P0128 on a 2017 Ram 1500
Engine Not Reaching Operating Temperature
P0128 on a 2017 Ram 1500 indicates engine not reaching operating temperature. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is thermostat stuck partially or fully open (typically $80–$350). Confirm the root cause before replacing parts.
What does P0128 mean on a 2017 Ram 1500?
P0128 is set when the engine fails to reach the calibrated minimum operating coolant temperature within a calibrated time and distance. The ECM monitors coolant temp, ambient temp, and time. If the engine never hits the temperature it should after driving long enough to warm up, the most likely cause is a thermostat stuck partially open — coolant is circulating to the radiator constantly instead of being blocked until the engine warms.
This guide covers P0128 across the 2015-2019 Ram 1500 generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2015 through 2019.
Is it safe to drive a 2017 Ram 1500 with P0128?
In most cases a 2017 Ram 1500 stays drivable for short trips with P0128 active, but diagnose and repair it promptly. This is a low-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0128 on a 2017 Ram 1500?
- Check Engine Light is illuminated
- Heater output is weak or takes a long time to warm up in cold weather
- Temperature gauge sits lower than normal
- Reduced fuel economy
- Slightly rough cold-start running
- No drivability issue once the engine eventually warms up
What causes P0128 on a 2017 Ram 1500?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Thermostat stuck partially or fully open The textbook P0128 cause across virtually all makes. | Most common | $80–$350 |
| Wrong-temperature thermostat installed (e.g. 160 °F in place of 195 °F) Common after a previous overheating repair where the wrong stat was fitted. | Common | $30–$200 |
| Failed engine coolant temperature (ECT) sensor reading low | Occasional | $80–$250 |
| Failed cylinder-head temperature (CHT) sensor on engines that use one | Occasional | $100–$400 |
| Heater core hose or bypass leak letting coolant circulate freely | Rare | $50–$250 |
| Cooling fan running constantly due to a separate fault | Rare | $100–$500 |
How to diagnose this on a 2017 Ram 1500
-
Watch coolant temp climb on a cold start
Connect a scan tool, set the coolant temp PID to graph, and start the engine cold. A healthy system climbs steadily from ambient to about 180–210 °F within 8–12 minutes of driving. If the gauge hovers in the 130–160 °F range and never reaches the upper plateau, the thermostat is the prime suspect.
Tools: Scan tool with graphing PIDs
-
Verify the temperature sensor reading matches reality
Point an infrared thermometer at the cylinder head near the temperature sensor and at the upper radiator hose. Compare to the scan tool reading. A sensor reading more than 15 °F off the thermometer is failing.
Tools: Infrared thermometer, Scan tool
-
Inspect the radiator hose temperature pattern
Cold-start the engine. The upper radiator hose should stay cool to the touch for the first 5–8 minutes (thermostat closed) and then warm rapidly as the thermostat opens. A hose that warms gradually from idle confirms the thermostat is stuck open.
Tools: Infrared thermometer
-
Check the thermostat opening temperature stamp
Before replacing, confirm the new thermostat is the correct OEM opening temperature. Pulled-apart thermostats often have the rated temperature stamped on the bypass plate (e.g. "195F" or "82C"). If a previous repair used a 160 °F thermostat, the engine will set P0128 even with a brand-new properly-functioning unit.
Tools: Vehicle-specific service spec
-
Verify the cooling fan is not running prematurely
Watch the cooling fan with the engine cold. If the fan starts running immediately, a separate fault is cooling the engine excessively. Diagnose that fault first — replacing the thermostat will not fix P0128 if the fan is the real cause.
Tools: Visual inspection
NHTSA complaints & recalls for the 2017 Ram 1500
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2017 Ram 1500. Use these to gauge how common a problem is on your specific vehicle before you start chasing Ram 1500 diagnostics.
