P0741 on a 2022 Ford Bronco
Torque Converter Clutch Stuck Off
P0741 on a 2022 Ford Bronco indicates torque converter clutch stuck off. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is worn or burned torque converter clutch friction material (typically $1,800–$4,500). Confirm the root cause before replacing parts.
What does P0741 mean on a 2022 Ford Bronco?
P0741 is set when the ECM (or TCM) commands the torque converter clutch (TCC) to lock up under cruise conditions and does not see the expected drop in engine RPM relative to vehicle speed. Effectively, the lockup clutch is being commanded but not engaging — or it engages and immediately slips. Either way the converter is running in fluid-coupling mode at highway speed when it should be mechanically locked.
This guide covers P0741 across the 2020-2024 Ford Bronco generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2020 through 2024.
Is it safe to drive a 2022 Ford Bronco with P0741?
In most cases a 2022 Ford Bronco stays drivable for short trips with P0741 active, but diagnose and repair it promptly. This is a high-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0741 on a 2022 Ford Bronco?
- Check Engine Light is illuminated
- Engine RPM at highway cruise is 200–400 RPM higher than normal
- Noticeable fuel economy drop on the highway
- Possible transmission fluid overheating warning on towing
- Shudder or vibration at light-throttle cruise (slipping TCC)
- Often paired with P0700 from the TCM
What causes P0741 on a 2022 Ford Bronco?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Worn or burned torque converter clutch friction material Requires torque converter replacement — major job. | Most common | $1,800–$4,500 |
| Failed TCC solenoid in the valve body | Common | $300–$900 |
| Stuck TCC control valve in the valve body | Common | $400–$1,500 |
| Low transmission fluid level or contaminated fluid | Common | $100–$400 |
| Wiring fault to the TCC solenoid | Occasional | $80–$350 |
| Failed TCM driver for the TCC solenoid | Rare | $500–$1,500 |
| Internal transmission damage allowing fluid bypass | Occasional | $2,500–$6,500 |
How to diagnose this on a 2022 Ford Bronco
-
Check transmission fluid level and condition
Transmission service procedures vary widely — some vehicles require a special procedure to check fluid level at operating temperature with the engine running. Follow the vehicle's specific procedure. Fluid that smells burnt or shows clutch material indicates internal damage; no point chasing the solenoid until the fluid is right.
Tools: Vehicle-specific service procedure, Replacement fluid (if needed)
-
Verify TCC command vs. actual lockup with a scan tool
During highway cruise, watch the TCC duty cycle or commanded state, alongside engine RPM and vehicle speed. The TCC should command on around 45–55 mph and engine RPM should drop 100–300 RPM at the moment of lockup. No RPM drop confirms the TCC is not engaging mechanically.
Tools: Scan tool with TCC and live RPM PIDs
-
Test the TCC solenoid electrically
Locate the TCC solenoid in the wiring diagram (most are accessible through the transmission's external connector). Measure resistance — typical 10–30 Ω depending on the transmission. Confirm continuity and that the TCM commands voltage to the solenoid during the lockup attempt.
Tools: Multimeter, Wiring diagram
-
Inspect transmission external connector for fluid
Disconnect the external transmission connector. Fluid wicking up into the wiring harness from a failed case seal will contaminate the TCM-side connector and cause electrical faults that mimic a solenoid failure. The repair is the seal and often the harness; the solenoid itself may be fine.
Tools: Connector unlock tool, Flashlight
-
Drop the pan and inspect the magnet
A pan magnet covered in fine clutch material — especially brown or black gritty paste — indicates the torque converter clutch has been slipping and shedding material. At that point the converter must be replaced; cleaning is not a fix.
Tools: Drain pan, Socket set, New filter and gasket
NHTSA complaints & recalls for the 2022 Ford Bronco
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2022 Ford Bronco. Use these to gauge how common a problem is on your specific vehicle before you start chasing Ford Bronco diagnostics.
- ENGINE 42
- POWER TRAIN 34
- VISIBILITY/WIPER 64
- SERVICE BRAKES 41
- UNKNOWN OR OTHER 37
21 active recalls
- LATCHES/LOCKS/LINKAGES:DOORS:LOCK Jun 2022
Ford Motor Company (Ford) is recalling certain four-door 2021-2022 Bronco vehicles. The passenger-side rear door may be opened from inside of the vehicle when the child safety lock is in the "ON" position.…
NHTSA campaign 22V411000 - VISIBILITY:WINDSHIELD Jun 2022
Ford Motor Company (Ford) is recalling certain 2022 Bronco and Ranger vehicles. The windshield may not have been properly bonded to the vehicle, which could allow it to detach during a crash. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle…
NHTSA campaign 22V451000 - BACK OVER PREVENTION: SENSING SYSTEM: CAMERA Nov 2022
Ford Motor Company (Ford) is recalling certain 2021-2022 Bronco vehicles equipped with rearview camera systems and 8-inch screen displays. The rearview camera image may still be displayed after a backing event has ended. As such, these vehicles fail to comply with the requireme…
NHTSA campaign 22V825000 - AIR BAGS:SENSOR:SIDE IMPACT Dec 2022
Ford Motor Company (Ford) is recalling certain 2021-2022 Bronco vehicles. The right or left side impact sensors may not be properly secured to the vehicle.…
NHTSA campaign 22V928000
How do I fix P0741 on a 2022 Ford Bronco?
- Service transmission fluid and filter to the correct specification
- Replace the TCC solenoid (often part of a solenoid pack)
- Repair external transmission wiring or connector
- Replace the torque converter (and usually rebuild the transmission)
- Rebuild or replace the transmission for severe internal damage
About the 2020-2024 Ford Bronco
The 2020-2024 Ford Bronco was commonly sold with the following powertrains: 2.3L EcoBoost I4, 2.7L EcoBoost V6. Common trims include Base, Big Bend, Black Diamond, Outer Banks, Badlands, Wildtrak, Raptor.
How to tell solenoid failure from converter failure
Both produce P0741, but the symptoms differ slightly:
- Solenoid failure — RPM at cruise is exactly normal-plus-converter-slip (around 200–300 RPM high). The transmission shifts cleanly otherwise. No shudder.
- Converter slipping — RPM at cruise is variable and rises under load. Light-throttle cruise produces a shudder you can feel through the seat and the steering wheel — described by owners as “feels like driving over rumble strips.”
The shudder pattern is diagnostic: solenoid issues don’t shudder; worn TCC friction material shudders during partial lockup.
P0741 with shudder is a transmission job
Once the TCC friction lining is worn to the point of slipping under light load, the converter shedding material accelerates downstream wear in the transmission itself. Driving a P0741 with shudder for months can convert a $1,800 torque-converter-only repair into a $5,000+ rebuild. Treat shuddering P0741 as urgent.
Trans fluid changes after P0741 — proceed with caution
For decades the rule was “if the transmission is starting to fail, do NOT change the fluid — the new clean fluid washes out gunked clutch material and the transmission fails immediately.” Modern fluid technology has changed that advice. A drain-and-fill (not a flush) with the correct OEM fluid is now generally safe and sometimes resolves P0741 if the fluid was degraded. A full machine-flush on a transmission with TCC slip is still risky.