P0102 on a 2017 Honda Civic
MAF Sensor Low Input
P0102 on a 2017 Honda Civic indicates maf sensor low input. It usually stays drivable short-term but should be diagnosed promptly. The most common cause is disconnected maf sensor connector (typically $0–$50). Confirm the root cause before replacing parts.
What does P0102 mean on a 2017 Honda Civic?
P0102 is set when the ECM sees the mass air flow sensor signal at a voltage or frequency below the calibrated minimum for the engine's operating conditions. Where P0101 means "MAF reading is implausible", P0102 means "MAF signal is too low or missing entirely." The cause is usually a disconnected sensor, broken signal wire, or a sensor that has failed in a way that produces no output.
This guide covers P0102 across the 2015-2019 Honda Civic generation — the symptoms, causes, and diagnostic steps below apply to every model year from 2015 through 2019.
Is it safe to drive a 2017 Honda Civic with P0102?
In most cases a 2017 Honda Civic stays drivable for short trips with P0102 active, but diagnose and repair it promptly. This is a moderate-severity code — ignoring it can lead to further damage or a failed emissions test.
What are the symptoms of P0102 on a 2017 Honda Civic?
- Check Engine Light is illuminated
- Hesitation, stumble, or stall on acceleration
- Hard starting or extended crank time
- Reduced power and throttle response
- Black smoke or rich smell from exhaust (ECM defaults to a rich limp map)
- Reduced fuel economy
What causes P0102 on a 2017 Honda Civic?
| Cause | Likelihood | Estimated repair (USD) |
|---|---|---|
| Disconnected MAF sensor connector Check this first — the simplest cause is the most common after recent work. | Most common | $0–$50 |
| Broken or shorted MAF signal wire | Common | $80–$350 |
| Corroded MAF sensor connector pins | Common | $30–$200 |
| Internal MAF sensor failure (sensor produces no output) | Common | $80–$450 |
| Open in MAF sensor 5 V reference or ground supply | Occasional | $100–$400 |
| Failed PCM input circuit for the MAF (rare) | Rare | $400–$1,500 |
How to diagnose this on a 2017 Honda Civic
-
Verify the MAF connector is fully seated
A loose or unlatched MAF connector is the #1 cause of P0102 after recent under-hood work — air filter changes, intake cleaning, or a previous diagnostic. Press the connector firmly until the latch clicks. Clear the code and drive.
Tools: None
-
Read MAF signal voltage or frequency
On a standard hot-wire MAF, the signal should read about 0.6 V at key-on engine-off and climb to 1.5–2.5 V at idle. A stuck reading below 0.3 V at idle confirms a low-input fault. On digital MAFs the scan tool will report frequency in Hz instead — typical idle readings are 2.5–3.5 kHz.
Tools: Scan tool with MAF voltage / frequency PID, Multimeter (back-probe capable)
-
Test the MAF power, ground, and signal wires
Back-probe the MAF connector with a multimeter. Verify: battery voltage on the supply wire with key on, continuity from the ground wire to engine ground, and an open or short on the signal wire to the PCM. A missing supply voltage points to a blown fuse or harness fault.
Tools: Multimeter, Back-probe pins, Wiring diagram
-
Inspect the connector pins
Unplug the MAF and look closely at the pins inside the connector. Green corrosion, bent terminals, or evidence of water intrusion will cause intermittent or low signal. Clean with electrical contact cleaner and bend terminals straight if needed.
Tools: Electrical contact cleaner, Pick tool, Magnifying glass
-
Swap or test the MAF sensor
If wiring and power supply test good and the connector is clean, the MAF sensor is the prime suspect. Swap with a known-good unit if available, or install a new OEM sensor. Avoid the cheap eBay MAFs — they fail at very high rates.
Tools: Socket / driver to remove MAF
Known Technical Service Bulletins for the 2015-2019 Honda Civic
Manufacturers publish Technical Service Bulletins (TSBs) when a known issue affects a specific vehicle. These bulletins come from the NHTSA database for your Honda Civic.
- ENGINE Jul 28, 2025
Service Bulletin - Oil leak at timing chain tensioner inspection cover due to possible insufficient sealant adhesion on inspection cover.
NHTSA #11021745 - FUEL/PROPULSION SYSTEM Aug 6, 2024
Dealer Message - American Honda Motor Co., Inc. (AHM) is searching for certain 2018-2020 Accords, 2016-2020 Civics, 2017-2020 CR-Vs, & 2018-2020 Odysseys that have been diagnosed to be in need of the low-pressure fuel pump, fuel strainer, fuel meter or fuel tank replacement.
NHTSA #11006249 - FUEL/PROPULSION SYSTEM Jul 22, 2024
Dealer Message - American Honda Motor Co., Inc. (AHM) is searching for certain 2018-2020 Accords, 2016-2020 Civics, 2017-2020 CR-Vs, & 2018-2020 Odysseys that have been diagnosed to be in need of the low-pressure fuel pump, fuel strainer, fuel meter or fuel tank replacement. If you have a vehicle that match the qualifiers listed below, AHM requests to have the photos of the lock ring & the low-pressure fuel pump flange taken & sent to TIS (click HERE for example photos).
NHTSA #11005271 - FUEL/PROPULSION SYSTEM Jul 6, 2024
Dealer Message - Dealer Message - American Honda Motor Co., Inc. (AHM) is searching for certain 2018-2020 Accords, 2016-2020 Civics, 2017-2020 CR-Vs, & 2018-2020 Odysseys that have been diagnosed to be in need of the low-pressure fuel pump, fuel strainer, fuel meter or fuel tank replacement.
