild reduction in fuel economy
- Often no drivability symptoms at all
- Vehicle may fail emissions / smog testing
- Sometimes accompanied by P0172 (rich Bank 1)
What causes P0138 on a 2017 Chevrolet Silverado 1500?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Failed Bank 1 downstream O2 sensor (stuck high) | Most common | $150–$450 |
| Shorted-to-power O2 signal wire (sensor reads max) | Common | $80–$350 |
| Genuine rich condition reaching the catalyst (leaking injector, FPR) Address the rich condition; the sensor is correctly reporting it. | Common | $150–$1,200 |
| Damaged sensor connector — corrosion biasing the signal | Common | $30–$200 |
| Internal sensor short due to contamination | Occasional | $150–$450 |
| Coolant or oil in the exhaust (head gasket / valve seals) | Rare | $1,200–$3,500 |
How to diagnose this on a 2017 Chevrolet Silverado 1500
-
Determine whether the reading is real or sensor-reported
Read fuel trims at idle and 2500 RPM. If Bank 1 LTFT is around −10 % or worse (the ECM pulling fuel out), the engine is genuinely running rich and the downstream sensor is correctly reporting it. If LTFT is near zero, the engine is fine and the sensor or its wiring is the problem.
Tools: Scan tool with fuel trim PIDs
-
Inspect for shorted signal wire
Disconnect the Bank 1 downstream O2 sensor. With the connector unplugged and the key on, scan-tool voltage on the signal wire should fall to bias voltage (0.4–0.5 V). If voltage stays high (above 1 V), the signal wire is shorted to power somewhere between the sensor and the PCM.
Tools: Scan tool, Multimeter
-
Verify with a known-good sensor
The downstream sensor is essentially a slow O2 sensor that should not switch rapidly. If a known-good sensor (or the Bank 2 downstream sensor if equipped) reads correctly while the Bank 1 downstream sticks high, the Bank 1 sensor is bad.
Tools: Scan tool with sensor swap capability
-
Inspect for fuel contamination of the catalyst
If a separate rich-running fault (P0172, stuck injector) has been present for months, fuel may have entered the catalyst and altered its oxygen-storage behavior — which the downstream sensor sees as a chronic rich signal. This requires the rich cause fixed AND likely catalyst replacement.
Tools: Diagnostic history review
-
Check for exhaust system damage
Look for any damage to the exhaust between the catalyst and the downstream sensor that could let oil mist or coolant into the exhaust stream. Coolant entering the exhaust (head gasket, cracked head) creates rich-mimicking sensor readings.
Tools: Visual inspection, Coolant pressure tester
Known Technical Service Bulletins for the 2015-2019 Chevrolet Silverado 1500
Manufacturers publish Technical Service Bulletins (TSBs) when a known issue affects a specific vehicle. These bulletins come from the NHTSA database for your Chevrolet Silverado 1500.
- UNKNOWN OR OTHER Apr 1, 2026
This preliminary information communicates information about how to determine if a wheel and tires size change is available.
NHTSA #11030974 - UNKNOWN OR OTHER Apr 1, 2026
This preliminary information communicates information about how to determine if a wheel and tires size change is available.
NHTSA #11030974 - UNKNOWN OR OTHER Mar 24, 2026
This PI was created to help avoid unnecessary front camera module replacements
NHTSA #11030353 - UNKNOWN OR OTHER Mar 24, 2026
This PI was created to help avoid unnecessary front camera module replacements
NHTSA #11030353 - UNKNOWN OR OTHER Mar 13, 2026
This PI was created to help avoid unnecessary front camera module replacements
NHTSA #11030169 - UNKNOWN OR OTHER Mar 13, 2026
This PI was created to help avoid unnecessary front camera module replacements
NHTSA #11030169
+14 more TSBs available in MECH AI's TSB explorer for this vehicle.
NHTSA complaints & recalls for the 2017 Chevrolet Silverado 1500
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2017 Chevrolet Silverado 1500. Use these to gauge how common a problem is on your specific vehicle before you start chasing Chevrolet Silverado 1500 diagnostics.
