P0741 on a 2017 Ram 1500
Torque Converter Clutch Stuck Off
P0741 on a 2017 Ram 1500 indicates torque converter clutch stuck off. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is worn or burned torque converter clutch friction material (typically $1,800–$4,500). Confirm the root cause before replacing parts.
What does P0741 mean on a 2017 Ram 1500?
P0741 is set when the ECM (or TCM) commands the torque converter clutch (TCC) to lock up under cruise conditions and does not see the expected drop in engine RPM relative to vehicle speed. Effectively, the lockup clutch is being commanded but not engaging — or it engages and immediately slips. Either way the converter is running in fluid-coupling mode at highway speed when it should be mechanically locked.
This guide covers P0741 across the 2015-2019 Ram 1500 generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2015 through 2019.
Is it safe to drive a 2017 Ram 1500 with P0741?
In most cases a 2017 Ram 1500 stays drivable for short trips with P0741 active, but diagnose and repair it promptly. This is a high-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0741 on a 2017 Ram 1500?
- Check Engine Light is illuminated
- Engine RPM at highway cruise is 200–400 RPM higher than normal
- Noticeable fuel economy drop on the highway
- Possible transmission fluid overheating warning on towing
- Shudder or vibration at light-throttle cruise (slipping TCC)
- Often paired with P0700 from the TCM
What causes P0741 on a 2017 Ram 1500?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Worn or burned torque converter clutch friction material Requires torque converter replacement — major job. | Most common | $1,800–$4,500 |
| Failed TCC solenoid in the valve body | Common | $300–$900 |
| Stuck TCC control valve in the valve body | Common | $400–$1,500 |
| Low transmission fluid level or contaminated fluid | Common | $100–$400 |
| Wiring fault to the TCC solenoid | Occasional | $80–$350 |
| Failed TCM driver for the TCC solenoid | Rare | $500–$1,500 |
| Internal transmission damage allowing fluid bypass | Occasional | $2,500–$6,500 |
How to diagnose this on a 2017 Ram 1500
-
Check transmission fluid level and condition
Transmission service procedures vary widely — some vehicles require a special procedure to check fluid level at operating temperature with the engine running. Follow the vehicle's specific procedure. Fluid that smells burnt or shows clutch material indicates internal damage; no point chasing the solenoid until the fluid is right.
Tools: Vehicle-specific service procedure, Replacement fluid (if needed)
-
Verify TCC command vs. actual lockup with a scan tool
During highway cruise, watch the TCC duty cycle or commanded state, alongside engine RPM and vehicle speed. The TCC should command on around 45–55 mph and engine RPM should drop 100–300 RPM at the moment of lockup. No RPM drop confirms the TCC is not engaging mechanically.
Tools: Scan tool with TCC and live RPM PIDs
-
Test the TCC solenoid electrically
Locate the TCC solenoid in the wiring diagram (most are accessible through the transmission's external connector). Measure resistance — typical 10–30 Ω depending on the transmission. Confirm continuity and that the TCM commands voltage to the solenoid during the lockup attempt.
Tools: Multimeter, Wiring diagram
-
Inspect transmission external connector for fluid
Disconnect the external transmission connector. Fluid wicking up into the wiring harness from a failed case seal will contaminate the TCM-side connector and cause electrical faults that mimic a solenoid failure. The repair is the seal and often the harness; the solenoid itself may be fine.
Tools: Connector unlock tool, Flashlight
-
Drop the pan and inspect the magnet
A pan magnet covered in fine clutch material — especially brown or black gritty paste — indicates the torque converter clutch has been slipping and shedding material. At that point the converter must be replaced; cleaning is not a fix.
Tools: Drain pan, Socket set, New filter and gasket
NHTSA complaints & recalls for the 2017 Ram 1500
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2017 Ram 1500. Use these to gauge how common a problem is on your specific vehicle before you start chasing Ram 1500 diagnostics.