NHTSA #11004264 - VISIBILITY/WIPER Jun 19, 2024
Service Bulletin - Due to a new North America regulation which introduces a new refrigerant and oil requirement, the compressor shaft seal may leak. American Honda is extending the warranty on the A/C compressor shaft seal from the original 3 years to 10 years from the original date of purchase, with no mileage limitation. The new refrigerant and oil may cause swelling of the compressor shaft seal. The swelling may lead to abnormal wearing of the seal which may increase seal gaps around the compressor shaft allowing refrigerant to leak out.
NHTSA #11002711 - VISIBILITY/WIPER Jun 19, 2024
Service Bulletin - American Honda is extending the warranty on the A/C condenser to 10 years from the original date of purchase with unlimited miles. This warranty extension only covers vehicles that have a defective A/C condenser from the factory. The A/C condenser was not manufactured to specification. As a result, corrosion may develop in the form of tiny holes in the condenser tube walls that allow the refrigerant to leak out.
NHTSA #11002705
+14 more TSBs available in MECH AI's TSB explorer for this vehicle.
NHTSA complaints & recalls for the 2017 Honda Civic
Owner-reported safety complaints and official recalls filed with the U.S. National Highway Traffic Safety Administration for the 2017 Honda Civic. Use these to gauge how common a problem is on your specific vehicle before you start chasing Honda Civic diagnostics.
- ENGINE 65
- STEERING 161
- UNKNOWN OR OTHER 160
- ELECTRICAL SYSTEM 99
- SERVICE BRAKES 35
6 active recalls
- STEERING:ELECTRIC POWER ASSIST SYSTEM Sep 2018
Honda (American Honda Motor Co.) is recalling certain 2017-2018 Honda Civic and CR-V vehicles. The magnet that controls the torque sensor output signal for the electronic power steering system may not be properly secured, allowing the magnet to become dislodged. During a full…
NHTSA campaign 18V663000 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL Nov 2018
Honda (American Honda Motor Co.) is recalling certain 2017-2018 Honda Civic Hatchback and Civic Type R vehicles. The owners guide in these vehicles may not have been included or if included, the owner's guide may not have been properly provided required information. As such, t…
NHTSA campaign 18V817000 - AIR BAGS Apr 2018
Honda (American Honda Motor Co.) is recalling certain 2017 Honda Civic Hatchback and Civic Type R vehicles. Driver and front passenger seatback pads sold as replacement service parts were made without slit openings for the seat-mounted side air bags. In the event of a crash nece…
NHTSA campaign 18V266000 - POWER TRAIN:DRIVELINE:DRIVESHAFT Nov 2017
Honda (American Honda Motor Co.) is recalling certain 2017 Honda Civic Sedan and Coupe vehicles. The right halfshaft may have been improperly heat treated, reducing its strength.…
NHTSA campaign 17V706000
How do I fix P0102 on a 2017 Honda Civic?
- Reconnect the MAF sensor connector
- Replace the MAF sensor with an OEM unit
- Repair broken signal, power, or ground wires
- Clean or replace corroded connector terminals
About the 2015-2019 Honda Civic
The 2015-2019 Honda Civic was commonly sold with the following powertrains: 2.0L I4, 1.5L Turbo I4, 1.8L I4. Common trims include LX, Sport, EX, Touring.
P0102 vs P0101
These are different failure modes on the same sensor:
- P0102 — Signal is too low or missing. Usually a wiring, connector, or dead-sensor problem. Cannot be solved by cleaning.
- P0101 — Signal is present but does not match expected airflow. Usually a dirty sensor or an intake leak. Cleaning often resolves it.
What the engine does when the MAF signal is missing
Without a usable MAF reading, the ECM falls back to “speed-density” mode — it estimates airflow from RPM, throttle position, and intake-air temperature. This works but is less precise. Expect noticeably worse fuel economy and hesitation while the code is active. The car remains drivable but is operating on a calibrated backup map.
Counterfeit MAF sensors
The aftermarket MAF market is full of counterfeit Bosch, Hitachi, and Denso sensors sold at suspiciously low prices on Amazon and eBay. Counterfeits often work briefly then set P0102 again within weeks. For the small price difference, buy from a reputable parts store or a dealer. Genuine OEM MAFs typically last 100,000+ miles.
P0102 on a 2017 Honda Civic: frequently asked questions
What does diagnostic trouble code P0102 mean on a 2017 Honda Civic?
P0102 is set when the ECM sees the mass air flow sensor signal at a voltage or frequency below the calibrated minimum for the engine's operating conditions. Where P0101 means "MAF reading is implausible", P0102 means "MAF signal is too low or missing entirely." The cause is usually a disconnected sensor, broken signal wire, or a sensor that has failed in a way that produces no output.
What are the symptoms of P0102 on a 2017 Honda Civic?
Check Engine Light is illuminated. Hesitation, stumble, or stall on acceleration. Hard starting or extended crank time. Reduced power and throttle response. Black smoke or rich smell from exhaust (ECM defaults to a rich limp map). Reduced fuel economy
What causes P0102 on a 2017 Honda Civic?
Disconnected MAF sensor connector (most-common). Broken or shorted MAF signal wire (common). Corroded MAF sensor connector pins (common). Internal MAF sensor failure (sensor produces no output) (common). Open in MAF sensor 5 V reference or ground supply (occasional). Failed PCM input circuit for the MAF (rare) (rare)
Is it safe to drive a 2017 Honda Civic with P0102?
In most cases a 2017 Honda Civic stays drivable for short trips with P0102 active, but it should be diagnosed and repaired promptly — this is a moderate-severity code. Ignoring it can lead to further damage or a failed emissions test.