P0174 on a 2012 Honda Odyssey
Fuel System Too Lean (Bank 2)
P0174 on a 2012 Honda Odyssey indicates fuel system too lean (bank 2). It usually stays drivable short-term but should be diagnosed promptly. The most common cause is vacuum leak specific to bank 2 (intake gasket, vacuum tee, brake-booster tee) (typically $80–$600). Confirm the root cause before replacing parts.
What does P0174 mean on a 2012 Honda Odyssey?
P0174 is the Bank 2 counterpart of P0171. It is set when the engine control module sees long-term fuel trim on Bank 2 driven beyond approximately +25 %. The ECM is adding the maximum allowed amount of fuel and the Bank 2 oxygen sensor still reports lean. Because P0174 only applies to V-engines and engines with separate exhaust banks, whether P0174 appears alongside P0171 tells you a lot about the root cause.
This guide covers P0174 across the 2010-2014 Honda Odyssey generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2010 through 2014.
Is it safe to drive a 2012 Honda Odyssey with P0174?
In most cases a 2012 Honda Odyssey stays drivable for short trips with P0174 active, but diagnose and repair it promptly. This is a moderate-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0174 on a 2012 Honda Odyssey?
- Check Engine Light is illuminated
- Rough idle, especially when cold
- Hesitation or stumble on light acceleration
- Reduced fuel economy
- Mild power loss
- Possible whistling vacuum-leak sound
What causes P0174 on a 2012 Honda Odyssey?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Vacuum leak specific to Bank 2 (intake gasket, vacuum tee, brake-booster tee) | Most common | $80–$600 |
| Cracked plastic intake manifold on V-engines (common on Ford and Chrysler V6/V8s) | Common | $250–$900 |
| Bank 2 fuel injectors clogged or under-delivering | Common | $150–$1,200 |
| Bank 2 upstream O2 sensor lazy or biased lean | Common | $150–$450 |
| Bank 2 exhaust leak upstream of the front O2 sensor | Occasional | $100–$500 |
| Weak fuel pump or clogged filter (both banks lean — P0171 also present) | Occasional | $80–$900 |
| PCV system fault drawing extra air into Bank 2 | Occasional | $30–$200 |
How to diagnose this on a 2012 Honda Odyssey
-
Determine whether P0171 is also present
Pull all codes. If P0174 sets alone, the cause is on Bank 2 specifically — an intake leak on that side, injectors on that side, or the Bank 2 O2 sensor. If P0171 and P0174 set together, the cause is something affecting the whole engine: low fuel pressure, MAF issue, large vacuum leak.
Tools: Scan tool
-
Identify the Bank 2 side of the engine
On most transverse V6s Bank 2 is the bank closest to the radiator. On Ford modular V8s Bank 2 is the passenger side. On GM truck V8s Bank 2 is the passenger side. Confirm in the service manual before pulling parts.
Tools: Vehicle-specific service information
-
Smoke-test the Bank 2 intake side
With smoke in the intake, focus on the Bank 2 intake runner gaskets, the vacuum lines that feed Bank 2 specifically, and the brake booster line if it tees into Bank 2. Cracked plastic intake manifolds on Ford 4.6 V8s, Chrysler 4.0 inline-6, and several GM engines are classic Bank-2-specific P0174 causes.
Tools: EVAP / intake smoke machine, Flashlight and mirror
-
Compare Bank 1 vs Bank 2 fuel trims
With the engine warm, read Bank 1 LTFT and Bank 2 LTFT simultaneously. A 10 %+ difference between banks isolates the problem to the bank with the higher positive number.
Tools: Scan tool with multi-PID display
-
Test Bank 2 injectors for low flow
Run the scan tool injector balance test on Bank 2 injectors only. An injector that does not produce as much pressure drop as its peers is under-delivering fuel and causing the bank-specific lean condition.
Tools: Scan tool with injector balance
NHTSA complaints & recalls for the 2012 Honda Odyssey
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2012 Honda Odyssey. Use these to gauge how common a problem is on your specific vehicle before you start chasing Honda Odyssey diagnostics.
- ENGINE 39
- POWER TRAIN 24
- SERVICE BRAKES 60
- ELECTRICAL SYSTEM 33
- STRUCTURE 25
5 active recalls
- SEATS:MID/REAR ASSEMBLY Nov 2017
Honda (American Honda Motor Co.) is recalling certain 2011-2017 Honda Odyssey vehicles. The second row outboard seats can slide sideways to one of two positions. If a seat is placed between either of the two positions when attaching the seat to the vehicle floor, the seat will…
NHTSA campaign 17V725000 - SEATS:MID/REAR ASSEMBLY Dec 2016
Honda (American Honda Motor Co.) is recalling certain model year 2011-2016 Odyssey vehicles manufactured August 17, 2010, to October 1, 2015. The affected vehicles have second row outboard seats that have a release lever that allows the seats to move for easier access to the thi…
NHTSA campaign 16V933000 - SUSPENSION:FRONT Dec 2011
HONDA IS RECALLING CERTAIN MODEL YEAR 2012, ODYSSEY VEHICLES MANUFACTURED FROM OCTOBER 31, 2011, THROUGH NOVEMBER 30, 2011. THE RETENTION NUT FOR THE FRONT RIGHT LOWER SUSPENSION DAMPER BOLT MAY NOT HAVE BEEN TIGHTENED TO THE PROPER TORQUE, POTENTIALLY ALLOWING THE NUT TO LOOSEN…
NHTSA campaign 11V602000 - POWER TRAIN:AUTOMATIC TRANSMISSION Apr 2013
Honda is recalling certain model year 2012-2013 CR-V, Odyssey, and model year 2013 Acura RDX vehicles. During sub-freezing temperatures, the brake-shift interlock blocking mechanism may become slow and allow the gear selector to be moved from the Park position without pressing t…
NHTSA campaign 13V143000
How do I fix P0174 on a 2012 Honda Odyssey?
- Repair Bank 2 vacuum / intake leaks
- Replace cracked plastic intake manifold (model-specific)
- Clean or replace Bank 2 fuel injectors
- Replace the Bank 2 upstream O2 sensor
- Repair Bank 2 exhaust leaks
About the 2010-2014 Honda Odyssey
The 2010-2014 Honda Odyssey was commonly sold with the following powertrains: 3.5L V6. Common trims include LX, EX, EX-L, Touring, Elite.
P0171 + P0174 together vs. P0174 alone
The presence pattern is your best diagnostic clue:
- Both P0171 and P0174 active → systemic problem affecting both banks. Check the MAF, fuel pressure, large vacuum leaks (brake booster, PCV hose, throttle body gasket), and the common air intake.
- Only P0174 active → Bank-2-specific problem. Inspect Bank 2 intake gaskets, Bank 2 injectors, Bank 2 O2 sensor, and Bank 2 exhaust upstream of the front sensor.
Why cracked intake manifolds are so common
Plastic intake manifolds began appearing in the mid-1990s for weight and heat-soak benefits. Two decades of thermal cycling has caused many of them to crack — particularly Ford 4.6 V8 (cracked coolant passage near the EGR tube), Chrysler 4.0 inline-6 (rear of the manifold), and GM 3.6 V6. The crack is often invisible to the eye and only shows up under smoke pressure.
Driving with P0174 long-term
Like P0171, mild long-term lean operation does not destroy the engine quickly, but sustained lean conditions raise combustion temperatures. The risks build over months: pinged spark plug electrodes, eventual catalyst damage, and burnt exhaust valves on the affected bank. Fix P0174 within a few weeks rather than letting it ride for a year.