- POWER TRAIN 220
- ENGINE 128
- SERVICE BRAKES 221
- ELECTRICAL SYSTEM 132
- UNKNOWN OR OTHER 88
6 active recalls
- SERVICE BRAKES, HYDRAULIC:POWER ASSIST:VACUUM Sep 2019
General Motors LLC (GM) is recalling certain 2015-2017 Cadillac Escalade, 2014-2018 Chevrolet Silverado, GMC Sierra, 2015-2018 Chevrolet Suburban, Tahoe, GMC Yukon vehicles. The amount of vacuum created by the vacuum pump may decrease over time.…
NHTSA campaign 19V645000 - SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:WHEEL SPEED SENSOR/TONE RING Oct 2019
General Motors LLC (GM) is recalling certain 2015-2020 Chevrolet Suburban, Tahoe, and GMC Yukon, and 2014-2018 Chevrolet Silverado 1500 and GMC Sierra 1500 vehicles equipped with a 5.3-liter engine, a 3.08-ratio rear axle and four-wheel drive. If a wheel-speed sensor fails, whil…
NHTSA campaign 19V761000 - AIR BAGS:FRONTAL Sep 2016
General Motors LLC (GM) is recalling certain model year 2015-2017 Chevrolet Silverado 2500 HD, 3500 HD, Tahoe, Suburban, GMC Sierra 2500 HD and 3500 HD, GMC Yukon, GMC Yukon XL, Cadillac Escalade and Cadillac Escalade ESV vehicles and 2014-2017 Chevrolet Corvette, Silverado 1500…
NHTSA campaign 16V651000 - CHILD SEAT:TETHER: CONNECTOR/CLIP Aug 2017
General Motors LLC (GM) is recalling certain 2017 Chevrolet Silverado 1500, and GMC Sierra 1500 trucks. The owner's manual for the affected vehicles may be missing instructions on how to use the tether anchorage and child restraint anchorage systems. As such, these vehicles fai…
NHTSA campaign 17V487000
How do I fix P0138 on a 2017 Chevrolet Silverado 1500?
- Replace the Bank 1 downstream O2 sensor with an OEM part
- Repair shorted-to-power O2 signal wire
- Address underlying rich condition (P0172) first if present
- Clean or replace corroded O2 sensor connector
- Repair coolant or oil entry into the exhaust (root cause)
About the 2015-2019 Chevrolet Silverado 1500
The 2015-2019 Chevrolet Silverado 1500 was commonly sold with the following powertrains: 5.3L V8, 6.2L V8, 2.7L Turbo I4. Common trims include WT, LT, RST, LTZ, High Country.
What the downstream O2 sensor actually does
Unlike the upstream sensor, which feeds closed-loop fuel control, the downstream sensor’s main job is to monitor catalyst efficiency. It also provides a slow secondary fuel-trim correction. A properly functioning catalyst smooths the rich/lean oscillation coming from the engine — so the downstream voltage normally hovers steadily around 0.6–0.8 V instead of switching.
P0138 means that smoothing is gone and the post-cat reading is biased high — either the cat is gone, the engine is running rich, or the sensor itself is misreading.
P0138 with no other rich codes
This pattern usually points at the sensor or its wiring rather than a fuel system problem. A genuine rich condition severe enough to peg the downstream sensor at >1 V would also set P0172. P0138 alone with normal fuel trims is the textbook “downstream sensor has failed” pattern.
When P0138 reflects a real fuel problem
If P0138 sets alongside P0172 (system too rich), P0171 (lean) with heavy intake leak, or recent fuel-injector work, the sensor is likely correct and the fueling is at fault. Replacing the sensor without fixing the upstream condition will result in P0138 returning within days.
P0138 on a 2017 Chevrolet Silverado 1500: frequently asked questions
What does diagnostic trouble code P0138 mean on a 2017 Chevrolet Silverado 1500?
P0138 is set when the downstream (post-catalyst) oxygen sensor on Bank 1 reports a voltage above the calibrated maximum (typically above 1.0 V) for an extended period. The downstream sensor normally sits at a relatively steady 0.6–0.8 V because the catalyst smooths the rich/lean oscillation it sees coming in. A reading stuck above 1.0 V is either a genuine very-rich condition reaching the catalyst, a shorted signal wire, or a failed sensor biased high.
What are the symptoms of P0138 on a 2017 Chevrolet Silverado 1500?
Check Engine Light is illuminated. Possible mild reduction in fuel economy. Often no drivability symptoms at all. Vehicle may fail emissions / smog testing. Sometimes accompanied by P0172 (rich Bank 1)
What causes P0138 on a 2017 Chevrolet Silverado 1500?
Failed Bank 1 downstream O2 sensor (stuck high) (most-common). Shorted-to-power O2 signal wire (sensor reads max) (common). Genuine rich condition reaching the catalyst (leaking injector, FPR) (common). Damaged sensor connector — corrosion biasing the signal (common). Internal sensor short due to contamination (occasional). Coolant or oil in the exhaust (head gasket / valve seals) (rare)
Is it safe to drive a 2017 Chevrolet Silverado 1500 with P0138?
In most cases a 2017 Chevrolet Silverado 1500 stays drivable for short trips with P0138 active, but it should be diagnosed and repaired promptly — this is a low-severity code. Ignoring it can lead to further damage or a failed emissions test.