P0411 on a 2022 Honda HR-V

Secondary Air Injection Insufficient Flow

P0411 on a 2022 Honda HR-V indicates secondary air injection insufficient flow. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is failed secondary air injection pump motor (typically $300–$1,200). Confirm the root cause before replacing parts.

Severity: low Safe to drive (short term) Subcompact SUV 2020-2024 Honda HR-V

Reviewed by MECH AI Editorial · Last verified

What does P0411 mean on a 2022 Honda HR-V?

P0411 is set when the engine control module commands the secondary air injection (SAI) system to inject air into the exhaust during cold start and does not detect the expected oxygen reading at the upstream O2 sensors. The SAI system is a separate pump that blows fresh air into the exhaust manifold for the first 60–90 seconds after cold start, helping the catalyst light off faster and reducing cold-start emissions. P0411 means that air injection is not happening — usually because the SAI pump, check valve, or control valve has failed.

This guide covers P0411 across the 2020-2024 Honda HR-V generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2020 through 2024.

Is it safe to drive a 2022 Honda HR-V with P0411?

In most cases a 2022 Honda HR-V stays drivable for short trips with P0411 active, but diagnose and repair it promptly. This is a low-severity code — ignoring it can lead to further damage or a failed emissions test.

What are the symptoms of P0411 on a 2022 Honda HR-V?

What causes P0411 on a 2022 Honda HR-V?

Cause Likelihood Estimated repair (USD)
Failed secondary air injection pump motor Particularly common on VW, Audi, BMW, Porsche, and Mercedes vehicles. Most common $300–$1,200
Stuck or seized SAI combination valve / check valve Common $200–$700
SAI vacuum control solenoid failure Common $80–$350
Cracked or disconnected SAI hose Common $50–$300
Carbon-clogged SAI passages in the exhaust manifold Occasional $400–$1,500
Failed SAI relay Occasional $30–$150
Wiring fault to the SAI pump or solenoid Occasional $80–$350

How to diagnose this on a 2022 Honda HR-V

  1. Listen for the SAI pump on cold start

    On a cold engine (sat overnight), start the vehicle and listen for the SAI pump — a distinct whirring or humming sound from under the hood for 60–90 seconds. Silence at cold start means the pump is not running. Note: SAI does not operate on warm restarts, so the test only works on a truly cold engine.

    Tools: Cold engine (sat overnight)

  2. Test the SAI pump electrically

    Locate the SAI pump (often in the engine bay or under a fender liner). Disconnect the connector and apply 12 V directly. A working pump runs immediately. Silence confirms a dead pump.

    Tools: Jumper wires, 12 V supply (battery)

  3. Inspect the SAI hose

    Trace the air hose from the pump to the exhaust manifold area. Cracks, splits, or disconnections are common — especially on rubber hoses that have spent 10+ years near hot exhaust components. A failed hose means the pump runs but no air reaches the exhaust.

    Tools: Flashlight, Inspection mirror

  4. Test the combination / check valve

    The SAI combination valve prevents exhaust from back-feeding into the pump. Remove and inspect — should freely allow air in one direction and seal in the other. Carbon buildup on the valve from years of exhaust exposure is the typical failure mode.

    Tools: Service manual procedure, Carb cleaner

  5. Read freeze-frame conditions

    Note the engine temperature, vehicle speed, and time-since- start in the freeze frame. P0411 only sets within the cold- start enrichment window. If freeze frame shows the engine already warm, suspect a sensor or wiring issue rather than the pump itself.

    Tools: Scan tool with freeze-frame data

NHTSA complaints & recalls for the 2022 Honda HR-V

Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2022 Honda HR-V. Use these to gauge how common a problem is on your specific vehicle before you start chasing Honda HR-V diagnostics.

74 owner complaints
10 involved a crash
1 involved a fire
8 reported injuries
  • ENGINE 16
  • POWER TRAIN 14
  • VEHICLE SPEED CONTROL 12
  • ELECTRICAL SYSTEM 24
  • UNKNOWN OR OTHER 14

3 active recalls

  • BACK OVER PREVENTION:DISPLAY FUNCTION Feb 2023

    Honda (American Honda Motor Co.) is recalling certain 2018-2020 Fit and 2019-2022 HR-V vehicles. The rearview camera image may not display when the engine is started with a key, due to a design error in the audio display power circuit. As such, these vehicles fail to comply wit…

    NHTSA campaign 23V046000
  • AIR BAGS:SENSOR:OCCUPANT CLASSIFICATION:FRONT PASSENGER Feb 2024

    Honda (American Honda Motor Co.) is recalling certain 2020-2022 Pilot, Accord, Civic sedan, HR-V, Odyssey, 2020 Civic coupe, Fit, 2021-2022 Civic hatchback, 2021 Civic Type R, Insight, 2020-2021 CR-V, CR-V Hybrid, Passport, Ridgeline, Accord Hybrid, 2020 Acura MDX, 2022 Acura MDX…

    NHTSA campaign 24V064000
  • BACK OVER PREVENTION:DISPLAY FUNCTION May 2024

    Honda (America Honda Motor Co.) is recalling certain 2018-2020 Fit and 2019-2022 HR-V vehicles that were previously recalled under NHTSA recall number 23V-046. The rearview camera image may not display when the engine is started with a key, due to a design error in the audio dis…

    NHTSA campaign 24V384000

How do I fix P0411 on a 2022 Honda HR-V?

About the 2020-2024 Honda HR-V

The 2020-2024 Honda HR-V was commonly sold with the following powertrains: 1.8L I4, 2.0L I4. Common trims include LX, Sport, EX, EX-L.

Why P0411 is rare in the US fleet but common on European cars

US-market vehicles largely phased out secondary air injection in the 2010s as more efficient catalyst designs made it unnecessary. European-market vehicles continued using SAI well into the 2020s for tighter Euro 6 standards. As a result:

If P0411 sets on a US-spec vehicle from the late 2010s or newer, double-check that the vehicle actually has an SAI system before diagnosing.

Carbon clogging in SAI passages

A common longer-term failure mode: SAI passages in the exhaust manifold accumulate carbon over years of use. Eventually airflow is restricted enough that even a working pump cannot deliver enough oxygen to the upstream O2 sensors during cold start. Cleaning the passages requires manifold removal — labor intensive. Some shops decline this repair and quote a full SAI delete (where legally permitted).

Drive cycle to verify a P0411 repair

P0411 only re-sets during cold-start enrichment. After any repair:

  1. Cold soak the engine 8+ hours
  2. Cold start and idle 2.5 minutes
  3. Drive a normal cycle, return home
  4. Repeat for 2-3 cold starts before assuming the fix held

A single warm-restart test cannot reproduce or rule out P0411.

Related diagnostic codes