P0174 on a 2012 Honda Civic

Fuel System Too Lean (Bank 2)

P0174 on a 2012 Honda Civic indicates fuel system too lean (bank 2). It usually stays drivable short-term but should be diagnosed promptly. The most common cause is vacuum leak specific to bank 2 (intake gasket, vacuum tee, brake-booster tee) (typically $80–$600). Confirm the root cause before replacing parts.

Severity: moderate Safe to drive (short term) Compact Sedan 2010-2014 Honda Civic

Reviewed by MECH AI Editorial · Last verified

What does P0174 mean on a 2012 Honda Civic?

P0174 is the Bank 2 counterpart of P0171. It is set when the engine control module sees long-term fuel trim on Bank 2 driven beyond approximately +25 %. The ECM is adding the maximum allowed amount of fuel and the Bank 2 oxygen sensor still reports lean. Because P0174 only applies to V-engines and engines with separate exhaust banks, whether P0174 appears alongside P0171 tells you a lot about the root cause.

This guide covers P0174 across the 2010-2014 Honda Civic generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2010 through 2014.

Is it safe to drive a 2012 Honda Civic with P0174?

In most cases a 2012 Honda Civic stays drivable for short trips with P0174 active, but diagnose and repair it promptly. This is a moderate-severity code — ignoring it can lead to further damage or a failed emissions test.

What are the symptoms of P0174 on a 2012 Honda Civic?

What causes P0174 on a 2012 Honda Civic?

Cause Likelihood Estimated repair (USD)
Vacuum leak specific to Bank 2 (intake gasket, vacuum tee, brake-booster tee) Most common $80–$600
Cracked plastic intake manifold on V-engines (common on Ford and Chrysler V6/V8s) Common $250–$900
Bank 2 fuel injectors clogged or under-delivering Common $150–$1,200
Bank 2 upstream O2 sensor lazy or biased lean Common $150–$450
Bank 2 exhaust leak upstream of the front O2 sensor Occasional $100–$500
Weak fuel pump or clogged filter (both banks lean — P0171 also present) Occasional $80–$900
PCV system fault drawing extra air into Bank 2 Occasional $30–$200

How to diagnose this on a 2012 Honda Civic

  1. Determine whether P0171 is also present

    Pull all codes. If P0174 sets alone, the cause is on Bank 2 specifically — an intake leak on that side, injectors on that side, or the Bank 2 O2 sensor. If P0171 and P0174 set together, the cause is something affecting the whole engine: low fuel pressure, MAF issue, large vacuum leak.

    Tools: Scan tool

  2. Identify the Bank 2 side of the engine

    On most transverse V6s Bank 2 is the bank closest to the radiator. On Ford modular V8s Bank 2 is the passenger side. On GM truck V8s Bank 2 is the passenger side. Confirm in the service manual before pulling parts.

    Tools: Vehicle-specific service information

  3. Smoke-test the Bank 2 intake side

    With smoke in the intake, focus on the Bank 2 intake runner gaskets, the vacuum lines that feed Bank 2 specifically, and the brake booster line if it tees into Bank 2. Cracked plastic intake manifolds on Ford 4.6 V8s, Chrysler 4.0 inline-6, and several GM engines are classic Bank-2-specific P0174 causes.

    Tools: EVAP / intake smoke machine, Flashlight and mirror

  4. Compare Bank 1 vs Bank 2 fuel trims

    With the engine warm, read Bank 1 LTFT and Bank 2 LTFT simultaneously. A 10 %+ difference between banks isolates the problem to the bank with the higher positive number.

    Tools: Scan tool with multi-PID display

  5. Test Bank 2 injectors for low flow

    Run the scan tool injector balance test on Bank 2 injectors only. An injector that does not produce as much pressure drop as its peers is under-delivering fuel and causing the bank-specific lean condition.

    Tools: Scan tool with injector balance

NHTSA complaints & recalls for the 2012 Honda Civic

Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2012 Honda Civic. Use these to gauge how common a problem is on your specific vehicle before you start chasing Honda Civic diagnostics.