- ENGINE 154
- POWER TRAIN 97
- STEERING 215
- ELECTRICAL SYSTEM 102
- SERVICE BRAKES 91
13 active recalls
- ENGINE AND ENGINE COOLING:ENGINE:DIESEL Aug 2020
Chrysler (FCA US LLC) is recalling certain 2014-2018 Ram 1500 and 2014-2016 Jeep Grand Cherokee vehicles equipped with 3.0L diesel engines. The crankshaft position sensor tone wheel may delaminate causing the engine to lose its ability to synchronize the fuel injector pulses and…
NHTSA campaign 20V475000 - LATCHES/LOCKS/LINKAGES:TAILGATE:LATCH May 2019
Chrysler (FCA US LLC) is recalling certain 2015-2017 Ram 1500, 2500 and 3500 pickup trucks equipped with an 8 foot bed and a power locking tailgate. Chrysler is also recalling all 2013-2014 and 2018 Ram 1500, 2500 and 3500 pickup trucks built before April 1, 2018 with a 6 or 8 f…
NHTSA campaign 19V347000 - STRUCTURE:BODY:TAILGATE Jul 2018
Chrysler (FCA US LLC) is recalling certain 2015-2017 RAM 1500, 2500, and 3500 pickup trucks equipped with a power locking tailgate and either a 5 foot, 7 inch or 6 foot, 4 inch bed. The tailgate actuator limiter tab may fracture and cause the tailgate to unlatch and open while d…
NHTSA campaign 18V486000 - ELECTRICAL SYSTEM:WIRING May 2018
Chrysler (FCA US LLC) is recalling certain 2014-2018 Dodge Journey, Charger and Durango, RAM 2500, 3500, 3500 Cab Chassis (more than 10,000lb), 4500 Cab Chassis and 5500 Cab Chassis, Jeep Cherokee and Grand Cherokee and Chrysler 300, 2014-2019 RAM 1500, 2015-2018 Dodge Challenger…
NHTSA campaign 18V332000
How do I fix P0128 on a 2017 Ram 1500?
- Replace the engine thermostat with the correct OEM opening temperature
- Replace the engine coolant temperature (ECT) sensor
- Replace the cylinder head temperature (CHT) sensor on engines that use one
- Repair any unintended cooling fan or bypass issues
About the 2015-2019 Ram 1500
The 2015-2019 Ram 1500 was commonly sold with the following powertrains: 5.7L HEMI V8, 3.6L V6, 3.0L EcoDiesel V6. Common trims include Tradesman, Big Horn, Laramie, Rebel, Limited.
Why a stuck-open thermostat hurts fuel economy
Modern engines are calibrated to run efficiently only when coolant temperature is in a narrow band — typically 195–220 °F. When coolant runs colder than that, the ECM holds the engine in cold-start enrichment mode for longer than necessary, which dumps extra fuel into the cylinders. Owners commonly see a 10–20 % drop in fuel economy with an uncorrected P0128.
Is P0128 safe to ignore?
Mechanically, yes — an over-cool engine will not seize or fail immediately. But every cold-running mile washes a little extra fuel past the rings into the oil, accelerates carbon buildup, and degrades emissions. Replace the thermostat at the next convenient service. The part itself is typically $15–$60 and the labor is straightforward on most engines.
P0128 in summer vs winter
P0128 is much more likely to set in cold-weather months. Some vehicles will store the code year-round once it has set, but the monitor only runs when ambient temperature is below a calibration threshold (often below 50 °F / 10 °C). A vehicle that sets P0128 every winter and not in summer has a marginal thermostat that should be replaced before it fully fails.
P0128 on a 2017 Ram 1500: frequently asked questions
What does diagnostic trouble code P0128 mean on a 2017 Ram 1500?
P0128 is set when the engine fails to reach the calibrated minimum operating coolant temperature within a calibrated time and distance. The ECM monitors coolant temp, ambient temp, and time. If the engine never hits the temperature it should after driving long enough to warm up, the most likely cause is a thermostat stuck partially open — coolant is circulating to the radiator constantly instead of being blocked until the engine warms.
What are the symptoms of P0128 on a 2017 Ram 1500?
Check Engine Light is illuminated. Heater output is weak or takes a long time to warm up in cold weather. Temperature gauge sits lower than normal. Reduced fuel economy. Slightly rough cold-start running. No drivability issue once the engine eventually warms up
What causes P0128 on a 2017 Ram 1500?
Thermostat stuck partially or fully open (most-common). Wrong-temperature thermostat installed (e.g. 160 °F in place of 195 °F) (common). Failed engine coolant temperature (ECT) sensor reading low (occasional). Failed cylinder-head temperature (CHT) sensor on engines that use one (occasional). Heater core hose or bypass leak letting coolant circulate freely (rare). Cooling fan running constantly due to a separate fault (rare)
Is it safe to drive a 2017 Ram 1500 with P0128?
In most cases a 2017 Ram 1500 stays drivable for short trips with P0128 active, but it should be diagnosed and repaired promptly — this is a low-severity code. Ignoring it can lead to further damage or a failed emissions test.