- ENGINE 154
- POWER TRAIN 97
- STEERING 215
- ELECTRICAL SYSTEM 102
- SERVICE BRAKES 91
13 active recalls
- ENGINE AND ENGINE COOLING:ENGINE:DIESEL Aug 2020
Chrysler (FCA US LLC) is recalling certain 2014-2018 Ram 1500 and 2014-2016 Jeep Grand Cherokee vehicles equipped with 3.0L diesel engines. The crankshaft position sensor tone wheel may delaminate causing the engine to lose its ability to synchronize the fuel injector pulses and…
NHTSA campaign 20V475000 - LATCHES/LOCKS/LINKAGES:TAILGATE:LATCH May 2019
Chrysler (FCA US LLC) is recalling certain 2015-2017 Ram 1500, 2500 and 3500 pickup trucks equipped with an 8 foot bed and a power locking tailgate. Chrysler is also recalling all 2013-2014 and 2018 Ram 1500, 2500 and 3500 pickup trucks built before April 1, 2018 with a 6 or 8 f…
NHTSA campaign 19V347000 - STRUCTURE:BODY:TAILGATE Jul 2018
Chrysler (FCA US LLC) is recalling certain 2015-2017 RAM 1500, 2500, and 3500 pickup trucks equipped with a power locking tailgate and either a 5 foot, 7 inch or 6 foot, 4 inch bed. The tailgate actuator limiter tab may fracture and cause the tailgate to unlatch and open while d…
NHTSA campaign 18V486000 - ELECTRICAL SYSTEM:WIRING May 2018
Chrysler (FCA US LLC) is recalling certain 2014-2018 Dodge Journey, Charger and Durango, RAM 2500, 3500, 3500 Cab Chassis (more than 10,000lb), 4500 Cab Chassis and 5500 Cab Chassis, Jeep Cherokee and Grand Cherokee and Chrysler 300, 2014-2019 RAM 1500, 2015-2018 Dodge Challenger…
NHTSA campaign 18V332000
How do I fix P0741 on a 2017 Ram 1500?
- Service transmission fluid and filter to the correct specification
- Replace the TCC solenoid (often part of a solenoid pack)
- Repair external transmission wiring or connector
- Replace the torque converter (and usually rebuild the transmission)
- Rebuild or replace the transmission for severe internal damage
About the 2015-2019 Ram 1500
The 2015-2019 Ram 1500 was commonly sold with the following powertrains: 5.7L HEMI V8, 3.6L V6, 3.0L EcoDiesel V6. Common trims include Tradesman, Big Horn, Laramie, Rebel, Limited.
How to tell solenoid failure from converter failure
Both produce P0741, but the symptoms differ slightly:
- Solenoid failure — RPM at cruise is exactly normal-plus-converter-slip (around 200–300 RPM high). The transmission shifts cleanly otherwise. No shudder.
- Converter slipping — RPM at cruise is variable and rises under load. Light-throttle cruise produces a shudder you can feel through the seat and the steering wheel — described by owners as “feels like driving over rumble strips.”
The shudder pattern is diagnostic: solenoid issues don’t shudder; worn TCC friction material shudders during partial lockup.
P0741 with shudder is a transmission job
Once the TCC friction lining is worn to the point of slipping under light load, the converter shedding material accelerates downstream wear in the transmission itself. Driving a P0741 with shudder for months can convert a $1,800 torque-converter-only repair into a $5,000+ rebuild. Treat shuddering P0741 as urgent.
Trans fluid changes after P0741 — proceed with caution
For decades the rule was “if the transmission is starting to fail, do NOT change the fluid — the new clean fluid washes out gunked clutch material and the transmission fails immediately.” Modern fluid technology has changed that advice. A drain-and-fill (not a flush) with the correct OEM fluid is now generally safe and sometimes resolves P0741 if the fluid was degraded. A full machine-flush on a transmission with TCC slip is still risky.
P0741 on a 2017 Ram 1500: frequently asked questions
What does diagnostic trouble code P0741 mean on a 2017 Ram 1500?
P0741 is set when the ECM (or TCM) commands the torque converter clutch (TCC) to lock up under cruise conditions and does not see the expected drop in engine RPM relative to vehicle speed. Effectively, the lockup clutch is being commanded but not engaging — or it engages and immediately slips. Either way the converter is running in fluid-coupling mode at highway speed when it should be mechanically locked.
What are the symptoms of P0741 on a 2017 Ram 1500?
Check Engine Light is illuminated. Engine RPM at highway cruise is 200–400 RPM higher than normal. Noticeable fuel economy drop on the highway. Possible transmission fluid overheating warning on towing. Shudder or vibration at light-throttle cruise (slipping TCC). Often paired with P0700 from the TCM
What causes P0741 on a 2017 Ram 1500?
Worn or burned torque converter clutch friction material (most-common). Failed TCC solenoid in the valve body (common). Stuck TCC control valve in the valve body (common). Low transmission fluid level or contaminated fluid (common). Wiring fault to the TCC solenoid (occasional). Failed TCM driver for the TCC solenoid (rare). Internal transmission damage allowing fluid bypass (occasional)
Is it safe to drive a 2017 Ram 1500 with P0741?
In most cases a 2017 Ram 1500 stays drivable for short trips with P0741 active, but it should be diagnosed and repaired promptly — this is a high-severity code. Ignoring it can lead to further damage or a failed emissions test.