452 owner complaints
55 involved a crash
5 involved a fire
41 reported injuries
  • POWER TRAIN 49
  • VEHICLE SPEED CONTROL 38
  • AIR BAGS 147
  • STEERING 74
  • ELECTRICAL SYSTEM 59

3 active recalls

  • STEERING:COLUMN Nov 2012

    Honda is recalling certain model year 2012 Civic passenger vehicles, manufactured from October 26, 2012, through October 30, 2012. These vehicles were assembled with the incorrect steering column assembly.…

    NHTSA campaign 12V548000
  • FUEL SYSTEM, OTHER:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS May 2011

    HONDA IS RECALLING CERTAIN MODEL YEAR 2012 CIVIC 2-DOOR AND 4-DOOR VEHICLES MANUFACTURED FROM APRIL 21, 2011, THROUGH MAY 2, 2011. THERE IS A POSSIBILITY THAT AN O-RING, WHICH SEALS A CONNECTION IN THE FUEL FEED LINE, IS MISALIGNED. IF THE O-RING IS MISALIGNED, A SMALL FUEL LEA…

    NHTSA campaign 11V288000
  • POWER TRAIN:DRIVELINE:DRIVESHAFT Jun 2012

    HONDA IS RECALLING CERTAIN MODEL YEAR 2012 HONDA CIVIC VEHICLES. DURING ASSEMBLY, THE PROCESS REQUIRED TO SEAT THE DRIVER’S SIDE DRIVESHAFT AND SET THE RETAINING CLIP WAS NOT COMPLETED. AS A RESULT, THE DRIVESHAFT MAY SEPARATE.…

    NHTSA campaign 12V256000

How do I fix P0174 on a 2012 Honda Civic?

About the 2010-2014 Honda Civic

The 2010-2014 Honda Civic was commonly sold with the following powertrains: 2.0L I4, 1.5L Turbo I4, 1.8L I4. Common trims include LX, Sport, EX, Touring.

P0171 + P0174 together vs. P0174 alone

The presence pattern is your best diagnostic clue:

Why cracked intake manifolds are so common

Plastic intake manifolds began appearing in the mid-1990s for weight and heat-soak benefits. Two decades of thermal cycling has caused many of them to crack — particularly Ford 4.6 V8 (cracked coolant passage near the EGR tube), Chrysler 4.0 inline-6 (rear of the manifold), and GM 3.6 V6. The crack is often invisible to the eye and only shows up under smoke pressure.

Driving with P0174 long-term

Like P0171, mild long-term lean operation does not destroy the engine quickly, but sustained lean conditions raise combustion temperatures. The risks build over months: pinged spark plug electrodes, eventual catalyst damage, and burnt exhaust valves on the affected bank. Fix P0174 within a few weeks rather than letting it ride for a year.

P0174 on a 2012 Honda Civic: frequently asked questions

What does diagnostic trouble code P0174 mean on a 2012 Honda Civic?

P0174 is the Bank 2 counterpart of P0171. It is set when the engine control module sees long-term fuel trim on Bank 2 driven beyond approximately +25 %. The ECM is adding the maximum allowed amount of fuel and the Bank 2 oxygen sensor still reports lean. Because P0174 only applies to V-engines and engines with separate exhaust banks, whether P0174 appears alongside P0171 tells you a lot about the root cause.

What are the symptoms of P0174 on a 2012 Honda Civic?

Check Engine Light is illuminated. Rough idle, especially when cold. Hesitation or stumble on light acceleration. Reduced fuel economy. Mild power loss. Possible whistling vacuum-leak sound

What causes P0174 on a 2012 Honda Civic?

Vacuum leak specific to Bank 2 (intake gasket, vacuum tee, brake-booster tee) (most-common). Cracked plastic intake manifold on V-engines (common on Ford and Chrysler V6/V8s) (common). Bank 2 fuel injectors clogged or under-delivering (common). Bank 2 upstream O2 sensor lazy or biased lean (common). Bank 2 exhaust leak upstream of the front O2 sensor (occasional). Weak fuel pump or clogged filter (both banks lean — P0171 also present) (occasional). PCV system fault drawing extra air into Bank 2 (occasional)

Is it safe to drive a 2012 Honda Civic with P0174?

In most cases a 2012 Honda Civic stays drivable for short trips with P0174 active, but it should be diagnosed and repaired promptly — this is a moderate-severity code. Ignoring it can lead to further damage or a failed emissions test.

Related diagnostic codes

P0174 on other Honda Civic model years