P0174 on a 2012 Honda Pilot

Fuel System Too Lean (Bank 2)

P0174 on a 2012 Honda Pilot indicates fuel system too lean (bank 2). It usually stays drivable short-term but should be diagnosed promptly. The most common cause is vacuum leak specific to bank 2 (intake gasket, vacuum tee, brake-booster tee) (typically $80–$600). Confirm the root cause before replacing parts.

Severity: moderate Safe to drive (short term) Mid-size SUV 2010-2014 Honda Pilot

Reviewed by MECH AI Editorial · Last verified

What does P0174 mean on a 2012 Honda Pilot?

P0174 is the Bank 2 counterpart of P0171. It is set when the engine control module sees long-term fuel trim on Bank 2 driven beyond approximately +25 %. The ECM is adding the maximum allowed amount of fuel and the Bank 2 oxygen sensor still reports lean. Because P0174 only applies to V-engines and engines with separate exhaust banks, whether P0174 appears alongside P0171 tells you a lot about the root cause.

This guide covers P0174 across the 2010-2014 Honda Pilot generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2010 through 2014.

Is it safe to drive a 2012 Honda Pilot with P0174?

In most cases a 2012 Honda Pilot stays drivable for short trips with P0174 active, but diagnose and repair it promptly. This is a moderate-severity code — ignoring it can lead to further damage or a failed emissions test.

What are the symptoms of P0174 on a 2012 Honda Pilot?

What causes P0174 on a 2012 Honda Pilot?

Cause Likelihood Estimated repair (USD)
Vacuum leak specific to Bank 2 (intake gasket, vacuum tee, brake-booster tee) Most common $80–$600
Cracked plastic intake manifold on V-engines (common on Ford and Chrysler V6/V8s) Common $250–$900
Bank 2 fuel injectors clogged or under-delivering Common $150–$1,200
Bank 2 upstream O2 sensor lazy or biased lean Common $150–$450
Bank 2 exhaust leak upstream of the front O2 sensor Occasional $100–$500
Weak fuel pump or clogged filter (both banks lean — P0171 also present) Occasional $80–$900
PCV system fault drawing extra air into Bank 2 Occasional $30–$200

How to diagnose this on a 2012 Honda Pilot

  1. Determine whether P0171 is also present

    Pull all codes. If P0174 sets alone, the cause is on Bank 2 specifically — an intake leak on that side, injectors on that side, or the Bank 2 O2 sensor. If P0171 and P0174 set together, the cause is something affecting the whole engine: low fuel pressure, MAF issue, large vacuum leak.

    Tools: Scan tool

  2. Identify the Bank 2 side of the engine

    On most transverse V6s Bank 2 is the bank closest to the radiator. On Ford modular V8s Bank 2 is the passenger side. On GM truck V8s Bank 2 is the passenger side. Confirm in the service manual before pulling parts.

    Tools: Vehicle-specific service information

  3. Smoke-test the Bank 2 intake side

    With smoke in the intake, focus on the Bank 2 intake runner gaskets, the vacuum lines that feed Bank 2 specifically, and the brake booster line if it tees into Bank 2. Cracked plastic intake manifolds on Ford 4.6 V8s, Chrysler 4.0 inline-6, and several GM engines are classic Bank-2-specific P0174 causes.

    Tools: EVAP / intake smoke machine, Flashlight and mirror

  4. Compare Bank 1 vs Bank 2 fuel trims

    With the engine warm, read Bank 1 LTFT and Bank 2 LTFT simultaneously. A 10 %+ difference between banks isolates the problem to the bank with the higher positive number.

    Tools: Scan tool with multi-PID display

  5. Test Bank 2 injectors for low flow

    Run the scan tool injector balance test on Bank 2 injectors only. An injector that does not produce as much pressure drop as its peers is under-delivering fuel and causing the bank-specific lean condition.

    Tools: Scan tool with injector balance

NHTSA complaints & recalls for the 2012 Honda Pilot

Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2012 Honda Pilot. Use these to gauge how common a problem is on your specific vehicle before you start chasing Honda Pilot diagnostics.

170 owner complaints
17 involved a crash
3 involved a fire
19 reported injuries
  • ENGINE 35
  • POWER TRAIN 20
  • VEHICLE SPEED CONTROL 17
  • SERVICE BRAKES 28
  • ELECTRICAL SYSTEM 22

9 active recalls

  • AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE Sep 2018

    Honda (American Honda Motor Co.) is recalling certain 2014 Honda Insight and Acura TSX and TSX Wagon, 2014-2015 Honda Crosstour and Pilot vehicles nationwide, as well as certain 2014 Honda FCX Clarity and Fit EV vehicles in Florida, Hawaii, Puerto Rico, Texas, Alabama, Georgia, L…

    NHTSA campaign 18V661000
  • AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE Apr 2018

    Honda (American Honda Motor Co.) is recalling certain 2003-2012 Honda Accord and Pilot, 2010 Accord Crosstour, 2001-2011 Civic, 2002-2011 CR-V, 2003-2004, 2006-2008 and 2011 Element, 2007 and 2009-2013 Fit, 2010-2012 Insight, 2002-2004 Odyssey, and 2012 Ridgeline vehicles. The f…

    NHTSA campaign 18V268000
  • AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE Jun 2019

    Honda (American Honda Motor Co.) is recalling certain 2009-2014 Acura TSX, 2011-2014 TSX Sport Wagon, 2010-2013 ZDX, 2008-2012 Honda Accord, 2010-2011 Accord Crosstour, 2006-2011 Civic and Civic Hybrid, 2008-2010 Civic GX NGV, 2012-2015 Crosstour, 2007-2011 CR-V, 2009-2013 Fit, 2…

    NHTSA campaign 19V502000
  • AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE May 2019

    Honda (American Honda Motor Co.) is recalling certain 2009-2014 Acura TSX, 2011-2013 TSX Sport Wagon, and 2010-2012 ZDX and 2008-2012 Honda Accord, 2010-2011 Accord Crosstour, 2006-2011 Civic, Civic Hybrid and Civic NGV, 2012-2014 Crosstour, 2007-2011 CR-V, 2009-2013 Fit, 2010-20…

    NHTSA campaign 19V378000

How do I fix P0174 on a 2012 Honda Pilot?

About the 2010-2014 Honda Pilot

The 2010-2014 Honda Pilot was commonly sold with the following powertrains: 3.5L V6. Common trims include LX, EX, EX-L, Touring, Elite, TrailSport.

P0171 + P0174 together vs. P0174 alone

The presence pattern is your best diagnostic clue:

Why cracked intake manifolds are so common

Plastic intake manifolds began appearing in the mid-1990s for weight and heat-soak benefits. Two decades of thermal cycling has caused many of them to crack — particularly Ford 4.6 V8 (cracked coolant passage near the EGR tube), Chrysler 4.0 inline-6 (rear of the manifold), and GM 3.6 V6. The crack is often invisible to the eye and only shows up under smoke pressure.

Driving with P0174 long-term

Like P0171, mild long-term lean operation does not destroy the engine quickly, but sustained lean conditions raise combustion temperatures. The risks build over months: pinged spark plug electrodes, eventual catalyst damage, and burnt exhaust valves on the affected bank. Fix P0174 within a few weeks rather than letting it ride for a year.

Related diagnostic codes