P0741 on a 2017 Kia Sportage

Torque Converter Clutch Stuck Off

P0741 on a 2017 Kia Sportage indicates torque converter clutch stuck off. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is worn or burned torque converter clutch friction material (typically $1,800–$4,500). Confirm the root cause before replacing parts.

Severity: high Safe to drive (short term) Compact SUV 2015-2019 Kia Sportage

Reviewed by MECH AI Editorial · Last verified

What does P0741 mean on a 2017 Kia Sportage?

P0741 is set when the ECM (or TCM) commands the torque converter clutch (TCC) to lock up under cruise conditions and does not see the expected drop in engine RPM relative to vehicle speed. Effectively, the lockup clutch is being commanded but not engaging — or it engages and immediately slips. Either way the converter is running in fluid-coupling mode at highway speed when it should be mechanically locked.

This guide covers P0741 across the 2015-2019 Kia Sportage generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2015 through 2019.

Is it safe to drive a 2017 Kia Sportage with P0741?

In most cases a 2017 Kia Sportage stays drivable for short trips with P0741 active, but diagnose and repair it promptly. This is a high-severity code — ignoring it can lead to further damage or a failed emissions test.

What are the symptoms of P0741 on a 2017 Kia Sportage?

What causes P0741 on a 2017 Kia Sportage?

Cause Likelihood Estimated repair (USD)
Worn or burned torque converter clutch friction material Requires torque converter replacement — major job. Most common $1,800–$4,500
Failed TCC solenoid in the valve body Common $300–$900
Stuck TCC control valve in the valve body Common $400–$1,500
Low transmission fluid level or contaminated fluid Common $100–$400
Wiring fault to the TCC solenoid Occasional $80–$350
Failed TCM driver for the TCC solenoid Rare $500–$1,500
Internal transmission damage allowing fluid bypass Occasional $2,500–$6,500

How to diagnose this on a 2017 Kia Sportage

  1. Check transmission fluid level and condition

    Transmission service procedures vary widely — some vehicles require a special procedure to check fluid level at operating temperature with the engine running. Follow the vehicle's specific procedure. Fluid that smells burnt or shows clutch material indicates internal damage; no point chasing the solenoid until the fluid is right.

    Tools: Vehicle-specific service procedure, Replacement fluid (if needed)

  2. Verify TCC command vs. actual lockup with a scan tool

    During highway cruise, watch the TCC duty cycle or commanded state, alongside engine RPM and vehicle speed. The TCC should command on around 45–55 mph and engine RPM should drop 100–300 RPM at the moment of lockup. No RPM drop confirms the TCC is not engaging mechanically.

    Tools: Scan tool with TCC and live RPM PIDs

  3. Test the TCC solenoid electrically

    Locate the TCC solenoid in the wiring diagram (most are accessible through the transmission's external connector). Measure resistance — typical 10–30 Ω depending on the transmission. Confirm continuity and that the TCM commands voltage to the solenoid during the lockup attempt.

    Tools: Multimeter, Wiring diagram

  4. Inspect transmission external connector for fluid

    Disconnect the external transmission connector. Fluid wicking up into the wiring harness from a failed case seal will contaminate the TCM-side connector and cause electrical faults that mimic a solenoid failure. The repair is the seal and often the harness; the solenoid itself may be fine.

    Tools: Connector unlock tool, Flashlight

  5. Drop the pan and inspect the magnet

    A pan magnet covered in fine clutch material — especially brown or black gritty paste — indicates the torque converter clutch has been slipping and shedding material. At that point the converter must be replaced; cleaning is not a fix.

    Tools: Drain pan, Socket set, New filter and gasket

NHTSA complaints & recalls for the 2017 Kia Sportage

Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2017 Kia Sportage. Use these to gauge how common a problem is on your specific vehicle before you start chasing Kia Sportage diagnostics.

387 owner complaints
14 involved a crash
25 involved a fire
18 reported injuries
  • ENGINE 211
  • POWER TRAIN 40
  • UNKNOWN OR OTHER 68
  • ELECTRICAL SYSTEM 61
  • SERVICE BRAKES 24

4 active recalls

  • FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS Dec 2018

    Kia Motors America (Kia) is recalling certain 2011-2017 Optima, 2012-2017 Sorento and 2011-2018 Sportage vehicles that previously received an engine replacement under recall number 17V-224, warranty, or the Knock Sensor Detection System (KSDS) Product Improvement Campaign. The h…

    NHTSA campaign 18V907000
  • SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:CONTROL UNIT/MODULE Mar 2021

    Kia Motors America (Kia) is recalling certain 2017-2021 Sportage and Cadenza vehicles. The electrical circuit in the Hydraulic Electronic Control Unit (HECU) may short-circuit, which can cause a fire in the engine compartment.…

    NHTSA campaign 21V137000
  • TRAILER HITCHES Nov 2016

    Kia Motors America (Kia) is recalling certain model year 2016-2017 Sorento vehicles manufactured October 27, 2014, to August 25, 2016, and 2017 Sportage vehicles manufactured December 10, 2015, to August 26, 2016. The affected vehicles are equipped with an accessory trailer hitc…

    NHTSA campaign 16V862000
  • TRAILER HITCHES Sep 2022

    Kia America, Inc. (Kia) is recalling certain 2016-2022 Sorento, 2021-2022 Sorento Hybrid (HEV), 2022-2023 Sorento Plug-In Hybrid (PHEV), and 2017-2022 Sportage vehicles equipped with a tow hitch harness installed as original equipment, or purchased as an accessory through a Kia d…

    NHTSA campaign 22V703000

How do I fix P0741 on a 2017 Kia Sportage?

About the 2015-2019 Kia Sportage

The 2015-2019 Kia Sportage was commonly sold with the following powertrains: 2.5L I4, 1.6L Turbo I4, 1.6L Hybrid I4. Common trims include LX, EX, X-Line, SX, X-Pro.

How to tell solenoid failure from converter failure

Both produce P0741, but the symptoms differ slightly:

The shudder pattern is diagnostic: solenoid issues don’t shudder; worn TCC friction material shudders during partial lockup.

P0741 with shudder is a transmission job

Once the TCC friction lining is worn to the point of slipping under light load, the converter shedding material accelerates downstream wear in the transmission itself. Driving a P0741 with shudder for months can convert a $1,800 torque-converter-only repair into a $5,000+ rebuild. Treat shuddering P0741 as urgent.

Trans fluid changes after P0741 — proceed with caution

For decades the rule was “if the transmission is starting to fail, do NOT change the fluid — the new clean fluid washes out gunked clutch material and the transmission fails immediately.” Modern fluid technology has changed that advice. A drain-and-fill (not a flush) with the correct OEM fluid is now generally safe and sometimes resolves P0741 if the fluid was degraded. A full machine-flush on a transmission with TCC slip is still risky.

Related diagnostic codes