P0700 on Hyundai vehicles
Transmission Control System Malfunction — what it means on a Hyundai, whether it's safe to drive, and the fixes by model and year.
P0700 on a Hyundai means transmission control system malfunction. Most vehicles stay drivable short-term, but diagnose it promptly. The most common cause is low or burnt transmission fluid (typically $100–$350). Pick your Hyundai model below for its known failure patterns, recalls, and TSBs.
What does P0700 mean on a Hyundai?
P0700 is an "informational" code set by the engine control module when the transmission control module (TCM) reports any fault. P0700 itself does not identify a specific transmission problem — it is a flag that tells you to scan the TCM for the underlying code or codes. The actual fault could be anything from a shift solenoid failure to a slipping clutch pack to a low-fluid condition.
P0700 is a standardized OBD-II code, so its definition is the same on every Hyundai. What differs by model and engine is which cause is most likely — pick your Hyundai model below for a diagnosis tuned to its known failure patterns, recalls, and TSBs.
Is it safe to drive a Hyundai with P0700?
In most cases a Hyundai stays drivable for short trips with P0700 active, but diagnose and repair it promptly. This is a high-severity code — ignoring it can lead to further damage or a failed emissions test. Exact tolerance depends on the model and engine.
What causes P0700 on a Hyundai?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Low or burnt transmission fluid — Always check fluid level and condition first; many P0700s clear with a fluid and filter service. | Most common | $100–$350 |
| Failed shift solenoid (one or more) | Common | $250–$900 |
| Failed transmission speed sensor (input or output) | Common | $150–$500 |
| Worn or stuck valve body | Occasional | $600–$2,000 |
| Internal mechanical wear — slipping clutch packs or bands | Occasional | $2,500–$6,000 |
| Failed transmission control module (TCM) itself | Rare | $500–$1,500 |
| Wiring harness damage to TCM or solenoid pack | Occasional | $200–$700 |
Repair costs are typical US ranges and vary by Hyundai model, model year, and labor rate. A diagnostic trouble code is a symptom, not a guaranteed failed part — confirm the root cause before replacing anything.
P0700 by Hyundai model
Select your Hyundai model and year for a P0700 diagnosis tuned to that vehicle's failure patterns, recalls, and TSBs.
Hyundai Elantra
1,515 NHTSA owner complaints · 13 recalls on record across the years covered below.
Hyundai Tucson
1,671 NHTSA owner complaints · 9 recalls on record across the years covered below.
Hyundai Santa Fe
1,450 NHTSA owner complaints · 12 recalls on record across the years covered below.
Complaint and recall counts are NHTSA totals for the model years covered on this site, not counts specific to P0700.
P0700 on other makes
Other codes on Hyundai vehicles
P0700 on a Hyundai: frequently asked questions
What does diagnostic trouble code P0700 mean on a Hyundai?
P0700 is an "informational" code set by the engine control module when the transmission control module (TCM) reports any fault. P0700 itself does not identify a specific transmission problem — it is a flag that tells you to scan the TCM for the underlying code or codes. The actual fault could be anything from a shift solenoid failure to a slipping clutch pack to a low-fluid condition. P0700 is a standardized OBD-II code, so the definition is the same on every Hyundai — which cause is most likely varies by model and engine.
What are the symptoms of P0700 on a Hyundai?
Check Engine Light is illuminated. Transmission stuck in a single gear (often 3rd or 4th — "limp mode"). Hard, delayed, or erratic shifts. Torque converter clutch not locking up on the highway. Higher than normal RPM at cruise. Reduced fuel economy. Possible transmission slipping under load
What causes P0700 on a Hyundai?
Low or burnt transmission fluid (most-common). Failed shift solenoid (one or more) (common). Failed transmission speed sensor (input or output) (common). Worn or stuck valve body (occasional). Internal mechanical wear — slipping clutch packs or bands (occasional). Failed transmission control module (TCM) itself (rare). Wiring harness damage to TCM or solenoid pack (occasional)
Is it safe to drive a Hyundai with P0700?
In most cases a Hyundai stays drivable for short trips with P0700 active, but it should be diagnosed and repaired promptly — this is a high-severity code. Ignoring it can lead to further damage or a failed emissions test. Exact tolerance depends on the model and engine.