P0174 on a 2017 Toyota Highlander
Fuel System Too Lean (Bank 2)
P0174 on a 2017 Toyota Highlander indicates fuel system too lean (bank 2). It usually stays drivable short-term but should be diagnosed promptly. The most common cause is vacuum leak specific to bank 2 (intake gasket, vacuum tee, brake-booster tee) (typically $80–$600). Confirm the root cause before replacing parts.
What does P0174 mean on a 2017 Toyota Highlander?
P0174 is the Bank 2 counterpart of P0171. It is set when the engine control module sees long-term fuel trim on Bank 2 driven beyond approximately +25 %. The ECM is adding the maximum allowed amount of fuel and the Bank 2 oxygen sensor still reports lean. Because P0174 only applies to V-engines and engines with separate exhaust banks, whether P0174 appears alongside P0171 tells you a lot about the root cause.
This guide covers P0174 across the 2015-2019 Toyota Highlander generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2015 through 2019.
Is it safe to drive a 2017 Toyota Highlander with P0174?
In most cases a 2017 Toyota Highlander stays drivable for short trips with P0174 active, but diagnose and repair it promptly. This is a moderate-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0174 on a 2017 Toyota Highlander?
- Check Engine Light is illuminated
- Rough idle, especially when cold
- Hesitation or stumble on light acceleration
- Reduced fuel economy
- Mild power loss
- Possible whistling vacuum-leak sound
What causes P0174 on a 2017 Toyota Highlander?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Vacuum leak specific to Bank 2 (intake gasket, vacuum tee, brake-booster tee) | Most common | $80–$600 |
| Cracked plastic intake manifold on V-engines (common on Ford and Chrysler V6/V8s) | Common | $250–$900 |
| Bank 2 fuel injectors clogged or under-delivering | Common | $150–$1,200 |
| Bank 2 upstream O2 sensor lazy or biased lean | Common | $150–$450 |
| Bank 2 exhaust leak upstream of the front O2 sensor | Occasional | $100–$500 |
| Weak fuel pump or clogged filter (both banks lean — P0171 also present) | Occasional | $80–$900 |
| PCV system fault drawing extra air into Bank 2 | Occasional | $30–$200 |
How to diagnose this on a 2017 Toyota Highlander
-
Determine whether P0171 is also present
Pull all codes. If P0174 sets alone, the cause is on Bank 2 specifically — an intake leak on that side, injectors on that side, or the Bank 2 O2 sensor. If P0171 and P0174 set together, the cause is something affecting the whole engine: low fuel pressure, MAF issue, large vacuum leak.
Tools: Scan tool
-
Identify the Bank 2 side of the engine
On most transverse V6s Bank 2 is the bank closest to the radiator. On Ford modular V8s Bank 2 is the passenger side. On GM truck V8s Bank 2 is the passenger side. Confirm in the service manual before pulling parts.
Tools: Vehicle-specific service information
-
Smoke-test the Bank 2 intake side
With smoke in the intake, focus on the Bank 2 intake runner gaskets, the vacuum lines that feed Bank 2 specifically, and the brake booster line if it tees into Bank 2. Cracked plastic intake manifolds on Ford 4.6 V8s, Chrysler 4.0 inline-6, and several GM engines are classic Bank-2-specific P0174 causes.
Tools: EVAP / intake smoke machine, Flashlight and mirror
-
Compare Bank 1 vs Bank 2 fuel trims
With the engine warm, read Bank 1 LTFT and Bank 2 LTFT simultaneously. A 10 %+ difference between banks isolates the problem to the bank with the higher positive number.
Tools: Scan tool with multi-PID display
-
Test Bank 2 injectors for low flow
Run the scan tool injector balance test on Bank 2 injectors only. An injector that does not produce as much pressure drop as its peers is under-delivering fuel and causing the bank-specific lean condition.
Tools: Scan tool with injector balance
NHTSA complaints & recalls for the 2017 Toyota Highlander
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2017 Toyota Highlander. Use these to gauge how common a problem is on your specific vehicle before you start chasing Toyota Highlander diagnostics.
- POWER TRAIN 68
- ENGINE 43
- UNKNOWN OR OTHER 49
- ELECTRICAL SYSTEM 46
- SERVICE BRAKES 29
4 active recalls
- ELECTRICAL SYSTEM Nov 2018
Fujian Wanda Automobile Glass Industry (Wanda) is recalling certain aftermarket Replacement Windshields sold for use in 2014-2018 Toyota Highlander vehicles. The windshields have an attached wire harness that water may leak into, possibly causing damage to the vehicle's Engine C…
NHTSA campaign 18E107000 - EQUIPMENT Aug 2017
Gulf States Toyota, Inc. (GST) is recalling certain 2017 Toyota Highlander and Highlander Hybrid vehicles equipped with accessory roof rail cross bars. The fasteners for the roof rails may not be torqued properly.…
NHTSA campaign 17V520000 - TIRES:TEMPORARY/EMERGENCY SPARE TIRE May 2017
Gulf States Toyota, Inc. (Gulf States) is recalling certain 2017 4Runner , 86, Avalon, Camry, Camry Hybrid, Corolla, Corolla iM, Highlander, Highlander Hybrid, Prius, Prius C, RAV4, RAV4 Hybrid, Sienna and Yaris vehicles. The spare tire air pressure was not adjusted to the prop…
NHTSA campaign 17V295000 - FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP Nov 2020
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2018-2019 4Runner, 2019-2020 Avalon, 2019 Corolla Hatchback, 2017-2019 Highlander, 2018-2020 Camry, 2020 Corolla, 2018-2019 Land Cruiser, 2017-2020 Tacoma, 2019-2020 RAV4, 2019-2020 Sequoia, 2017-2020 Sienna,…
NHTSA campaign 20V682000
How do I fix P0174 on a 2017 Toyota Highlander?
- Repair Bank 2 vacuum / intake leaks
- Replace cracked plastic intake manifold (model-specific)
- Clean or replace Bank 2 fuel injectors
- Replace the Bank 2 upstream O2 sensor
- Repair Bank 2 exhaust leaks
About the 2015-2019 Toyota Highlander
The 2015-2019 Toyota Highlander was commonly sold with the following powertrains: 3.5L V6, 2.4L Turbo I4, 2.5L Hybrid I4. Common trims include L, LE, XLE, XSE, Limited, Platinum.
P0171 + P0174 together vs. P0174 alone
The presence pattern is your best diagnostic clue:
- Both P0171 and P0174 active → systemic problem affecting both banks. Check the MAF, fuel pressure, large vacuum leaks (brake booster, PCV hose, throttle body gasket), and the common air intake.
- Only P0174 active → Bank-2-specific problem. Inspect Bank 2 intake gaskets, Bank 2 injectors, Bank 2 O2 sensor, and Bank 2 exhaust upstream of the front sensor.
Why cracked intake manifolds are so common
Plastic intake manifolds began appearing in the mid-1990s for weight and heat-soak benefits. Two decades of thermal cycling has caused many of them to crack — particularly Ford 4.6 V8 (cracked coolant passage near the EGR tube), Chrysler 4.0 inline-6 (rear of the manifold), and GM 3.6 V6. The crack is often invisible to the eye and only shows up under smoke pressure.
Driving with P0174 long-term
Like P0171, mild long-term lean operation does not destroy the engine quickly, but sustained lean conditions raise combustion temperatures. The risks build over months: pinged spark plug electrodes, eventual catalyst damage, and burnt exhaust valves on the affected bank. Fix P0174 within a few weeks rather than letting it ride for a year.